Yamaha NS-1000MM Manual de usuario

CAUTIONS

Read this before using the speakers.

●To assure the finest performance, please read this

manual carefully. Keep it in a safe place for future

reference.

●Install the speakers in a cool, dry, clean place –

away from windows, heat sources, sources of

excessive vibration, dust, moisture and cold. Avoid

sources of humming (transformers, motors). To

prevent fire or electric shock, do not expose the

speakers to rain or water.

●To prevent the enclosure from warping or

discoloring, do not place the speakers where they

will be exposed to direct sunlight or excessive

humidity.

●Do not place the following objects on top of the

speakers:

•Other components, as they might cause damage

and/or discoloration on the surface of the

speakers.

•Burning objects (i.e. candles), as they might cause

fire, damage to the speakers and/or personal

injury.

•Containers with liquid in them. If the liquid spills, it

might cause electric shock to the user and/or

damage to the speakers.

●Do not place the speakers where they are liable to

be knocked over or struck by falling objects. Stable

placement will also ensure better sound

performance.

●Placing the speakers on the same shelf or rack as

the turntable can result in feedback.

●Secure placement or installation is the owner’s

responsibility.

YAMAHA shall not be liable for any accident caused

by improper placement or installation of speakers.

●Any time you note distortion, reduce the volume

control on your amplifier to a lower setting. Never

allow your amplifier to be driven into “clipping”.

Otherwise the speakers may be damaged.

NS-1000MM

Natural Sound 3-way acoustic-suspension speaker system

Thank you for selecting the Yamaha NS-1000MM speaker system.

●When using an amplifier with a rated output power

higher than the nominal input power of the speakers,

care should be taken never to exceed the speakers’

maximum input.

●Do not attempt to clean the speakers with chemical

solvents as this might damage the finish. Use a

clean, dry cloth.

●Do not attempt to modify or fix the speakers.

Contact qualifiedYAMAHA service personnel when

any service is needed. The cabinet should never be

opened for any reasons.

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four

points and can be removed if desired. To remove the

cover, hold on to both sides and slowly pull straight

away from the speaker. To reattach, line up the four

holes on the inner surface of the cover with the four

corresponding pegs on the speaker and push gently.

Note

When the cover is removed, be sure not to touch

the speaker units with your hands or to exert

excessive force with tools.

SETTING UP THE SPEAKERS

■To mount the speakers on a wall by using

the provided mounting brackets

1Attach the bracket to the rear of the speaker by

using the provided screws.

2Remove the provided pads from the backing sheet

and put them at the lower corners of the speakers.

WARNING

●Each speaker weighs 3.0 kg (6 lbs. 10 oz.). Do not

mount them on thin plywood or a wall with soft

surface material. If mounted, the screws may

come out of the flimsy surface and the speakers

may fall.This damages the speakers or causes

personal injury.

●Do not install the speakers to a wall with nails,

adhesives, or any other unstable hardware. Long-

term use and vibrations may cause them to fall.

●To avoid accidents resulting from tripping over

loose speaker cords, fix them to the wall.

3Fasten screws into a firm wall or wall support as

shown in the figure, and hang the holes of the

mounting bracket on the protruding screws.

* Make sure that the screws are securely caught by

the narrow parts of the holes.

Wall/ wall

support

Tapping screw

(Available at the hardware store)

40 mm

Min.

20 mm

2 mm

Diam. 3.5 to 3.8 mm

You can also use the screw holes on the rear and

the bottom of the speaker for mounting the

speakers on the wall or the ceiling (if you will not

use the provided mounting brackets).

60 mm

64 mm

60 mm

Rear Bottom

A screw with a diameter of 4 mm

and a pitch of 0.7 mm can be

used. (Depth of hole : 10mm)

How to Connect:

1Loosen the terminal knob.

2Insert the bare wire end properly into the terminal

hole.

[Remove the insulation from both ends of the

speaker cable.]

3Tighten the knob and secure the cable.

Test the firmness of the connection by pulling

lightly on the cable at the terminal.

10 mm

Speaker (R) Speaker (L)

Note

Do not let the bare speaker wires touch each other

as this could damage the speaker or the amplifier,

or both of them.

Black (–)

Red (+)

Speaker output

terminals of the

amplifier

Amplifier

CONNECTION TO YOUR AMPLIFIER

BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF.

Loosen

■Connections

•Connect the screw-type input terminals at the rear of

the speakers to the speaker output terminals of your

amplifier with the provided speaker cables.

•Connect the (+) terminals on both the amplifier and

the speakers using one side of the speaker cable.

Connect the (–) terminals on both components using

the other side of the cable.

•Connect one speaker to the left (marked L) terminals

of your amplifier, and another speaker to the right

(marked R) terminals, making sure not to reverse the

polarity (+, –). If one speaker is connected with

reversed polarity, the sound will be unnatural and

lack bass.

Tighten

SPECIFICATIONS

Type ......... 3-way acoustic-suspension speaker system

Magnetically shielded type

Driver................................. 12 cm (4-3/4”) cone woofer

2.5 cm (1”) dome mid-range

1.5 cm (9/16”) dome tweeter

Nominal Impedance .........................................6 ohms

Frequency Response..........................70 Hz – 24 kHz

Nominal Input Power............................................ 60W

Maximum Input Power ....................................... 150W

Sensitivity .......................................... 86 dB/2.83V, 1m

Dimensions (W x H x D)..............150 x 275 x 180 mm

(5-7/8” x 10-13/16” x 7-1/16”)

Weight .................................... 3.0 kg (6 lbs.10 oz.) x 2

Accessories ......................... Speaker cable (10 m) x 2

Mounting bracket x 2

Screw x 4

Pad x 4

* Please note that all specifications are subject to

change without notice.

* Care should be taken not to exceed the input power

values noted above.

Printed in Malaysia V706740

■Placing the speakers

• Place the speakers on a sturdy, vibration-free

surface or speaker stands.

• Better stereo images will be obtained when the

speakers are slightly angled in towards the listeners.

Note

These speakers feature a magnetically shielded

design, but there is still a chance that placing

them too close to a TV set might impair picture

color. Should this happen, move the speakers

away from the TV set.

Tabla de contenidos

Otros manuales de Sistema de altavoces de Yamaha

Yamaha

Yamaha NS-W2 Manual de usuario

Yamaha

Yamaha SW115V Manual de usuario

Yamaha

Yamaha ATS-1080 Manual de usuario

Yamaha

Yamaha NS-AW350 Manual de usuario

Yamaha

Yamaha VXL1B-24 Manual de usuario

Yamaha

Yamaha KMS-710 Manual de usuario

Yamaha

Yamaha NS-4HX Manual de usuario

Yamaha

Yamaha NS-10MMF Manual de usuario

Yamaha

Yamaha IF2108 Instrucciones de montaje

Yamaha

Yamaha NS-LC8 Manual de usuario

Yamaha

Yamaha YST-NC1 Manual de usuario

Yamaha

Yamaha YAS-706 Series Manual de usuario

Yamaha

Yamaha NS-PA160 Manual de usuario

Yamaha

Yamaha NX-B02 - Portable Speakers - 10 Watt Manual de usuario

Yamaha

Yamaha YSP 1100 - Digital Sound Projector Five CH... Manual de usuario

Yamaha

Yamaha YSP-5100 Manual de instalación

Yamaha

Yamaha NS-AC143 Manual de usuario

Yamaha

Yamaha NS-100S Manual de usuario

Yamaha

Yamaha NS-E80 Manual de usuario

Yamaha

Yamaha NS-P41 Manual de usuario

Yamaha

Yamaha ATS-1070 Manual de usuario

Yamaha

Yamaha YAS-108 Manual de usuario

Yamaha

Yamaha S112IV Manual de usuario

Yamaha

Yamaha YSP-4300 Manual de usuario

Manuales populares de Sistema de altavoces de otras marcas

JVC

JVC CA-MXK5R Manual de usuario

LG NB4532B Manual de usuario

JVC

JVC CA-FSH100 Manual de usuario

5Core

5Core Pro Series Manual de usuario

EAW

EAW MQV1394e Manual de usuario

Lynx

Lynx GXR-LA10A Manual de usuario

iLive

iLive ITB066B Manual de usuario

RDX

RDX QuickStation 4 Manual de usuario

Electro-Voice

Electro-Voice S-122 Manual de usuario

Sven

Sven SPS-619 GOLD Manual de usuario

Pioneer

Pioneer CS-7070 Manual de usuario

EAW

EAW UB82e Manual de usuario

Sondpex

Sondpex Active Speaker System and Digital Music... Manual de usuario

JVC

JVC NX-PN7 Manual de usuario

Marshall Amplification

Marshall Amplification AR-DM61-BT Manual de usuario

SE Audiotechnik

SE Audiotechnik I-LINE Manual de usuario

Gemini

Gemini WRX-843 Series Manual de usuario

TCL

TCL 6100 Series Manual de usuario