9
08/2013
5
Before putting into operation
Assembly
mImportant: To avoid malfunctions, please note that all the drawers
must be COMPLETELY closed before you pull one out!
•One handle (6) is included, and it can be mounted on the left or right.
(Figure 2).
•For details of how to mount the wheels (3), please refer to Figure 3
and turn the tool trolley on its top.
•For good maneuverability, fit the two swiveling and lockable casters
(3b) to the same side on which the handle is mounted.
•Fasten each of the casters to the tool trolley using 4 screws, 4 spring
washers and 4 standard washers.
If problems arise with the drawers, please refer to the following
instructions:
What to do if,
a drawer cannot be closed properly:
•Lock and unlock the lock until you hear a loud “click”.
•Open a second drawer and then close both drawers simultaneously or
•Activate the emergency release (4). This is done by moving the
emergency release on the underside of the professional tool trolley.
This will release the lock on the professional tool trolley (see Figs. 4 -
6).
none of the drawers can be opened, although the lock is not locked:
•Lock and unlock the lock until you hear a loud “click”.
•Activate the emergency release (4) (see Figs. 4 - 6).
WW_154_AUS_SPK7.indb 9 18.02.13 09:19
