Worcester R29 Manual de usuario
Users Instructions and
Customer Care Guide
R 29 / R 40 HE conventional Condensing
boiler
6720 610 577-01.10
ZB 7-28 R 29 HE GC-Number: 41 311 60
ZB 11-40 R 40 HE GC-Number: 41 311 61
6 720 611 138 GB (03.11) TD
2
Contents
6 720 611 138 GB (03.11)
Contents
Excellence comes as standard 3
Safety precautions 4
1General notes 6
2Controls 8
3Operating the Appliance 9
3.1 Preparation 9
3.2 Switching the Appliance On/Off 10
3.3 Switching on the System 11
3.4Controlling 11
3.5 Setting the Hot Water Temperature of a Cylinder 11
3.6 Frost protection 12
3.7 Fault Condition 12
4Tipsonsaving energy 13
5General Information 14
6Maintaining your appliance 15
7Servicecentres 15
8Faultorbreakdown 16
9YourBoschguarantee 17
10 Guarantee registration 18
11 Operating Instructions Quick Reference 19
3
Excellence comes as standard
6 720 611 138 GB (03.11)
Excellence comes as standard
Thank you for purchasing a Worcester Greenstar condensing
appliance.
The Worcester Greenstar Series has been developed by the
Bosch Group and the strictest quality control standards are
demanded throughout every stage of production.
Indeed, the Bosch Group have led the field in innovative appliance
design and performance for many years.
The result is that your new Greenstar appliance offers you the very
best of everything – quality, efficiency, economical running costs,
proven reliability and value for money.
What’s more, you also have the assurance of our no nonsense
2yearparts and labour guarantee.
And it’s backed up by Worcester Care Call a complete mainte-
nance scheme to keep your boiler operating at peak condition and
efficiency.
No wonder that more and more people are agreeing that when it
comes to gas, it has to be a Worcester Bosch appliance.
Benchmark
The “Benchmark” initiative is the new code of practice to encour-
age the correct installation, commissioning and servicing of
domestic central heating boilers and system equipment.
The “log-book” is a vital document that must be completed by the
installer at the time of installation. It confirms that the boiler has
been installed and commissioned according to the manufacturers
instructions and is one of the methods of demonstrating
compliance with the Building Regulations.
Without the completion of the “log-book”, manufacturers may
refuse to respond to a call–out from a householder, who will be
advised that he or she must call back the installer, who has not ful-
filled his obligations to record the information required by the ini-
tiative.
4
Safety precautions
6 720 611 138 GB (03.11)
Safety precautions
Gas Safety (Installation and Use) Regulations
It is the law that all gas appliances are installed by a competent
person in accordance with the above regulations. Failure to install
appliances correctly could lead to prosecution. It is in your inter-
est, and that of safety, to ensure compliance with the law.
If you smell gas:
BTurn off gas service cock at the meter.
BOpen all doors and windows.
BDo not operate any electrical switches.
BDo not smoke.
BExtinguish any naked flames.
BCall your gas company.
If you smell fumes from the appliance:
BSwitch off appliance.
BOpen windows and doors.
BInform your heating engineer.
Fitting and modifications
BFitting of the appliance or any modifications to the appliance
may only be carried out by a competent person.
BFlue systems must not be modified in any way.
Maintenance
BWe recommend that you take out a maintenance contract
with a competent installer and have the appliance serviced at
regular intervals.
BEnsure that your Service Engineer uses only genuine spare
parts!
Combustible materials
BDo not store or use any combustible materials (paper, thin-
ners, paints etc.) in the vicinity of the appliance.
5
Safety precautions
6 720 611 138 GB (03.11)
Health and safety
BThis appliance contains no asbestos products.
BThere is no potential hazard due to the appliance being electri-
cally unsafe.
BThere are no substances used in the construction that are a
potential hazard in relation to the COSHH Regulations (Con-
trol of Substances Hazardous to Health Regulations).
Combustion Air/Ambient Air
BKeep combustion air/ambient air free of corrosive substances
(e.g. halogenated hydrocarbons which contain chlorine or flu-
orine compounds). In this way corrosion can be prevented.
6
General notes
6 720 611 138 GB (03.11)
1General notes
To get the best from your appliance please read these instructions
carefully.
Central heating systems
During the first few hours of operation of the central heating sys-
tem, check that all radiators are being heated at an even rate. If the
top of a radiator is at a lower temperature than the bottom then it
should be vented by releasing air through the venting screw at the
top of the radiator. Ask your installer to show you how this is done.
Repeated venting will reduce the quantity of water in the system
and this must be replenished for safe and satisfactory operation of
the appliance. An open vented system will re-fill automatically.
Should water leaks be found in the system or excessive venting is
required then a service engineer must be contacted to inspect the
installation and rectify any fault.
Only additives that are compatible with aluminium may be used in
the system. Any incompatible additive used will invalidate the
guarantee. Contact Fernox or Sentinel for further details.
Condensate drain
This is a condensing appliance and the terminal will, at times, give
out a plume of water vapour. This is quite normal.
The appliance produces quantities of condense which is dis-
charged regularly through the siphon.
Ventilation
This is a room sealed appliance and does not require any air for
combustion from inside the house. If the appliance is fitted into a
cupboard or a compartment is built around the appliance after
installation then the compartment must be separated from the
boiler space by a perforated non-combustible partition as
described in BS6798.
Notwithstanding the requirements of BS6798, there is no need
for ventilation openings to be provided in the compartment
because of the low heat loss from the casing.
Do not allow the flue terminal fitted on the outside wall to become
obstructed or damaged.
7
General notes
6 720 611 138 GB (03.11)
Clearances
Your installer will have provided adequate space around the appli-
ance for safety and servicing access. Do not restrict this space
with the addition of cupboards, shelves etc. next to the appliance.
Room thermostat
A room thermostat should be fitted to control the central heating.
Refer to the instructions supplied with the thermostat for informa-
tion on siting and setting.
Thermostatic radiator valves
It is recommended that this type of valve is fitted to all the radia-
tors. It is a requirement that they are fitted, at least, in the sleeping
areas.They should conform to the requirements of BS2767:10.
Time Control
Separate time control of the space heating and the hot water sys-
tem is required using a twin-channel programmer or two or more
separate timers.
Cylinder Thermostat
A cylinder thermostat must be fitted to the cylinder which, when
used with a motorised valve, will give close control of the water
temperature.
Left-hand side 10 mm
Right-hand side 10 mm
In Front 600 mm
Above Casing (Vertical Flue) 200 mm
Above Flue Turret 30 mm
Below 200 mm
Table 1
8
Controls
6 720 611 138 GB (03.11)
2Controls
61 Reset button
135 Master switch
136 Boiler temperature control
170 Service valves in boiler flow and return
172 Gas isolation valve (open)
295 Identification sticker
310 Function control (Service only)
317 Display
363 Indicator lamp for “burner on”
364 Indicator lamp for “off/on”
365 “Chimney sweep” button
366 Service button
367 No function
365 61 317 366 367
ECO
310
364
135
295
136
170
363
172 170
6 720 611 138-01.1O
E
9
Operating the Appliance
6 720 611 138 GB (03.11)
3Operating the Appliance
3.1 Preparation
Turn on the gas cock (172).
BPress in the handle and turn it anti-clockwise as far as the stop
(when handle is in line with direction of flow, the cock is open).
Central heating system valves (170)
BUsing a spanner, turn square nut until groove is in line with
direction of flow (see detail).
Groove at right angles to direction of flow = off.
170
172
6 720 611 138-02.1O
10
Operating the Appliance
6 720 611 138 GB (03.11)
3.2 Switching the Appliance On/Off
Switching on
BSwitch on the appliance at the master switch (I).
The indicator lamp shows green and the display will show the
primary flow temperature.
The trap filling programme ensures that the condensation trap is
filled after the appliance has been installed or after the appliance
has been out of use for a long period. For that reason, the appli-
ance remains at minimum heating output for 15 minutes.
Switching off
BSwitch off the appliance at the master switch (0).
The green indicator lamp goes out.
i
If the display alternates between -II- and the boiler
flow temperature, the trap filling programme is
active.
6 720 610 333-04.1O
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Caldera de Worcester
Worcester
Worcester Greenstar 12i System ErP Manual de usuario
Worcester
Worcester GREENSTARHIGHFLOW 440 CDi Manual de usuario
Worcester
Worcester GREENSTAR CDi CLASSIC REGULAR Manual de usuario
Worcester
Worcester GREENSTAR 24i junior Manual de usuario
Worcester
Worcester Greenstar CDi Compact Guía del usuario
Worcester
Worcester 280 RSF Instrucciones de operación
Worcester
Worcester WM 12 Guía del usuario
Worcester
Worcester 9/14CBi Manual de usuario
Worcester
Worcester 24CDi Guía del usuario
Worcester
Worcester GB162-50 Manual de usuario
Worcester
Worcester Greenstar Highflow 440 Manual de usuario
Worcester
Worcester 14/19CBi Guía del usuario
Worcester
Worcester GREENSTAR 25Si Manual de usuario
Worcester
Worcester Greenstar Danesmoor 25kW Manual de usuario
Worcester
Worcester Greenstar Heatslave II 12/18 Guía del usuario
Worcester
Worcester GB162 Manual de usuario
Worcester
Worcester 230 Combi RSF Guía del usuario
Worcester
Worcester DANESMOOR Guía del usuario
Worcester
Worcester 26CDi Xtra Guía del usuario
Worcester
Worcester GREENSTAR 35CDi Classic System ErP 41-406-39 Guía del usuario
