Wireless Holdings DV4home Manual de usuario
1
DV4home
DV4home (full version) – IP (Internet) transceiver
For D-Star/DMR/* 4FM/*P25/*DPMR/*NXDN
Also supports a DV4mini (not included) Hotspot
User Guide
Version 1.00 preliminary (software version 0.063C)
DV Development Group
Portion of this ocument was extracte from the DV4mini manual written by: German Version:
DH5RAE (English translation: N1DL, Up ate: DG1SW an AG0X)
Special thanks to Pascal Villeneuve VA2PV for his har work an contribution to this operating
manual.
*Will be supporte in a future software upgra e
2
Table of Content:
What’s included in the box 4
Introduction 4
Description 4
Front panel overview 6
Rear panel overview 7
Digital modes 8
D-Star 8
DMR 8
C4FM-Fusion 9
P25 9
DPMR 10
S stem requirements 10
Initial setup 11
Operating the DV4home 12
Remote webserver 12
Connecting to a reflector 13
Method #1: Usin any web browser 13
Method #2: Direct on the DV4home 14
Transmitting with the DV4home 19
Full duplex operation 20
Operating the optional DV4mini 21
Reflectors 22
DCS (Di ital Call Server) 23
FCS 23
PCS 23
3
Xreflectors 23
D-Plus reflectors 23
DMR reflectors 23
Net organization (CCS7) 24
Operating modes 24
Technical Data 25
Software update 26
Cop right 28
Important Links 28
Operating conditions 28
4
What’s inclu e in the box
1 x DV4home
1 x AC (120V) / DC (12V) power adapter (1.0A)
1 x handheld microphone with li hted DTMF key pad
Intro uction
The DV4home is another member of the successful family of DV4 products. It supports all di ital
modes, while simplifyin and extendin the supported functions. While it acts as a "home" for the
DV4mini it can also be easily used mobile or portable. It is a stand-alone unit which does not need a
PC to operate. (DV4mini not included)
You can describe the DV4home as an IP (Internet) transceiver.
There are 2 versions available, the DV4home and the DV4home compact.
Description
The DV4home uses the same microcontroller platforms as the DV4home compact, but adds 2
AMBE3000 chips, a microphone and a speaker to the unit. There is a built-in speaker and the
microphone is included.
These components allow the followin additional functions:
Direct Internet transceiver mode without a DV4mini by usin the microphone and the external
speaker. This is an economical alternative if no local wireless si nal is needed. In this mode the
DV4home supports D-Star, DMR, dPMR, NXDN (and later *C4FM via software update)
Dual mode support: even without a DV4mini inserted, the unit can be simultaneously connect to a D-
Star and a DMR reflector, usin 2 separate speakers to play the respective audio streams.
Transceiver mode connects a D-Star or DMR radio via a plu ed in DV4mini to a reflector.
5
Conference mode requires a DV4mini inserted into the unit and allows the use of the built-in
microphone/speaker connectors and the RF connection throu h the DV4mini to a DMR or D-Star
radio. This mode works in D-Star and DMR.
Transcode (later via software update) mode allows to use a di ital radio in one mode while
connectin to a reflector in another mode. Use your D-Star radio to try out DMR! The followin
conversions are supported:
D-Star → DMR
DMR→ D-Star
All → Fusion (C4FM)
Fusion (C4FM) → All
DMR/D-Star Brid e mode allows interconnectin DMR and D-Star reflector rooms usin the licensed
DVSI AMBE chips. This mode bears the risk of creatin loops in the network, therefore a free license
key is required which also helps that the installations can be supported by the network
administrators to assure a flawless inte ration.
IPSC2 and DMRplus brid e permit the connection between DMRPlus.
6
Front panel
1. Power led indicator
2. Volume and multifunction knob
a. Turn clock wise to increase volume, turn counter clock wise to
decrease volume
b. Push briefly the knob to switch between menus
c. Press and hold 2 seconds to enter a command or wait for ok to
appears in the bottom left corner of the screen
In this manual we will refer to a brief push and a press and hold as we
describe operations
3. OLED display
4. Green LED on when receivin si nal (does not show the status of the optional
DV4mini)
5. Microphone connector - 8 pins female RJ-45, the MIC connector does not us
any conventional pinout because of its internal confi uration. The pinout
connections will be published in the next manual version.
6. Red LED on when transmittin (PTT), (does not show the status of the optional
DV4mini)
7
Rear panel
7. DV4mini slot (DV4mini optional)
8. LS for Loud Speaker, providin variable volume for an external speaker
9. LineOUT, line level audio output 1/8 inch diameter (3.5mm) female jack
10. LineIN, Line level input (available in future software update) 1/8 inch
diameter (3.5mm) female jack
11. Ethernet 8 pins RJ-45 connector for Internet connection, 10/100 Mbps
12. USB port (type A) for Wi-Fi don le or LTE stick (available in future software
update)
13. Power connector, 9-15V, 1A, barrel connector 5.5/2.5mm
8
Digital Mo es
The DV4home can handle five di ital modes:
D-Star
D-Star was developed in Japan 1999/2000 especially for ham radio and it became the
leadin system worldwide due to its clear and relative simple user interface. Voice is
bein transformed by the AMBE Vocoder into a compressed di ital data stream of
3600 bits/s.
In addition, there is a data channel with 1200 bits/s for a total data rate of 4800
bits/s. This data si nal modulates a carrier, so that a lo ical 0 is one frequency and a
lo ical 1 a second frequency. This is called 2FSK (two frequency shift keyin ) or GMSK
(which are the same, however the si nal is modulated usin a bell curve). This si nal
can be used to modulate most FM transceivers (via the packet radio socket).
This is the reason why there are many homemade D-Star solutions.
Three reflector systems are used for communication. DCS (most common), D-Plus,
REF reflectors (mostly in En lish speakin countries), and the x-Reflector system
which plays a minor role. The DV4home enables communication on all these systems.
DMR
DMR was ori inally desi ned by ETSI for commercial applications. This is evident in
the user interface where numbers are used in lieu of call si ns. DMR modulates with
4FSK, indicatin that it uses 4 frequencies (compared to D-Star with 2 frequencies).
This allows doublin the data rate to 9600 bit/s. The hi her rate allows the
transmission of 2 channels at the same time (2 time slots). The DV4mini always works
in simplex mode in DMR.
If you use time slot one (TS1) you have to set your radio to color code 1 (CC1) and the
talk roup you want to use, i.e TG311 or TG262 etc. Be aware that you have to enter
the talk roup number into the receive roup list of your radio too, or your squelch
will not open. This is a common error made by first time users and it is very
frustratin .
When you use TS2, you always transmit and receive on TG9 (local) Then this routed
by the DV4mini and the DMR Plus system into the selected rooms.
9
So on TS2 you use CC1, TG9. A ain, you need to pro ram your radio accordin ly, and
a ain do not for et to put TG9 into your receive roup list!
There are multiple DMR networks available:
The DMR Plus network is developed and operated by the DV4 team, the
Brandmeister network by a team of Russian developers and the DMR-MARC network
by the Motorola Amateur Radio Club.
The DMR Plus network reflectors and the Brandmeister reflectors can be selected in
the expert settin s.
DMR reflectors have numbers in the ran e of 4000 to 5000. Each re ion has its own
reflector, which can be selected in the DV4mini menu.
The DMR-MARC network can be selected by usin the IPSC2 version of the control
center. Select the appropriate IPSC2 server as your DMR server and you can connect
to the Motorola TG on TS1 and to the DMR Plus TG on timeslot 2.
C4FM-Fusion
C4FM-FUsion is a system developed by YAESU. It is based like DMR on 4FSK, and also
transmits 4 frequencies with a total data rate of 9600 bits/s. It uses the same AMBE+
Codec as DMR, but needs only 3600 bits/s. The extra bits are used in C4FM-Fusion in
a different way. They can be used for data transfer (e. . GPS) but also for additional
error correction to make the speech more stable durin interference. There is also a
mode for hi h speech quality which uses all bits for speech only.
C4FM -Fusion reflectors are named FCS001 (Europe), FCS002 (USA), FCS003 (Canada),
etc. All DV4minis / DV4homes connected to a reflector can hear each other. It is very
easy to connect a C4FM/Fusion repeater to the FCS reflector system.
P25
P25 is a di ital system that is mostly used by public and private emer ency services
worldwide.
Currently the DV4minis have 2 reflector systems available:
● PCS001 for Europe, located in Switzerland
● PCS002 for the Americas, located in Florida
10
PMR:
dPMR is a DMR system from China which uses several Chinese Codecs instead of the
DVSI AMBE codecs commonly used by other di ital systems. These radios are cheaper
as they do not need to pay license fees for the Codecs. Practically you have to use
radios from the same manufacturer on both ends of the communication, as they are
not much standardized. This is why we call the mode experimental.
System requirements
The followin components are necessary:
1. Internet access.
2. A PC with Windows 7, 8.1, 10, for firmware up rade.
3. Web browser (any platform) for remote control.
Tabla de contenidos
