Windster WS-3230SS Manual de usuario
www.windsterhood.com
User s Manual
WS-3230SS
WS-3236SS
WS-3242SS
WS-3248SS
Please read this operation manual thoroughly before
using your range hood. Store it in a safe location for
when you need to reference it in the future.
NOTE: PLEASE INSPECT HOOD
IMMEDIATELY UPON RECEIVING.
CLAIM OF DAMAGE AFTER 7 DAYS
OF DELIVERY WILL BE DENIED.
This unit is designed for indoor
residential use only. DO NOT USE
OVER A WOOD GRILL OR MOUNT
IN OUTDOOR ENVIRONMENT.
UNDER CABINET SERIES
WALL MOUNT SERIES
1 TABLE OF CONTENTS
Table of Contents
Safety Information ............................................................... 2 - 3
Content Checklist ..................................................................... 4
Measurements ........................................................................... 5
Preparation ........................................................................... 6 - 7
Installation ................................................................................. 8
Operation & Features .......................................................... 8 - 9
Cleaning & Maintenance ........................................................ 10
Troubleshooting ...................................................................... 11
Parts List / Replacement ........................................................ 12
Warranty / Contact Us ....................................................... 13-14
2SAFETY INFORMATION
SAFETY INFORMATION
"CAUTION-To reduce risk of fire, properly exhaust air according to local city building
code(s).
"WARNING-To reduce the risk of fire or electric shock, do not use this fan with any
solid- state speed control device.(Variable Speed Controller)
"WARNING-TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards, including fire-rated
construction.
b) Sufficient air is needed for proper combustion and exhausting of gases through
the flue (chimney) of fuel burning equipment to prevent back drafting, Follow
the heating equipment manufacturer's guideline and safety standards such as
those published by the National Fire Protection Association (NFPA), and the
American Society for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
c) When cutting or drilling into wall or ceiling, do not damage electrical wiring and
other hidden utilities.
d) Ducted fans must always be vented to the outdoors.
e) If this unit is to be installed over a tub or shower, it must be marked as
appropriate for the application and be connected to a GFCI(Ground Fault
Circuit Interrupter)-protected branch circuit.
f) Never place a switch where it can be reached from a tub or shower.
WARNING-TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
"WARNING-TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A
a
RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING :
A. SMOTHER FLAMES with a close- fitting lid, cookie sheet, or metal tray,
then turn off the burner.
BE CAREFUL TO PREVENT BURNS. If the flames do not go out
immediately
EVACUATE AND CALL THE FIRE DEPARTMENT.
B. NEVER PICK UP A FLAMING PAN - You may be burned.
C. DO NOT USE WATER including wet dishcloths or towels - a violent
steam explosion may result.
3SAFETY INFORMATION
D. Use an extinguisher ONLY if:
1. You know you have a Class ABC extinguisher, and you already know
how to operate it.
2. The fire is small and contained in the area where it started.
3. The fire department is being called.
4. You can fight the fire with your back to an exit.
aBased on "Kitchen Firesafety Tips" published by NFPA.
WARNING-TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer, if you have
questions, contact the manufacturer.
b) Before servicing or cleaning unit, switch power off at service panel and lock
service disconnecting means to prevent power from being switched on
accidentally. When the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the service panel.
CAUTION-For General Ventilating Use Only. Do Not Use To Exhaust Hazardous
Or Explosive Materials And Vapors.
WARNING-TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high settings. Boil overs caused by
smoking
and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
b) Always turn hood ON when cooking at high heat or when flambéing food
(i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé).
c) Clean ventilating fans frequently. Grease should not be allowed to accumulate on
fan or filter.
d) Use proper pan size. Always use cookware appropriate for the size of the surface
element.
4CONTENT CHECKLIST
CONTENT CHECKLIST
1. CONTENTS INCLUDED
a. (1) WS32 series(30" , 36" , 42" or 48")hood assembly
b. (1) User’s manual
c. (1) 7" conversion collar
d. (2) Aluminum filters with frame & (2) stainless steel filler (30")
e. (2) Aluminum filters with frame & (2) stainless steel filler (36")
f. (3) Aluminum filters with frame & (2) stainless steel filler (42")
g. (3) Aluminum filters with frame & (2) stainless steel filler (48")
h. (2) Stainless steel oil trays (30" and 36")
I. (3) Stainless steel oil trays (42" and 48")
j. (1) Screw packet
2. TOOLS REQUIRED (NOT INCLUDED)
a. Safety gloves
b. Safety glasses
c. Electric drill w/ starter bit
d. Utility knife
e. Philips screwdriver
f. Spirit level
g. Measuring tape
h. Writing instrument (pen, marker, pencil)
I. Aluminum tape
5MEASUREMENTS
24"
30" (29-3/4")
36" (35-3/4")
42" (41-3/4")
48" (47-3/4")
7-7/8"
8-3/8"
30" (14-7/8")
36" (17-7/8")
42" (20-7/8")
48" (23-7/8")
12"
2-1/2"
4-1/8"
Fig.1a
36"
Bottom of
hood to top
of cooktop
27" - 33" Standard
8" ceiling
Fig.1b
(side to duct center)
(back to
duct edge)
(back to
duct center)
15/16"
9/16"
2-1/4"
8-1/4"
10-7/8"
power cable
1" x 2-1/2"(36"-48")
3"
1" x 1-1/2"(30")
6PREPARATION
PREPARATION
1. BEFORE YOU START
**DO NOT INSTALL IF DAMAGED**
**RETURN OR EXCHANGE WILL BE DENIED IF INSTALLED**
a. Be sure you have all the content of your purchase and required tools for this
installation.
b. Installation may take at least 1 to 2 hours from start to finish.
c. Plan to use as few elbows or turns as possible for more efficient air flow.
d. Collar size may need to be increased if utilizing a long duct run.
e. At least 12" of vertical duct is required before any turn.
f. Do not try to install this unit by yourself, SERIOUS INJURY MAY OCCUR.
g. At least two people are needed for installation.
h. Hiring a certified installer and electrician is recommended.
I. Cold weather installation will require make-up air or a CFM reducer.
Check with your local building codes for more detail.
2. LOCATION
a. Determine the exact location you want to install the range hood.
b. Distance between cooktop and range hood should be between 27"-33".
c. Range hood should be mounted at stated measurements to ensure
performance and lifespan of electrical components.
d. Correctly measure the dimension needed to install the unit.
Use Fig. 1a on page 5 for unit measurements
Use Fig. 1b on page 5 for general measurements
7PREPARATION
e. For cabinet with recessed-bottom, use (2) 3" x 12" or 15" wood strips on
both sides to balance the recession. Use (4) 1-1/4" long flat head screws
to secure the wood strips to cabinet. (Fig. 1d)
3. HOOD
a. Inspect for any sign of defect or damage. (ie. scratches, dents, loose
seams, etc.)
b. Power up the unit to make sure it is working properly.
c. Remove the aluminum filter and unscrew the fillers.
d. Remove the protective film on the filters and fillers.
e. Install handles to filters using a Philips screwdriver.
Fig. 1d - Cabinet w/ recessed-bottom
Fig. 1c - Cabinet
½"
FRONT OF CABINET
BACK OF CABINET
CABINET BOTTOM VIEW
CABINET SIDE
CABINET SIDE
ELECTRICAL OUTLET
7.5-8"
ROUND
EXHAUST
11 (30" CABINET)
14 (36" CABINET)
17 (42" CABINET)
20 (48" CABINET)
½"
FRONT OF CABINET
BACK OF CABINET
CABINET BOTTOM VIEW
WOOD STRIP
CABINET SIDE
ELECTRICAL OUTLET
7.5-8"
ROUND
EXHAUST
11 (30" CABINET)
14 (36" CABINET)
17 (42" CABINET)
20 (48" CABINET)
3"
CABINET SIDE
WOOD STRIP
8INSTALLATION
INSTALLATION
UNDER CABINET INSTALLATION (Top round outlet)
a. Make sure all preparation steps are completed.
b. Feed the wires coming out of the hood through the bottom of the cabinet.
c. Lift the unit up flesh against the wall and the bottom of the cabinet.
d. Using the screws and washers provided, insert into each of the keyhole
openings and tightly secure the unit against the bottom of the cabinet.
NOTE: Install more screws through the back of the unit if necessary.
e. Connect 7" ducting to the collar of the hood.
f. Finish off by sealing the connection point with aluminum tape.
OPERATION & FEATURES
1. CONTROL SWITCH LAYOUT (from left to right)
a. Power ON / OFF
b. Low speed
c. Medium speed
d. High speed
e. Lights ON / OFF
2. FILTERS
a. (2) 14-3/8" x 12-3/4" Aluminum filters and (2) fillers (30" model)
b. (2) 14-3/8" x 12-3/4" Aluminum filters and (2) fillers (36" model)
c. (3) 14-3/8" x 12-3/4" Aluminum filters and (2) fillers (42" model)
d. (3) 14-3/8" x 12-3/4" Aluminum filters and (2) fillers (48" model)
Activate delay shut-off: Press “Button A" once to activate 90 seconds delay
shut-off. Light surrounding button will flash and fan will turn off after 90 seconds.
Turn off Fan: Press “Button A" twice to instantly turn off the fan.
a b c d e
NOTE: Install handles onto the frame of the aluminum filter before use.
3. REMOVING THE FILTERS
b. Push the frame back/down into the hood.
Tilt the frame out.
c. Remove the frame.
d. Removing Tray: Lift at an angle and remove
stainless steel oil tray for
cleaning.*
9
i
ii
iii
Pull up on the filter latch, tilt towards you and
remove the filter.
a.
i
ii
iii
a. Push the handles back/down into the hood
and.
Tilt the filters towards you.
i
ii
b. Remove the baffle filter.
iii
Remove stainless steel oil tray for cleaning.*
c.
* Remove stainless steel oil tray cleaning.
i
ii
iii
Aluminum Filter Set Baffle Filter (Optional)
Note: Aluminum filter can be removed
with the frame.
Back of Hood
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Campana de ventilación de Windster
Windster
Windster H30SS Manual de usuario
Windster
Windster WS-28TB30SS Manual de usuario
Windster
Windster RA-7630SS Manual de usuario
Windster
Windster ISLAND Series Manual de usuario
Windster
Windster RA-268 Manual de usuario
Windster
Windster LINER WS-69TB30 Manual de usuario
Windster
Windster WS-50E30SS Manual de usuario
Windster
Windster LINER WS-69TB30 Manual de usuario
Windster
Windster WS-96TB30SS Manual de usuario
Windster
Windster WSC-4630SS Manual de usuario
Windster
Windster RA-1730 Manual de usuario
Windster
Windster WS-4836SS Manual de usuario
Windster
Windster WS-5530SS Manual de usuario
Windster
Windster WS-6730SS Manual de usuario
Windster
Windster WS-96TB Manual de usuario
Windster
Windster RA=33 Series Manual de usuario
Windster
Windster WS-268 Manual de usuario
Windster
Windster RA-7730SS Manual de usuario
Windster
Windster WS-38U30SS Manual de usuario
Windster
Windster RA-7630SS Manual de usuario
