Whirlpool CAM2762KQ Manual de usuario

WHIRLPOOL CAM2762KQ WASHER

INSTALLATION INSTRUCTIONS

FOR DEBITEK SLIM READER

Remove the two screws on either side of the machine backsplash

(Fig. 1) and raise the backsplash to gain access to the wiring har-

ness. The access cover on the meter housing should also be re-

moved.

Fig. 1

Locate the two mounting screws for the

machine timer inside the meter housing (Fig.

2). Loosen the screws. They do not need to

be completely removed. Lift up on the timer

assembly and remove it from the meter

housing. It may be necessary to remove the

two harness plugs on the back of the timer in

order to accomplish this step. Press in on the

clips on either side of the timer plugs to

release them and carefully detach them from

the timer.

Fig. 2

Fig. 3

Locate the beige jumper wire attached to the

bottom plug (Fig. 3). The end of this wire may be

taped to the harness. If the wire is not already

connected to the upper plug (black), the terminal

on this wire must be installed in the upper plug in

order for the machine to operate.

Fig. 4

Looking at the rear of the upper plug, the

connector on the beige jumper should be

inserted into the empty slot located in the

second position from the left on the top row.

This position should have a black wire with

a white stripe directly below it. (Fig. 4)

Once this has been completed, replace the

timer and secure the mounting screws. Make

certain that the feature connection harness

from the bottom plug is not pinched under-

neath the timer assembly and is easily

accessible from the access opening in the

meter housing.

Locate the power transformer included

with the kit and secure it inside the

backsplash using the self-adhesive velcro

provided. Then connect the two-pin, white

Molex connector on the reader harness to

the matching power connector on the

machine (Fig.5). This connector is located

in the main wiring harness inside the

backsplash and may be taped. It will be

necessary to remove the dummy plug on

the end of the connector prior to attaching

the reader harness.

Fig. 6

Attach the 110-volt connections on the Debitek

transformer to the reader harness. These are the two

large connectors on the transformer on the ends of the

thickest wire. Corresponding attachment points on the

reader harness have a yellow and black wire on one

and a single white wire on the other. The connections

are not polarized and may be connected to either wire

on the transformer.

Attach the remaining two wires on the transformer to

the red and black wires with matching connectors on

the reader harness . Again, polarity does not matter.

Fig. 5

Route the loose ends of the reader

harness through the hole in the

side of the backsplash area into the

meter housing and attach the

machine’s feature connector plug

(Fig.7) to the appropriate connec-

tor on the harness.

Fig. 7

Pull the end of the reader cable with the black Molex

connector through the coin slide opening (Fig. 8) and

plug it into the mating connector on the back of the

card reader. Then mount the card reader in the coin

slide opening using the supplied coin slide bolt.

Fig. 8

Secure all wiring with the supplied wire ties, ensuring that no part of the harness can interfere with the

rotating arm on the side of the timer assembly. Verify that all connections are correct according to the

included installation drawing. Close and secure the backsplash.

The unit can now be programmed and tested.After starting the machine should be allowed to complete

one full cycle and stop on its own to ensure that there are no issues with wiring or reader programming.

Otros manuales de Arandela de Whirlpool

Whirlpool

Whirlpool WTW5057LW Manual de usuario

Whirlpool

Whirlpool Michigan 49022 Manual de usuario

Whirlpool

Whirlpool WTW9500EW Manual de usuario

Whirlpool

Whirlpool Cabrio WTW6400SW2 Manual de usuario

Whirlpool

Whirlpool W10656457B Manual de usuario

Whirlpool

Whirlpool FDLR70210 Manual de usuario

Whirlpool

Whirlpool WTW7000DW0 Manual de usuario

Whirlpool

Whirlpool GVW9959KL2 Manual de usuario

Whirlpool

Whirlpool GCAM2792LQ0 Manual de usuario

Whirlpool

Whirlpool WFW5030JW Manual de usuario

Whirlpool

Whirlpool WFW96HEAC Manual de uso y mantenimiento

Whirlpool

Whirlpool LA6500XP Manual de usuario

Whirlpool

Whirlpool FL243 Manual de usuario

Whirlpool

Whirlpool LSV8244BW0 Manual de usuario

Whirlpool

Whirlpool AWE 6517 Manual de usuario

Whirlpool

Whirlpool LA6098XT Manual de usuario

Whirlpool

Whirlpool WTW5500 Manual de usuario

Whirlpool

Whirlpool LA5705XW Manual de usuario

Whirlpool

Whirlpool TDLR70212 Guía de instalación

Whirlpool

Whirlpool AWE 9527 Manual de usuario

Whirlpool

Whirlpool AWH 912/PRO Manual de usuario

Whirlpool

Whirlpool WVMD1208AHG Manual de usuario

Whirlpool

Whirlpool LA7000XS Manual de usuario

Whirlpool

Whirlpool LA5800XP Manual de usuario

Manuales populares de Arandela de otras marcas

Tricity Bendix

Tricity Bendix AW 1000 W Guía del producto

Panasonic

Panasonic NA-F60L5WRB Manual de usuario

GE WSLP1500 Manual

Electrolux

Electrolux EWF1284EDW Manual de usuario

Bosch

Bosch WAN2829BSN Manual de usuario

LG TV2516DV3B Manual de usuario

LG TH2517DSAV Manual de usuario

VESTEL

VESTEL CMH-XL 7510 TE Manual de usuario

AEG

AEG 74335 Manual de operación

Johnson

Johnson JWF721A Manual de usuario

Beko

Beko WTE7604XLW0 Manual de usuario

Danby

Danby DTT100A1WDB Instrucciones de montaje

Amica

Amica WA 14 Ex Manual de usuario

Daewoo

Daewoo DWD-F1222 Manual de usuario

Bosch

Bosch WAS28461AU Manual de usuario

Miele

Miele PW 6080 Vario Manual de usuario

Finlux

Finlux FLX108CF220 Manual de usuario

Beko

Beko WKB 51231 PTMA Manual de usuario