Whirlpool AKR1985/IX Manual de usuario

T-BOX COOKER HOOD

AKR1985/IX

INSTRUCTION MANUAL

Dear Customer,

If you follow the recommendations contained in this Instruction Manual, our appliance

will give you constant high performance and will remain efficient for many years to

come.

CONTENTS

RECOMMENDATIONS AND SUGGESTIONS

CHARACTERISTICS

INSTALLATION & USE

MAINTENANCE

Product Specification & Technical Parameters

Model AKR1985/IX

Rated Voltage 220-240V~

Rated Power Frequency 50Hz

Light Power 2x20W 12V

Motor Power 270W

Total Power 310W

Motor 1

Diameter of Exhaust Pipe 150mm

Dimension (mm) W 898 x D 498 x H 585-1015

RECOMMENDATIONS AND SUGGESTIONS

INSTALLATION

* The manufacturer will not be held liable for any damages resulting from incorrect or

improper installation.

* Please read this instruction manual before installing and using this cooker hood.

Properly keep this instruction manual in a safe place for future reference.

* This cooker hood can be used in the Ducted Mode (ducting fumes to the outside).

* Only a qualified and trained service technician can undertake the work of installation

and servicing.

* Check that the mains voltage corresponds to the one indicated on the rating plate

fixed inside the hood.

* Check that the domestic power supply guarantees adequate earthing.

* Do not connect the hood to exhaust ducts carrying combustion fumes (boilers,

fireplaces, etc.)

* If the hood is used in conjunction with non-electrical appliances (e. g. gas burning

appliances), a sufficient degree of ventilation must be guaranteed in the room in order

to prevent the backflow of exhaust gas. The kitchen must have an opening directly

with the open air in order to guarantee the entry of clean air.

* The minimum distance is 700mm from the bottom of cooker hood to the top of hob.

NOTICE: Considering excessive weight, two or more people are required to install or

move this appliance. Failure to do so can cause physical injuries.

USE

* The cooker hood has been designed only for domestic use to eliminate kitchen

fumes.

* Never use the hood for purposes other than what it has been designed for.

* Never leave high naked flames under the hood when it is in operation.

* Adjust the flame intensity to direct it onto the bottom of the pan only; making sure

that it does not engulf the pan sides.

* Deep fat fryer must be continuously monitored during use: overheated oil can burst

into flame.

* The hood should not be used by children or person not instructed in its correct use.

MAINTENANCE

* Proper maintenance of the Range Hood will assure proper performance of the unit.

* Disconnect the hood from the main supply before carrying out any maintenance

work.

* Clean and/or replace aluminum grease filters and activated charcoal filters after

specified period of time.

* Clean the hood using a damp cloth and a neutral liquid detergent.

* DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of

such waste separately for special treatment is necessary.

WARNING!!

In certain circumstances electrical appliances may be a danger hazard.

* Do not check the status of the filters while the cooker hood is operating.

* Do not touch the light bulbs after appliance use.

* Do not disconnect the appliance with wet hands.

* Avoid free flame, as it is damaging for the filters and a fire hazard.

* Constantly check food frying to avoid that the overheated oil may become a fire

hazard.

* Disconnect the electrical plug prior to any maintenance.

* Children don’t recognize the risks of electrical appliances. Therefore use or keep the

appliance only under supervision of adults and out of the reach from children.

* Don’t use this product outdoor.

* This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning use of the appliance by a

person responsible for their safety. Children should be supervised to ensure that they

do not play with the appliance.

* There shall be adequate ventilation of the room when the range hood is used at the

same time as appliances burning gas or other fuels.

* There is a fire risk if cleaning is not carried out in accordance with instructions.

* Do not flambé under the range hood.

* The discharge air must not be discharged into a flue which is used for exhausting

fumes from appliances burning gas or other fuels.

CHARACTERISTICS

DIMENSIONS

COMPONENTS

Ref Q’ty Product Components

1 1pc

Hood body, complete with: controls, lights, blower, filters, air

outlet adapter

2 1set

Telescopic Chimney comprising

2.1 1pc

Decorative Chimney Top

2.2 1pc

Decorative Chimney Bottom

3 1pc Aluminum Exhaust Duct (source locally, not supplied)

4 1pc Wall or Roof Cap (source locally, not supplied)

Ref Q’ty Installation Components

5.1 1pc Chimney Mounting Bracket

5.2 1pc

Hood Mounting Bracket

6 1set

Damper (flaps)

7.a 5pcs Mounting Screws (ST 5 X 50MM)

7.b 2pcs Chimney Mounting Bracket Screws (M 4 X 10 MM)

7.c 3pcs Chimney Bottom Fixing Screws (ST 4 X10 MM)

8 5pcs Drywall Anchors

Ref Q’ty Documentations

9 1pc Instruction Manual

10 1pc

Warranty Card

INSTALLATION & USE

Note 1 : On stainless steel hoods, carefully remove the plastic protective film from all

exterior surfaces of the hood and chimney prior to final installation.

Note 2: At least two people will be required to mount the hood.

WALL DRILLING AND BRACKETS FIXING (X=Y-240)

1. Draw a vertical line on the supporting wall up to the ceiling, or as high as practical,

at the centre of the area in which the hood will be installed.

2. Draw a horizontal line at 700mm

above the hob.

3. Place one of chimney mounting

brackets 5.1 on the wall as shown

min. 20mm from the ceiling or

upper limit aligning the centre

(notch) with the vertical reference

line.

4. Mark the wall at the centre of the

holes in the bracket.

5. Place the hood mounting bracket 5.2 on the wall as shown aligning the central

notches to the vertical reference line.

6. Mark the wall at the centre of the holes in the bracket.

7. Drillφ10mm holes at all the centre points marked.

8. Fix the two brackets using the mounting screws and drywall anchors.

MOUNTING THE HOOD BODY

1. Hook the body onto the hood mounting

bracket 5.2 as shown.

2. Balance the hood body by slightly

adjusting the hood mounting bracket.

Gently lower the hood until it securely

engages the bracket.

DAMPER (FLAPS) FIXING

1. Fix the damper (flaps) into the air outlet adapter.

2. To be sure that the damper (flaps) is locked well on the air

outlet adapter, it should be flexible in opening and closing.

DUCT FIXING

Caution: To reduce the risk of fire, use metal ductwork only.

1. Attach an adequate length of φ150mm round duct to

the rangehood adapter.

2. Duct tape all joints to make them secure and air tight, or

use a fastener to make it secure and air tight. (fastener is

an accessory or source locally.)

CONNECTIONS

Ducted mode air exhaust system

Caution: To reduce the risk of fire, use metal

ductwork is preferred.

1. Decide where the ductwork will run

between the hood and the outside.

2. Astraight, short duct run will allow the hood

to perform most efficiently.

3. Long duct runs, elbows, and transitions will

reduce the performance of the hood. Use

as few of them as possible. Larger ducting

may be required for best performance with longer duct runs.

4. Attach an adequate length of φ150mm round duct to the air outlet adapter.

5. The air must not be discharge into a flue that is used for exhausting fumes from

appliances burning gas or other fuels" "Regulations concerning the discharge of

air have to be fulfilled.

6. Install a roof/wall cap. Connect round metal ductwork to cap and work back

towards hood location. Use duct tape to seal the joints between ductwork

sections.

Electrical Connection

* Electrical wiring must be done by a qualified person(s) in accordance with all

applicable codes and standards. Turn off electrical power at service entrance

before wiring.

* If the supply cord is damaged, it must be replaced by the manufacturer, its service

agent or similarly qualified persons in order to avoid a hazard.

* Do not use the plug and an extension cord other than the ones initially supplied with

the hood.

* The earthing of this hood is compulsory. Do not remove ground prong of the plug.

TELESCOPIC CHIMNEY COMPRISING ASSEMBLY

Decorative Chimney Top

Raise the decorative chimney top 2.1 up inside the decorative

chimney bottom 2.2. Secure decorative chimney top 2.1 to the

chimney mounting bracket 5.1 that is well fixed on the wall with the

two chimney bracket screws 7.b supplied from two sides.

Decorative Chimney Bottom

1. Carefully slide the decorative chimney bottom 2.2 down outside the decorative

chimney top 2.1. Carefully place the decorative

chimney bottom 2.2 into the recessed area of the hood

body top.

2. Fix the Decorative Chimney Bottom 2.2 with the three

decorative Chimney Bottom screws 7.c supplied from

inside of hood body.

OPERATION OF CONTROLS

The hood is operated using the push button on the front

panel.

The light switch turns the lamps on and off.

The blower switch turns the blower on to three speed settings:

0 - OFF

1 - LOW SPEED

2 - MEDIUM SPEED

3 - HIGH SPEED

4 – LIGHT

MAINTENANCE

GREASE FILTER

* The grease filters should be cleaned frequently (every two months of operation, or

more frequently for heavy use). Use a warm detergent solution.

* Grease filters are washable.

1. Remove the grease filter one by one by pulling

out each latch. This will disengage the filter from

the hood. Tilt the filter downward and remove.

2. Wash the filters, taking care not to bend them.

Allow them to be dry before refitting.

3. When refitting the filters, make sure that the handle is visible from the outside.

4. To install the grease filter, align rear filter tabs with slots in the hood. Pull out the

latch, push filter into position and release. Make sure the filter is securely

engaged after assembly.

HALOGEN BULBS

This range hood requires two halogen bulbs (Type JCD, 12V, 20W Max, G-4 Base)

WARNING: Always switch off the electrical supply before carrying out any operation

on the appliance.

To change bulbs:

1. Kick off the halogen bulb cover ②by using the flat screw driver.

2. Remove the bulb by pulling sideward (DO NOT ROTATE).

3. Replace with Type JCD, 12V, 20W Max, G-4 Base halogen bulb. Do not touch

replacement bulb with bare hands !

Otros manuales de Campana de ventilación de Whirlpool

Whirlpool

Whirlpool GZ7730XGS0 Manual de usuario

Whirlpool

Whirlpool AKR 689 Instrucciones de montaje

Whirlpool

Whirlpool RH2030XJB1 Manual de usuario

Whirlpool

Whirlpool AKR912IXS Manual de usuario

Whirlpool

Whirlpool WVW57UC0FS Hoja de información del producto

Whirlpool

Whirlpool GZ9736XSS Manual

Whirlpool

Whirlpool WSLESS 66 AS X Manual de usuario

Whirlpool

Whirlpool AKR 687 - EXTRACTOR OR FILTERING HOOD Manual de usuario

Whirlpool

Whirlpool AKR 641 Instrucciones de montaje

Whirlpool

Whirlpool UXW7324BSS0 Hoja de información del producto

Whirlpool

Whirlpool GZ5730XR Series Guía del usuario

Whirlpool

Whirlpool AKR 633 WH Manual de usuario

Whirlpool

Whirlpool AKR 890 - EXTRACTOR OR FILTERING HOOD Manual de usuario

Whirlpool

Whirlpool AKT3570/IX Guía de instalación

Whirlpool

Whirlpool RH2330XJ Manual de usuario

Whirlpool

Whirlpool HE36W Guía de instalación

Whirlpool

Whirlpool WVU15UN0F Hoja de información del producto

Whirlpool

Whirlpool AKR6151IXS Manual de usuario

Whirlpool

Whirlpool 99044504A Hoja de información del producto

Whirlpool

Whirlpool WMH78519L Manual de usuario

Whirlpool

Whirlpool RH7330XL Manual de usuario

Whirlpool

Whirlpool RJH 3330-1 Manual de usuario

Whirlpool

Whirlpool Build-in 30 inch Hoja de información del producto

Whirlpool

Whirlpool GXW6530DXS Hoja de información del producto

Manuales populares de Campana de ventilación de otras marcas

emmeti

emmeti RECUPA MED A-140 Guía

Nibe

Nibe F135 Manual de usuario

Kuppersberg

Kuppersberg INTRO 60 Instrucciones de instalación y mantenimiento

Zephyr

Zephyr Spruce AK9834BS Guía de instalación

Hisense

Hisense MH6INBG Manual de usuario

Miele

Miele DA 1255 Manual de usuario

Broan

Broan 46000 Manual de usuario

GE Profile PV977 Instrucciones originales

FALMEC

FALMEC FFRIA24W5FS Manual de usuario

Küppersbusch

Küppersbusch DX ISLA Manual de usuario

ETNA

ETNA AV360RVS Manual de usuario

JUNO

JUNO JDF603E6 Manual de usuario

Miele

Miele DA 6708 D Manual de usuario

Tricity Bendix

Tricity Bendix LE 150 Manual

AEG

AEG X68163BV1 Manual de usuario

AEG

AEG 125 D Manual de usuario

Smeg

Smeg KSEV97X Manual de usuario

Nibe

Nibe S Series Guía del usuario