Wen 5500 Manual de usuario

Wen 5500 (13 hp engine) carburetor assembly

To disassemble the carburetor on a Wen 5500 generator, do the following:

Remove the two P2 (#2 PoziDrive) head screws holding the solenoid to the bottom of the

carburetor bowl.

Remove the 14mm hex head bolt from the bottom of the carburetor bowl.

Separate the bowl from the bottom of the carburetor.

Remove the pivot pin from the float and pull the float away from the carburetor.

Insert a ¼” flat head screwdriver into the center stem of the carburetor and remove the

jet.

Remove the nozzle from inside the center stem.

Reassembly is in reverse order. Be sure the o-ring is properly seated between the bowl

and the bottom of the carburetor.

Manuales populares de Generador portátil de otras marcas

Kohler

Kohler 20EORZ Manual de instrucciones

Powerhorse

Powerhorse 83171 Manual de usuario

HURST

HURST ML-630-SI Manual de usuario

ETQ

ETQ TG4000 Manual de usuario

Briggs & Stratton

Briggs & Stratton 40265 Guía de configuración

ConMed

ConMed 7550 Manual de usuario

Owon

Owon Waveform Generator Manual de usuario

evertz

evertz 7700 Series Manual de usuario

Power Stroke

Power Stroke PS906025 Manual de usuario

Firefly

Firefly Cygnus CYG2400/460/24 Manual de usuario

Draper

Draper PG950S Actualización de firmware

PowerBoss

PowerBoss PowerBoss Manual de usuario

SDMO

SDMO SH 4000 Manual de usuario

EINHELL

EINHELL STE 5500 Manual de usuario

Wanco

Wanco WI3000P Manual de usuario

Full Boar

Full Boar FBT-3300 Manual de usuario

Dwyer Instruments

Dwyer Instruments ASG Manual de usuario

Westinghouse

Westinghouse WH1000i Series Manual de usuario