3
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These lim-
its are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instruction manual,
may cause harmful interference to radio commu-
nications. Operation of this equipment in a resi-
dential area is likely to cause harmful interference
in which case users will be required to correct
the interference at their own expense.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Cet appareil numérique de la classe A respecte
toutes les exi-gences du Règlement sur le
matériel brouilleur du Canada.
It is your responsibility to ensure that this control is safely installed according to all applicable
codes and standards.
Watts is not responsible for damages resulting from improper installation and/or maintenance.
This is a safety-alert symbol.
The safety alert symbol is
shown alone or used with
a signal word (DANGER,
WARNING, or CAUTION),
a pictorial and/or a safety
message to identify hazards.
When you see this symbol
alone or with a signal word
on your equipment or in
this manual, be alert to the
potential for death or serious
personal injury.
This pictorial alerts you to
electricity, electrocution, and
shock hazards.
This symbol identifies hazards which, if not avoided,
could result in death or serious injury.
This symbol identifies hazards which, if not avoided,
could result in minor or moderate injury.
This symbol identifies practices, actions, or failure
to act which could result in property damage or
damage to the equipment.
• It is the installer’s responsibility to ensure
that this control is safely installed according
to all applicable codes and standards.
• Improper installation and operation of this
control could result in damage to the
equipment and possibly even personal
injury or death.
• This control is not intended for use as a
primary limit control. Other controls that are
intended and certified as safety limits must
be placed into the control circuit.
Radio Frequency
Interference
NOTICE
Read manual and all prod-
uct labels BEFORE using
the equipment. Do not use
unless you know the safe
and proper operation of this
equipment. Keep this man-
ual available for easy access
by all users. Replacement
manuals are available at
tekmarControls.com
Do not attempt to service the control. There
are no user serviceable parts inside the control.
Attempting to service the control voids the
warranty.
Important Safety Information
