6
Front Panel
1. AC Power Button – Press and hold for three seconds to manually toggle the outlets on or o on all connected PDUs.
Outlets configured as Disabled or Reset Only are not aected on each connected PDU.
2. LED Indicators – See the status of the internet, safe voltage, surge protected, and whether the unit is properly Grounded.
See “LED Operation” on page 9.
3. Voltage Display – Displays the voltage (V) being supplied to the selected PDU from the wall outlet.
4. Output Current Display – Displays current draw in amps (A) for a single PDU or the total for all PDUs.
5. PDU Power Indicator – Has two states:
a. Blinking – The Current display shows the selected PDU’s current draw in amps (A).
b. Solid – The Current display shows the aggregate current draw of all connected PDUs.
6. Button 1 – Sequences through PDUs 1 through 3 and Total (left to right) displaying the current for the specified PDU. The
aggregate of all PDUs displays when Total is selected. This button is also used to reset individual PDUs. See “How to
Manually Reset Individual PDUs From the Faceplate” on page 7.
7. Button 2 – Sequences through Total and PDUs 3 through 1 (right to left) displaying the current for the specified PDU.
The aggregate of all PDUs displays when Total is selected. This button is also used to reset individual PDUs. See “How to
Manually Reset Individual PDUs From the Faceplate” on page 7.
8. USB Ports – For powering USB devices. 1.5A maximum per port.
9. Accessory Outlet (Unprotected and Non-Controllable) – Always-on, front-facing outlet for service use. A solid blue LED
indicates the outlet has power and is working.
1 2 3 Total
B1
B2
ACCESSORY OUTLET
(UNPROTECTED)
CURRENTVOLTAGE
POWER
WB-800I-FP
1 2 3 4 56 7 8 9
