WATT AGE 130116 Manual de usuario

AC/DC LiPO/NiMH/NiCD CHARGER with Peak-Detection

Circuitry and Auto Voltage Sensor

Charge-It-All Sport Features:

●AC/DC Input Voltage (110V or 12V)

●Peak-Detection Circuitry with Timed Safety Auto-Cutoff

●1A, 2A, 3A, 4A or 6A Selectable Charge Rates in NiCD/NiMH Mode

●100mAH, 300mAH, 700mAH, 1.3A or 2A Selectable Charge Rates in Lithium Mode

●Charges 1 - 8 NiCD or NiMH Cells and 1-3 LiPO Cells

●Automatic Voltage Detection

●Reverse Polarity Protection

●Internal Cooling Fan to Reduce Heat

●Easy to Set Up and Use

Product Part # 130116

Introduction:

Thank you for choosing the Wattage Charge-It-All Sport AC/DC Peak-Detection charger. This charger is designed to charge 1 (1.2V) to 8 (9.6V)

Nickel-Cadmium or Nickel-Metal Hydride cells ranging from 250mAH and higher and 1 (3.7V) to 3 (11.1V) Lithium Polymer cells ranging from

100mAH and higher. Please read through this operations sheet completely before using your charger for the first time. If charging LiPO cells,

please read and understand the special warnings specifically for LiPO cells.

CHARGE-IT-ALL SPORT

Included with Your Charger:

●2-Pronged 110V AC Input Cord

●12V DC Input Cord w/Alligator Clips

●Output Cord w/Banana Plugs

●JST Plug Adapter

Please Read and Understand the Following Warnings:

●This charger is designed to charge 1-8 NiCD and NiMH battery cells and 1-3 LiPO cells ONLY. Do not attempt to charge any other type of battery,

such as gel cell, lead-acid or Alkaline batteries.

●NEVER connect the AC power and the DC power input cords at the same time and never allow the 12V DC alligator clips to touch or short out.

●When the charger is connected to an automotive battery (12V DC power source), do not start the automobile’s engine. The engine can be running

during the charging process, but starting or turning off the engine during the charging process can damage the charger and/or your battery pack.

●Do NOT allow children to use the charger without adult supervision.

●NEVER leave the charger connected to a power source when not in use.

●NEVER leave the charger unattended when the charger is in use.

●NEVER place the charger on a carpeted surface during use.

●ALWAYS disconnect the battery pack from the charger if the battery pack becomes unusually warm or hot.

●AVOID using the charger in direct sunlight.

●ALWAYS allow the battery pack to cool before recharging it.

When charging LiPO battery packs, please read and understand the special warnings listed below. Also make sure to read any and all

warnings included in the packaging with your battery. If used improperly, LiPO batteries can be very dangerous, so please follow these

warnings and suggestions at all times.

●DO NOT use the product if you do not understand the warnings and proper use of the product.

●ALWAYS let the battery cool and "rest" between uses and charging.

●We recommend the use of a fire-safe container when charging or storing.

●DO NOT charge inside your car or inside your house.

●Inspect the battery before each use for swelling or other malformation. If the cell has ballooned, it MUST be discarded.

●Set the charger to 1C (charge at 1/2C or less for the first 5 cycles).

●Check polarity and then connect battery to charger.

●When handling the battery, remember not to poke, bend or damage the cell. The cell outer casing is soft and can be damaged.

●Remember, the cells must never exceed 160 degrees Fahrenheit for any reason.

●LiPO cells may explode or catch fire. Serious injury can result from misuse. Serious injury, loss of property, fire and death can result from misuse

of this product.

●All instructions, warnings and cautions must be followed at all times. Failure to do so can lead to serious injury or fire.

●DO NOT overcharge. Maximum voltage for each pack must be followed.

●DO NOT leave in direct sunlight or in a hot car or storage area.

●DO NOT get wet or expose to moisture.

●DO NOT short-circuit the battery.

●DO NOT leave the battery connected when not in use.

●DO NOT operate or charge unattended.

1Continued On Back Page

☛☛

☛

Charge-It-All Sport Safety Features:

●If the battery pack polarity is reversed or if the battery pack has a short circuit,

the charger will shut off and the charge rate LEDs will blink together. If this

happens, unplug the battery pack from the charger and double-check all wires

for polarity and short circuits before reattaching the battery pack to the charger.

●When the START/STOP button is pressed to start the charging process,

an internal safety timer is automatically started. If the battery pack

malfunctions or misses the “peak,” the timer will automatically stop the

charging process after the following elapsed times:

NiCD and NiMH MODE

1 Amp .................. 300 Minutes

2 Amps ................. 150 Minutes

3 Amps ................. 100 Minutes

4 Amps ................... 75 Minutes

6 Amps ................... 50 Minutes

LITHIUM MODE

All Amp Ratings ........... 3 Hours

After the charge process is complete, the charger switches

to trickle charge mode at 1/10th of the selected charge rate,

regardless of the charge mode

Using Your Charge-It-All Sport Charger:

Before using your charger for the first time, please read and

understand the warnings listed on the front page. Failure to

understand and follow these warnings can result in damage to the

charger, your flight battery or worse.

●Plug the desired input cord into the back of the charger (either 12V DC

or 110V AC), then plug the input cord into the power source. The red and

green LEDs will default to the position they were in when the charger was

last used.

WARNING Never plug the charger into a 220V power source and never

connect the charger to a 12V DC and a 110V AC power source at the

same time. Use only one desired power source at a time. If connecting

the charger to a 12V DC power source, make sure to attach the red

alligator clip to the positive terminal and the black alligator clip to the

negative terminal.

●Plug the banana plugs on the output cord into the front of the charger,

making sure that the polarity is

correct (red to red and black to

black), then connect your

battery to the output cord.

IMPORTANT If the connector on

your battery is different from the

connector on the output cord,

you will need to change the

connector on the output cord. If you do, double-check that the polarity is

correct when you install your new connector.

NOTE The charger includes a JST adapter if your battery uses a JST

plug. The JST plug is typically referred to as a BEC connector and is red.

●Choose the charge type (either NiMH, NiCD or Lithium) by pressing

and holding the MODE button for

1.5 seconds. The charge mode

will change as indicated by the

green LED. If your battery has

NiCD cells, choose the NiCD

charge mode. If your battery has

NiMH cells, choose the NiMH

charge mode. If you have a

Lithium Polymer (LiPO) battery,

choose the Lithium charge mode.

WARNING Always make sure that you choose the charge mode that

matches the type of cells in your battery pack. Charging your battery pack

using a charge mode that’s different than the cell type you’re charging will

damage the battery pack and possibly result in fire.

●After selecting the charge

mode, select the charge rate by

briefly pressing the MODE

button until the desired charge

rate is selected as indicated by

the blinking red LED. See the

table below for recommended

charge rates.

Recommended Charge Rates

We recommend choosing a charge rate for NiMH batteries that is close to

the batteries’ rated mAH capacity (e.g., charge a 2000mAH NiMH battery

at no more than 2 amps). For NiCD batteries, we recommend choosing a

charge rate that is 1-3 times the batteries’ rated mAH capacity (e.g., charge

a 1400mAH NiCD battery at 2-4 amps).

NiCD Charge Rates NiMH Charge Rates

1000mAH 1A -3 A 1000mAH 1A

1200mAH 2A - 3A 1200mAH 1A

1400mAH 2A - 4A 1400mAH 1A

1600mAH 2A - 5A 1600mAH 1A - 2A

1800mAH 2A - 5A 1800mAH 1A - 2A

2000mAH 2A - 6A 2000mAH 2A

2400mAH 3A - 6A 2400mAH 2A

2800mAH 3A - 6A 2800mAH 3A

3000mAH 3A - 6A 3000mAH 3A

Lithium Charge Rates

145mAH .1A (100mAH) 1250mAH 1.3A

340mAH .3A (300mAH) 1500mAH 1.3A

350mAH .3A (300mAH) 2000mAH 2A

520mAH .3A (300mAH) 2100mAH 2A

750mAH .7A (700mAH) 2150mAH 2A

830mAH .7A (700mAH) 2500mAH 2A

910mAH .7A (700mAH) 3200mAH 2A

1050mAH .7A (700mAH) 4000mAH 2A

Sample average charge time for a 1600mAH battery charged at:

1Amp is 96 minutes

2Amps is 48 minutes

4Amps is 24 minutes

IMPORTANT Batteries may be charged at different rates depending on

the manufacturer’s suggestions. The table above is for general reference

only and errs on the side of caution.

IMPORTANT If you are charging 8 cells using a 12V DC power source,

the DC input (your power source) MUST be higher than 14V.

1000mA in 1A

1600/4000=0.4x60=24 Minutes

2Continued On Back Page

☛☛

☛

●After selecting the proper charge rate and double-checking that the proper charge mode is selected, press the START/STOP button to begin the

charge process. During the charge process the red LED will be steady. If you need to stop the charge process before charging is complete, press

the START/STOP button again or disconnect your battery from the charger.

IMPORTANT If there is a battery error (i.e., reversed polarity or internal short), the charge rate LEDs will

blink together shortly after you press the START/STOP button. If this occurs, remove the battery from the

charger and check all connections and battery integrity before attempting to charge the battery again.

●At the end of the charging process, the charger will detect when the battery reaches its peak and will stop

fast charging. At this point, the charge rate LED will begin to blink, indicating that the charger is now in

trickle mode and that the battery is ready for use.

Charging Tips:

●Always unplug the charger when you are finished charging.

●Let the charger cool between uses, especially on hot or humid days.

●New batteries should be charged at the lowest recommended charge rate for the first 3 charging cycles (5 cycles for LiPO cells). This will ensure

your batteries’ long life and optimal capacity.

●Always use your charger on a hard surface. Never use it while setting on carpeted surfaces. Carpeted surfaces will block the cooling vents on the

bottom of the charger, which can cause the charger to overheat during use.

●Most LiPO cells can be charged at 1C, but charging at .5C will produce a better charge and prolong the life of the battery. It will also lessen the

chance of damaging the battery during the charging process.

Your new WattAge Charge-It-All Sport AC/DC Peak Charger is guaranteed to be free of workmanship and component error for a period of 90 days

starting from the original time of purchase. Warranty claims must be accompanied by an itemized sales receipt that shows the purchase date.

In that WattAge has no control over the final use of this product, by installing and using the product, the user accepts all liability resulting from

or included with the installation and use of this product. In no instance will the liability cost of the charger exceed the original purchase price of

the charger.

FOR SERVICE AND INFORMATION WITHIN THE USA:

Global Services/WattAge Customer Care

18480 Bandilier Circle

Fountain Valley, CA 92708

Phone: (714) 963-0329 Fax: (714) 964-6236

Email: service@globalhobby.net

http://globalservices.globalhobby.com

WattAge IS EXCLUSIVELY DISTRIBUTED IN THE USA BY

GLOBAL HOBBY DISTRIBUTORS

Version V1.0 January 2005

Este manual sirve para los siguientes modelos

Otros manuales de Cargador de baterías de WATT AGE

WATT AGE

WATT AGE PF-12 Manual de usuario

Manuales populares de Cargador de baterías de otras marcas

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Manual de usuario

Enelion

Enelion Vertica Manual de usuario

RCA

RCA CHU6 Manual de usuario

ANSMANN

ANSMANN ALCT 6/24-10 Manual de usuario

Hitachi

Hitachi UC 18YRSL Guía de solución de problemas

Olympus

Olympus B-20 LPC Manual de usuario

Exibel

Exibel ZH1708143 Manual de usuario

Lenmar

Lenmar Mach 1 Manual de usuario

CTEK

CTEK MXS 5.0 Manual de usuario

ABB

ABB HT842379 Manual de usuario

Nitecore

Nitecore Superb Charger SC4 Manual de usuario

Renogy

Renogy RBC2125DS-21W Manual de usuario

Braun

Braun BWC02M Manual de usuario

CTEK

CTEK MXS 3.6 Manual de usuario

Black & Decker

Black & Decker BDV090 Manual de usuario

Trinity

Trinity DPD Manual de usuario

Hulkman

Hulkman Sigma 1 Manual de usuario

IKEA

IKEA koppla Manual de usuario