VTech Baby 2-in-1 Push & Discover Turtle Instrucciones de montaje
Parent’s Guide
91-003985-001 UK
2-in-1 Push &
Discover Turtle
On/Off/Volume
Switch
Number Button
Music Button
Turtle & Butterfly
Button
INTRODUCTION
Meet the 2-in-1 Push & Discover Turtle by VTech®! This adorable
little turtle and butterfly really are baby’s best friends! The easy-to-
grab handle is perfect for little hands and easily detaches for two
ways of play. The light up Number button, Music button and Turtle &
Butterfly button introduce the turtle and butterfly, counting, sounds,
melodies and phrases.
2
2
2
INCLUDED IN THE PACKAGE
• 2-in-1 Push & Discover Turtle
• Handle
• Handle base
• Parent’s Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE
Please keep this Parent’s Guide as it contains important information.
Removing the Packaging Locks:
Rotate the packaging lock 90 degrees
anticlockwise.
1
2Pull out the packaging lock and discard.
3
3
3
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the turtle. Use a screwdriver
to loosen the screw and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA batteries following the diagram inside the battery
box. (For best performance, alkaline batteries or fully charged Ni-
MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
4
4
4
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates
they must not be disposed of in domestic waste as
they contain substances that can be damaging to the
environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on
the market after 13th August, 2005.
Help protect the environment by disposing of your
product or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.
5
5
5
ASSEMBLY INSTRUCTIONS
With the 2-in-1 Push & Discover Turtle, safety comes first. To
ensure your child’s safety, adult assembly is required.
1. Connect the Handle Top to the Handle Base as shown below.
Please note that once the handle pieces are connected, they
cannot be separated.
2. Attach the Handle Base to the turtle’s body by inserting the Handle
into the slot on the back of the turtle.
6
6
6
3. To remove the Handle, press the two buttons on either side of the
Handle Base and pull out the handle from the back of the turtle.
PRODUCT FEATURES
1. On/Off/Volume Switch
To turn the unit On, slide the On/Off/
Volume Switch to the Low volume
position or the High volume
position. You will hear a song and
a welcoming phrase. To turn the
unit Off, slide the On/Off/Volume
Switch to the Off position.
2. Automatic Shut-Off
To preserve battery life, the 2-in-1 Push & Discover Turtle will
automatically shut off after approximately one minute without
input. The unit can be turned on again by pressing any button or
turning the back wheel.
NOTE
If the unit repeatedly powers down while playing, please install a new
set of batteries.
7
7
7
ACTIVITIES
1. Number Button
Press the Number Button to learn
about numbers and practise counting
with playful phrases and fun sounds.
The lights will flash with the sounds.
2. Music Button
Press the Music Button to hear
playful melodies and songs. The
lights will flash with the sounds.
3. Animal Button
Press the Animal Button to learn
about the turtle and butterfly. The
lights will flash with the sounds.
4. Wheel Sensor
Push or pull the turtle with or without
the handle attached to hear a variety
of fun sounds and short tunes.
Watch the turtle’s head bob and the
butterfly’s wings flap up and down.
The light will flash with the sounds.
8
8
8
MELODY LIST
1. A-Tisket, A-Tasket
2. Alphabet Song
3. Bingo
4. Ride a Cock Horse to Banbury Cross
5. Glow Worm
6. Hey, Diddle, Diddle
7. Skip to My Lou
8. Old MacDonald
9. Pease Porridge Hot
10. Row, Row, Row Your Boat
SONG LIST
Song 1
Let’s go for a stroll in the sun.
Stretch your legs and have some fun!
Little butterfly stretches her wings, too.
We’re ready for a great day exploring with you!
Song 2
One, two, three, four, walk with me,
I want to explore the world with you.
One, two, three, four, walk with me,
We can have fun, you and me!
9
9
9
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Please turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to play again.
5. If the unit still does not work, install a new set of batteries.
10
10
10
Tabla de contenidos
Otros manuales de Juguete de VTech Baby
VTech Baby
VTech Baby My Friend Alice Manual de usuario
VTech Baby
VTech Baby Lights & Stripes Zebra Instrucciones de montaje
VTech Baby
VTech Baby Lullaby Lambs Mobile Instrucciones de montaje
VTech Baby
VTech Baby Soothing Slumbers Sheep Mobile Instrucciones de montaje
VTech Baby
VTech Baby Musical Spin and Play Kitty Manual de usuario
VTech Baby
VTech Baby Twist & Play Cube Manual de usuario
VTech Baby
VTech Baby Farm Fun Storybook Instrucciones de montaje
VTech Baby
VTech Baby Swing & Sing Monkey Instrucciones de montaje
VTech Baby
VTech Baby Twist & Spin Lion Instrucciones de montaje
VTech Baby
VTech Baby 3-in-1 Starry Skies Sheep Soother Manual de usuario
VTech Baby
VTech Baby Rocking, Rolling Cody Manual de usuario
VTech Baby
VTech Baby Snooze & Soothe Elephant Manual de usuario
VTech Baby
VTech Baby Snuggly Sounds Whale Manual de usuario
VTech Baby
VTech Baby Little Singing Cody Manual de usuario
VTech Baby
VTech Baby Baby's First Storytime Rhymes Manual de usuario
VTech Baby
VTech Baby Rattle & Shake Birdie Manual de usuario
VTech Baby
VTech Baby Musical Cuddle Bug Instrucciones de montaje
VTech Baby
VTech Baby Caterpillar Teether Manual de usuario
VTech Baby
VTech Baby Shaking Sounds Tambourine Manual de usuario
VTech Baby
VTech Baby Lights & Stripes Zebra Instrucciones de montaje
