voxicon VXD-P49UWHD Manual de usuario
VXD-P49UWHD
USER MANUAL
1
1. Safety Precautions
2. Maintenance Guidelines
WARNING: Safety Instructions
CAUTION
Do not place the monitor in rain, humid environment or open
the monitor case to avoid any shock, electrical hazards, and/or
mechanical hazards.
Before cleaning the monitor, unplug the monitor power cable from
the electrical outlet.
The terms HDMI and HDMI High-Definition Multimedia Interface, and
the HDMI Logo are trademarks or registered trademarks of HDMI
Licensing Administrator, Inc. in the United States and other countries.
To clean your screen, slightly dampen a soft, clean cloth with water.
If possible, use a special screen-cleaning tissue or solution. Do not
use benzene, thinner, ammonia, abrasive cleaners, or compressed
air.
Use a slightly dampened, warm cloth to clean the frame. Avoid
using detergent of any kind as some detergents might leave a milky
film on the plastics.
Unplug the monitor if you are not going to use it for an extended
period of time.
To avoid the risk of shock or permanent damage to the set, do not
expose the monitor to dust, rain, water, or excessive moisture
environment. If your monitor gets wet, wipe it with dry cloth as soon
as possible.
Keep the monitor out of direct sunlight and away from stoves or
any other heat source.
Keep the monitor out of water source
Remove any object that could fall into ventilation holes or
prevent proper cooling of the monitor's electronics.
Do not block the ventilation holes.
Do not knock or drop the monitor during operation or transportation.
Operation
Caring for Your Monitor
2
3. Box Contents
Monitor x 1
Screws M4*12mm x 4
(for wall mounting)
DP Cable x 1
Stand Stem x 1 Stand Base x 1
Screws CM4*8mm x 3
(for stand installation)
Power Cable x 2
User Manual x 1
length 17mm
length 35mm
Base A
Base B
Screws CM5*12mm x 4
(for stand installation)
VXD-P49UWHD
USER MANUAL
3
4. Product Overview
4.1 —Monitor Buttons
4.2—Monitor Ports
M Menu Button: Press to display the OSD menu or enter sub-menus.
Down Button: Press to move down in the menus.
Up Button: Press to move up in the menus.
E Exit Button: Press to exit.
Power Button: Press to turn the monitor on/off.
HDMI Connectors: Insert one end of the HDMl cable into the computer's
HDMl output and connect the other end to the monitor's HDMI port.
DP Connector: lnsert one end of the DP cable into the computer's DP
output and connect the other end to the monitor's DP port.
Audio Output: Insert the audio cable for output of audio signals.
Power Connector: Insert the power cable to supply power to the monitor.
2
1
3
4
5
7
6
8
9
1 2 3 4 5
2. Lock the base A and the base B with three CM4*8 screws. Then lock the base
assembly and bracket assembly with three CM5*12 screws.
3. Take the whole machine out of the carton and put it in the upper styrofoam, and
put the whole machine upside down.
4. Fasten the assembled base part to the quick-release position of the whole machine,
but be sure to shake the fastened base back and forth twice to see if it is fastened.
base A
base B
CM4*8
Screws x3
Stand Stem
CM5*12
Screws x3
4
5. Stand lnstallation
1. Open the package, remove the product with the foam still attached, and place it
gently on a desk or table.
Bu�on
5
6. Mount lnstallation
This monitor only includes screws which may be used when attaching the
monitor to a VESA 75*75mm type mount. No VESA mount or mounting
accessory is included.
1. Open the carton package, take out the whole machine and Polylon together, as
shown in the figure, place a horizontal table top, use a Phillips screwdriver to
remove the four screws of the rear lock shell first.
5. If you want to remove the base, take off the decorative cover of the rear shell, pull
down the quick release button, and the base can be taken off.
6. Use both hands to place the assembled monitor on a flat desk.
Keep the foam underneath the monitor before attaching the stand.
Remove four M4*8 screws
6
2. Take the hexagonal studs from the accessory bag and lock them on the back shell,
as shown in the figure, two stud locks with a length of 35mm are above and two
stud locks with a length of 17mm are underneath.
3. The assembled product can be wall-mounted. Do not pinch the screen directly with
your hands during the process of hanging the product to prevent the screen from
being broken.
Do not discard the original screws because they may be needed for later use.
Stud length 35mm
Stud length 17mm
Wall bracket
Exposure to loud audio for prolonged periods of time may permanently
damage your hearing.
Plug in your earphones to receive audio signals from your monitor. If you have an
audio device connected toyour computer when you connect your earphones tothe
monitor, the audio devices will not produce sound. Earphones and other audio
devices are not included.
7. Connectivity Options
7.2 – Connecting Your Earphones
7.1 – Connecting the Power Cable
7
Earphones (not included)
Connect the included power cable to the power connector and then plug the other
end into a wall outlet.
Power Cable
7.3 – DP Connectivity
7.4 – HDMI Connectivity
For the monitor to receive DP signals from the computer, use the DP cable to connect
the monitor tothe computer.
8
DP
DP OUTPUT
DP Cable (Included)
For the monitor to receive HDMl signals from the computer, use an HDMl cable to
connect the monitor to the computer.
HDMI Cable (Not Included)
HDMI OUTPUT
PC
Indicator Light
9
8. Basic Operation
9. lndicator Light
1. Insert one end of the DP cable into your PC's graphics card. An HDMl cable may
also be used. HDMI cable is not included.
2. Connect the other end of the cable to the corresponding connector on your monitor.
3. Connect the power cable to your monitor then connect the other end to your power
source. It is recommended that you use a surge protector with adequate voltage if
a wall outlet cannot be reached directly.
4. Locate the power button on the monitor and press it to turn the monitor on.
Solid blue light indicates power is on and the monitor is operating normally. Flashing
blue light indicates no video source, no horizontal or vertical signal has been detected
or power is low.Please ensure your computer is on and all video cables are fully inse-
rted and/or connected.
HDMI Connectors
DP Connectors
Tabla de contenidos
Otros manuales de Monitor de voxicon
