W
A
L
L
Rear view of Voca TC-X Main Unit
07
The supplied water tube will need to be cut in order to
connect each section. Proceed one section at a time and
where needed use the supplied push-in corner adapters.
To connect, simply push the tube in until it is safely
secured. Test the tube steadiness by pulling slightly: it
should not come off. To release the tube, push the
connector’s collet and pull the tube.
When cutting each section please allow the extra lenght
needed to secure the tube inside the connector.
Please follow the instructions below for added details.
Before cutting the water tube, please make sure that each
section is short enough so that they add up to the total
lenght of the tube.
When cutting the tube, please use a precision tool and cut
a straight vertical line to ensure a correct water flow.
Once finished, ensure each section is secure and free from
any leakage.
to attach tube
to release tube
Push-in
connector Water tube
07.1
07.2
Unfasten the nut and attach the water tube to the
T-joint, making sure it is properly connected all the way.
Slide the nut through the tube and gently fasten it back
to secure it. Cut two sections of the tube and connect:
T-joint to pressure regulator, then to filter.
Depending on the location of each component the corner
adapters can be used to assist with the process.
When cutting the water tube, please take into consider-
ation the extra lenght needed to secure the tube inside
each connector.
Gently fasten the nut
to secure the tube
Keep the T-joint valve and
the mains water closed at
all times during installation!
An additional release path between the filter and the
Voca TC-X can be installed. It will allow for filter rinse
and manual filtered water (at original temperature) in
case of power disruptions. Make use of the T-adapter
and the ball valve as instructed.
To avoid leakage and damages, please make sure that the
ball valve is properly functioning when closed.
By leaving this
part for last,
the remaining
part of the
water tube can
be used after
the rest of the
installation is
complete.
Push-in
connector
Water tube
Connecting each section with the water tube
Mains to filter (via pressure regulator)
Adding the additional release path
Note:
Note:
Note:
