Note:
Following each removal of the biosensor from the body it is sufficient
to clean the sensor with mild, ph-neutral soap under running, luke-
warm water. Following this, rinse the biosensor well with clear water
and dry. Please also clean the sensor holder and the cap of the reading
device regularly in the same way.
Service life and storage of biosensor and
medical plastic ring
On the packaging of the biosensor and plastic ring you will find the
packing date and the maximum storage date, which states the date
until which the biosensor and plastic ring may be used.
Medical plastic ring: The plastic ring may remain in the vagina for
a maximum continuous period of 30 days at a time and must be
replaced at the latest after this time. Naturally, you may remove it for
reading and insert it again as often as you like.
Biosensor: The battery life of the biosensor is approximately 6
months. The battery status of your sensor is communicated with each
data upload. If the battery is running low, we will send you a replace-
ment sensor automatically. The booked application time starts on the
day on which the first temperature value is recorded with the sensor,
at the latest 4 weeks after the date of sending of your OvulaRing
package. The internal memory of the biosensor can record data for
up to 3 months. If the memory is full, no new temperature values can
be saved. Therefore, the biosensor should be read out at least every 4
weeks. When the biosensor is not located in the vagina, no tempera-
ture value is recorded. During this time store the biosensor in a dry,
light-protected location in the storage box supplied.
