19
18
10. DURING WELDING MACHINE KEEP TO THE PLACE OF WORK
CARRIED OUT WITHIN 5 METERS OF STRANGERSANDANIMALS.
The welding process is a source of electromagnetic waves, heat,
ultraviolet radiation, and glare. Before welding sure to check the area of
welding works outside people and animals, which can be caused by
trauma. Set-sparking screens.
11. TO REDUCE THE RISK OF VIEW DO NOT WATCH EVEN WITH CLOSE
DISTANCE OF 15 METERS ON WELDING WITHOUT SPECIAL
PROTECTIVE MASKS OR GLASSES WITH TINTED WINDOWS.
Ultraviolet radiation of the arc can cause irreparable damage to the eyes.
You can not carry out welding work and to approach closer than 15 meters
to the place of welding to people who wear contact lenses, eyeglasses,
pacemakers and devices stabilize heart rhythm.
12. KEEP AWAY FROM THE WELDING MACHINE FLAMMABLE
MATERIALS.
During welding operations should not be closer than 15 meters from the
site of welding fuel, engine oil, matches, oily clothes, straw, trash and
other flammable materials. Be careful with the presence of fire
extinguishers.
13. DO NOT COVER WELDING MACHINE IN OPERATION.
The product is equipped with a forced air cooling system, and if it is
covered, the welding machine may overheat.
14. AVOID DIRECT CONTACT WITH THE WELDING CIRCUIT, THE
DISCOVERY OF LIVE PARTS OF THE WELDING MACHINE AND
CABLES, INCLUDING ITS PRODUCTS IN IDLE.
15. DO NOT WELDING INTHE RAIN OR WET HANDS.
Work welding machine in rain or snow can cause electrical shock or
damage to the product. If the welding machine gets wet, before turning it
necessary to wipe dry. Do not pour water on the product, do not wash it.
16. DO NOT LEAVE THE WELDING MACHINE IS UNATTENDED,
DISCONNECT THE SUPPLY PRODUCT IMMEDIATELY AFTER
WELDING.
17. REMEMBER, THE GAS GENERATED DURING THE WELDING
PROCESS - HARMFULTO HUMAN HEALTH.
Carry out welding work outdoors or in a well-ventilated area. Materials
having in its composition lead, cadmium, mercury, zinc and beryllium,
under the influence of the welding arc may release toxic gas in dangerous
to life and health of people and animals concentrations. When welding
these materials be sure to use personal respiratory protection.
18. BEFORE STARTING WELDING MACHINE ON A FLAT, LEVEL
SURFACE.
To avoid turning the product or place it on an uneven, and the vibrating
surface.
19. IF, DURING WELDING OPERATIONS SPARKS GOT INTO THE VENT
WELDING MACHINE, IMMEDIATELY UNPLUG THE PRODUCT FROM
THE WALLAND CONTACTTHE SERVICE CENTER.
20. OPERATION, STORAGE AND TRANSPORTATION OF WELDING
MACHINES, PROTECTS IT FROM THE EFFECTS OF
PRECIPITATION, WATER VAPOR, CORROSIVE FLUIDS,
MECHANICALDAMAGE, SPARKS, MOLTEN METAL, DUSTAND DIRT.
21. DO NOT ATTEMPT TO REPAIR THE UNIT, CONTACT THE SERVICE
CENTER.
All the models of welding machines have passed the required tests for
electromagnetic compatibility and safety, in accordance with the
requirements. However, during welding, these products can influence on
nearby radio-electronic devices and computer control system.
CAUTION!
Always be aware of the fact that, when connected to an
electrical welding machine Electrode with the electrode does
not touch the clip "mass" and the apparatus. Do not use the
power and welding cables, if they have damaged or worn
insulation.
WARNING!
Be sure to monitor the serviceability of the product. In case
of failure, you can smell typical of burning insulation, flame,
sparks, immediately stop the operation of the product and
contact a service center.
