www.vistacnc.com - 5 -
www.vistacnc.com - 5 - P2-S Pendant LinuxCNC Manual v. 1.1
Turn axis selection knob to X, Y, Z, or A position to select an axis to jog.
□Selected axis name. It flashes at ½ second rate.
□Step size and Step jogging rate. The size and rate display changes alternately every 2 seconds.
2. MPG (Manual Pulse Generator) mode selection
2.1 STEP, STEP SIZE and STEP JOG RATE
STEP In STEP mode, the selected axis moves 1 step at each MPG click (detent) with the step
size currently in the system and with speed of step jogging rate.
STEP SIZE While pressing and holding the EN side button , turn MPG one or few clicks
clockwise or counterclockwise to select predefined step size. All step sizes are defined in vc-
p2s.hal file.
STEP JOG RATE While double clicking (press, release, and press, within half a second) and
holding the EN side button , turn MPG to change step jogging rate.
