Quick Installation Guide Vista
4 SmartDisc 10IPRT
1.2 Rear View and Description
Item Labeling/description Function
1 eSATA Connection for a external storage medium (coded hard disk) in accordance
with eSATA standard.
2 V1in - V8 in Optional analogue video input 1-8: BNC sockets for connecting colour or B/W
video. Switching between CCIR/PAL and EIA/NTSC mode is automatic.
Activation via optional HYBRID Card 4, in each case for four inputs (max. two
cards).
3 V1 out - V8 out Optional analogue video output 1-8: Active loop through outputs - BNC
sockets - for direct connection of additional video systems/monitors.
Activation via optional HYBRID Card 4, in each case for four inputs (max. two
cards).
4 34 pin terminal block Terminal block with screw type terminals: Terminals for power supply, PTZ
control interfaces, control inputs, relay outputs, loudspeakers.
5 Transp. data/ Control
interface
9 pin sub D plug: Transparent serial multifunction data interface (RS-232), e.g.
for the ALM50R alarm/relay module.
6 Ethernet Socket RJ-45: Ethernet interface (10/100 MBit/s)
primarily provided as the interface to the evaluation network
IP address on delivery or following a device reset: 192.168.31.95
7 IP Camera Socket RJ-45: Ethernet interface (10/100/1000 MBit/s)
primarily provided as the interface to the network of IP cameras
IP address on delivery or following a device reset: 192.168.32.95
8 M4 thread for earthing the video system.
9 ISDN Socket RJ-45: ISDN interface (S0 bus) for optional ISDN Card or PSTN
interface (analogue modem) for optional PSTN Card
Activation via optional ISDN Card or PSTN Card.
10 Mic Jack socket: Direct connection of an Electret or of an electrostatic microphone
11 Line in Jack socket: Direct connection of an audio source with line level output
12 Line out Jack socket: Direct connection of an audio source with line level input
