Caution: 1. When the GPS connection (reception) occurs, the green LED will blink during the operation, instead of the red LED.
When the is disconnected red LED will blink during the operation, instead of the green LED.
6. Functions and Buttons
Buttons Operation Status LED indications Buzzer
- Switch on. System preparation The yellow and led LEDs are turned on. They will be
turned off when the booting process ends. Long beep
- Switch off. The file that is being currently recorded ends safely
after the power is turned off. The yellow and red LEDs will stay turned on until they
are turned off at the time of ending. -
- Entering the GPS data. GPS operation The green LED will blink. -
Wi-Fi
Formatting the SD card (only possible in
the continuous recording mode). Formatting the SD card after rebooting the system The green, yellow and blue LEDs will blink alternately. Long beep when starting, which
will be repeated 3 times
Audio recording ON/OFF
Audio recording ON The red LED will blink slowly (every 1 second).
Audio recording OFF The red LED will blink normally (every 3 seconds).
- Updating.
When successfully updating through the SD card. The yellow and red LEDs will blink alternately. When
the updating process ends, the system will be
rebooted for operation.
Short beep, beep when starting
Short beep, beep when ending
When failing to update through the SD card.
The yellow and red LEDs will be turned off after
waiting while staying turned on. The system will be
rebooted for operation.
Short beep, beep, beep, beep
when failing, which will be
repeated 3 times
Buttons Operation State LED indications Buzzer
Continuous recording
