VIS-A-VIS VITALINQ 94A-07 Manual de referencia
An Introduction and Training Module
Model 94A-07
Vitalinq Introduction
vVis-A-Vis (pronounced “vee-sah-vee”) established in
1986
vIntercom and music system designed for cath lab
environment
vIn production since 1986
vMost units remain in service
vCurrent model is 94A-07
vIn addition to Cath Labs, successfully used in:
üElectrophysiology labs
üInterventional Radiology Lab
üHybrid Operating Rooms
Communication -Physician
vProvides continuous two-way communication (no voice
switching) between physician in procedure room and
control room operator
vAllows control room operator to respond immediately to
physician's requests
vThe Physician:
üWears no device
üSpeaks in normal tone
üVoice picked up by microphone mounted to monitor
üHears control room technician through speaker mounted
overhead in ceiling
Communication -Operator
vControl room Operator can speak using a headset or
desk microphone
vWhen using headset, a foot switch must be depressed
before speaking
vWhen using desk mic, operator hears through speaker
mounted overhead in ceiling
vCommunication speaker in control room can be turned
off if desired
vAll adjustments made at console in control room
Music
vStereo integrated into console
vProvides music playback in either or both rooms
vMusic can be from a variety of sources:
üAny device that can connect to USB or Aux-in
(iPhone, iPod, iPad, Android, USB flash drive)
üCompact disc
üRadio (subject to strength/environmental shielding)
vIndependent volume adjustment for each room using
fade
Included in the 94A-07 system
vVitalinq Console with integrated stereo
v2 Communication Speakers (1 for each room)
v4 stereo speakers (2 for each room)
vDesk microphone
vHeadset with mute switch
vMonitor Microphone (for procedure room)
vEthernet cables in various lengths, pre-terminated, color coded
vMonitor Mic adaptor box, splitters, and couplers
vSpeaker bridge plates
vInstallation and Operations Manual
Optional Equipment
MC-07 Remote Console
vAllows additional headset and/or desk mic connection
vConnects to 94A-07 console using Ethernet cable
vCan be placed across control room or in separate room
Wireless Headset
vCan be used to replace corded headset or
vTwo can be connected in addition to corded headset allowing:
üTwo-way communication between each other
üTwo-way communication to corded headset
üWill not communicate with procedure room
Call for details on optional equipment.
The Console
Dimensions
8.5”x4.5”x8.5”
Installation
v6 speakers total –2 stereo and
1 communication for each room
vEach speaker has two Ethernet connectors allowing them
to be “daisy-chained” together using Ethernet cables
vEach speaker is labeled and pre-configured for its
location
vSpeakers secure through 6-9/16”hole in ceiling using
integral dogs which swing into place
Installation
vOnly 2 to 3 cables need to be routed from console
ØBlue Ethernet cable to control room speakers plugs into “TEK BLUE”jack on
rear of console
ØWhite Ethernet cable to procedure room speakers plugs into “LAB White”jack
on rear of console
ØProcedure room mic cable either
üdaisy chains to procedure room speaker
üor is connected directly to console with coaxial or Ethernet cable
vConsole placed on desk in control room
vPlugs into any 110VAC/60Hz outlet
vHeadset plugs into one of two headset jacks on front of console
vDesk mic plugs into other aux jack on rear of console
Otros manuales para VITALINQ 94A-07
1
Tabla de contenidos
