Viglen Vig750s Manual técnico

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

BIOS Update Instruction for the Vig750s Motherboard

PMPAS750-Vig750s

Before initiating a BIOS update, be sure to read and precisely follow the instructions included in

this document.

If a BIOS update process is interrupted or the incorrect BIOS is flashed, your system may not

function properly and can possibly damage the motherboard.

Before updating the BIOS on the Viglen Desktop Board, manually record all BIOS settings that have

been changed (from default) so they can be restored after completing the BIOS update

There are up to four methods of updating BIOS to the latest Viglen approved version.

The number of options made available for any particular board may vary depending on BIOS

Support, drive support and BIOS update file size. You only need to use one.

•EZ-Flash 3 Update

•Recovering the BIOS - CrashFree BIOS 3 (recover corrupted BIOS)

•Windows\WinPE BIOS Update

•Express BIOS update

Latest BIOS files and Utility are available from Viglen FTP site:

http://download.viglen.co.uk/files/Motherboards/Vig750s

BIOS Update Instructions using EZ-Flash Method:

For this method, you will require a Flash USB device and required BIOS file.

1. Insert the USB flash disk that contains the latest BIOS file to the USB port.

2. Select <Del> or <F2> to Load BIOS Setup.

3. Enter the Advanced Mode (F7) of the BIOS setup program. Go to the Tool menu to select ASUS EZ

Flash Utility and press <Enter> to enable it.

Figure 1 –ASUS EZ Flash 3 Utility

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

4. Press the Up/Down arrow keys to find the USB flash disk that contains the latest BIOS, and then

press <Enter>.

5. Select the correct BIOS file, and then press <Enter> to perform the BIOS update process.

Figure 2

6. Reboot the system when the update process is completed.

7. After restarting load BIOS setup menu by pressing < Del> or <F2> key.

8. Load Default BIOS settings by pressing <F5> key.

9. Press F10 to Save and Exit.

Note:

• This function supports USB flash disks formatted using FAT32/16 on a single partition only.

• Ensure to load the BIOS default settings to ensure system compatibility and stability. Select the

Load Optimized Defaults item under the Exit menu.

IMPORTANT!!!!!

During the update process DO NOT shut down the PC or interrupt the process, this could cause

damage to the motherboard.

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

Recovering the BIOS - CrashFree BIOS 3

The CrashFree BIOS 3 is an auto recovery tool that allows you to restore the BIOS when it fails or gets

corrupted during the updating process. You can restore a corrupted BIOS file using the motherboard

support DVD or a USB flash drive that contains the updated BIOS file.

Before using this utility, rename the BIOS file in the removable device into

H110TP.CAP

To recover the BIOS:

1. Turn on the system.

2. Insert the support DVD to the optical drive or the USB flash drive that contains the BIOS file to

the USB port.

3. The utility automatically checks the devices for the BIOS file. When found, the utility reads the

BIOS file and enters ASUS EZ Flash 3 utility automatically.

4. The system requires you to enter BIOS Setup to recover BIOS settings. To ensure system

compatibility and stability, we recommend that you press <F5> to load default BIOS values.

DO NOT shut down or reset the system while updating the BIOS! Doing so can cause system

to fail!

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

Windows\WinPE BIOS Update

Windows

1. Save the BIOS update file to a temporary directory.

2. Extract necessary files.

3. Open Commend Prompt

a. Type ‘CMD’ under Search.

b. Run Commend Prompt as Administrator

4. In commend prompt navigate to the extracted BIOS folder. (i.e. Vig700S_BIOS_0708_64 bits)

Figure 3

5. At the prompt, type update to launch the BIOS updates process.

During BIOS update process if pop message appears select OK to continue.

Figure 4

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

6. BIOS update process will start.

CAUTION!!! DO NOT POWER DOWN YOUR SYSTEM before the update is completed.

Figure 5

7. Once BIOS update is completed, pop up message will appear “Windows will shut down in less

than a minute”.

System will log off and restart after one minute.

8. During system re-boot, load BIOS setup menu by pressing < Del> or <F2> key.

9. Load Default BIOS settings by pressing <F5> key.

10. Press <F10> to save and exit.

Latest BIOS files and Utility are available from Viglen FTP site:

http://download.viglen.co.uk/files/Motherboards/Vig730S/

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

BIOS settings for Windows 7 and Windows 10 O/S

Windows UEFI mode for Windows 8.1/10

Vig830s system configured with Windows 8/8.1 will have following default BIOS settings. If

you wish to downgrade to Windows 7 then BIOS must be configured to Non-UEFI mode.

Boot\CSM (Compatibility Support module)

Launch CSM [Enabled]

Boot Device Control [UEFI Only]

Boot from Network Devices [UEFI drivers first]

Boot from Storage Devices [UEFI drivers first]

Boot from PCI-E/PCI Expansion Devices [UEFI drivers first]

Boot\Secure Boot Menu

OS Type [Windows UEFI mode]

Note

Please ensure the changes of the following settings are performed by personnel with some previous

experience/knowledge of altering BIOS settings.

Enabling Windows UEFI mode for Windows 8/8.1 & 10 Operating System

1. From the BIOS main menu bar select ‘Advanced’

2. Navigate to the Boot sub menu

3. Select CSM (Compatibility Support Module)

Figure 6

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

4. In the CSM (Compatibility Support Module) change following settings for Windows 8/8.1

& 10

Launch CSM [Enabled]

Boot Device Control [UEFI Only]

Boot from Network Devices [UEFI drivers first]

Boot from Storage Devices [UEFI drivers first]

Boot from PCI-E/PCI Expansion Devices [UEFI drivers first]

Figure 7-Compatibility Support Module

When these settings have been changed, press <Esc> or the Back Button to go back to

the Boot Sub Menu to enable Windows UEFI for secure boot.

5. Navigate to Secure Boot from within the Boot sub menu.

6. Change OS Type to Windows UEFI.

Figure 8-Secure Boot Menu

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

7. Select Key Management.

8. Select Install default Secure Boot keys and select Yes to proceed.

Figure 9-Key Management

9. Press F10 to Save and exit.

If you need to check changes have been saved go back into BIOS after reboot and navigate

into Secure Boot settings. Check that Secure Boot state is enabled and Platform Key (PK)

state is Loaded.

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

Figure 10- Key management –Key loaded

XMA Limited, VHQ, 7 Handley Page Way, Old Parkbury Lane, Colney Street, St. Albans, Hertfordshire AL2 2DQ

Tel: 01727 201 850 | Fax: 01727 201858 | Email: [email protected]| Web: www.xma.co.uk

BIOS Settings for Windows 7 Operating System (Non UEFI Mode)

To downgrade to Windows 7 operating system, BIOS settings must be changed to boot into

Legacy BIOS mode (non UEFI Mode).

For Windows 7 operating system BIOS should be configured as per below settings

Boot\CSM (Compatibility Support module)

Launch CSM [Enabled]

Boot Device Control [UEFI and Legacy OPROM first]

Boot from Network Devices [Legacy OPROM]

Boot from Storage Devices [Legacy OPROM]

Boot from PCI-E/PCI Expansion Devices [Legacy OPROM]

Figure 11 -Windows 7 BIOS settings

Boot\Secure Boot Menu

OS Type [Other OS]

Figure 12 Windows 7 BIOS settings

Tabla de contenidos

Otros manuales de Placa madre de Viglen

Viglen

Viglen Vig850G Manual de usuario

Viglen

Viglen Intel D955XBK Manual de usuario

Viglen

Viglen Vig770S Manual de usuario

Viglen

Viglen D865GLC Manual de usuario

Viglen

Viglen Intel D925XECV2 Manual de usuario

Viglen

Viglen Vig395p Manual de usuario

Viglen

Viglen VIG615M Manual de usuario

Viglen

Viglen CX135 Manual de usuario

Viglen

Viglen Vig451J Manual de usuario

Viglen

Viglen Vig644M Manual de usuario

Viglen

Viglen Vig870G Manual de usuario

Viglen

Viglen VIG590M Manual de usuario

Viglen

Viglen Vig660W Manual de usuario

Viglen

Viglen Vig565s Manual de usuario

Viglen

Viglen Motherboard Vig390s Manual de usuario

Viglen

Viglen D915GHA Manual de usuario

Viglen

Viglen D925XCV Manual de usuario

Viglen

Viglen Vig680M Manual de usuario

Viglen

Viglen Vig535b Manual de usuario

Viglen

Viglen L440GX+ Manual de usuario

Viglen

Viglen Vig655M Manual de usuario

Viglen

Viglen vig830s Manual de usuario

Viglen

Viglen Vig550B Manual de usuario

Viglen

Viglen Vig760S Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario