ViewSonic VFA710w Manual de usuario
ViewSonicTM
VFA710w
Digital Photo Frame
Model No.: VS12557
- User Guide
- Guide de l’utilisateur
- Guía del usuario
IMPORTANT: Please read this User Guide to obtain important
information on installing and using your product in a safe
manner, as well as registering your product for future service.
Warranty information contained in this User Guide will describe
your limited coverage from ViewSonic Corporation, which is also
found on our web site at http://www.viewsonic.com in English,
or in specic languages using the Regional selection box in the
upper right corner of our website.
“Antes de operar su equipo lea cuidadosamente las instrucciones
en este manual”
ViewSonic VFA710w
Compliance Information
FCC Statement
This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: You are cautioned that changes or modications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
For Canada
• This Class B digital apparatus complies with Canadian ICES-003.
• Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Following information is only for EU-member states:
The mark is in compliance with the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE).
The mark indicates the requirement NOT to dispose the equipment including any spent or discarded batteries or accumulators as unsorted
municipal waste, but use the return and collection systems available.
If the batteries, accumulators and button cells included with this equipment, display the chemical symbol Hg, Cd, or Pb, then it means that
the battery has a heavy metal content of more than 0.0005% Mercury or more than, 0.002% Cadmium, or more than 0.004% Lead.
i
ViewSonic VFA710w
ENGLISH
Important Safety Instructions
1. Do not use the equipment near water.
2. Wipe the machine with a soft and dry cloth.
3. Do not block any vent holes. Please install the product in accordance with the manufacturer’s instructions.
4. Do not use the product on your legs for a long time because it gets hot and you may be burned.
5. Please avoid installing the product in a place where the temperature is above 35°C or lower than 5°C, or in a place that is moist or wet.
6. Protect the power cord plug, outlet, and connections to other equipment from damage by trapping and squeezing.
7. Please only use devices and accessories specied by the manufacturer.
8. The unit is hot pluggable. However it is recommended that the power be turned off before the memory card is inserted or removed.
9. Do not remove the memory card during data access. The data may be lost and the product could be damaged.
10. Disconnect the power cord if the product will not be used for an extended period.
11. Do not repair, disassemble, or modify the product. Only qualied ViewSonic personnel can check and repair any damage to the machine.
12. The unauthorized playing of certain audio or image les may infringe the related copyright laws under certain circumstances.
13. When you use the internal speakers, do not adjust the volume to a high level, or the sounds may distort and become unpleasant.
14. When you view pictures for an extended period of time your eyes may become strained.
15. Do not touch the screen because it is difcult to remove nger marks.
16. Avoid exposing the digital photo frame to direct sunlight. Adjust the angle to reduce glare.
17. Careful attention should always be paid when moving the digital photo frame.
18. Make sure the place where the digital photo frame is placed is clean and dry.
19. If there is smoke, a strange smell or an abnormal noise, immediately turn off the digital photo frame and contact your dealer or ViewSonic.
20. Do not rub or apply pressure to the LCD panel. This may cause irreparable damage to the screen.
ii
ViewSonic VFA710w
Declaration of RoHS Compliance
This product has been designed and manufactured in compliance with Directive 2002/95/EC of the European Parliament and the
Council on restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS Directive) and is deemed
to comply with the maximum concentration values issued by the European Technical Adaptation Committee (TAC) as shown below:
Substance Proposed Maximum Concentration Actual Concentration
Lead (Pb) 0.1% < 0.1%
Mercury (Hg) 0.1% < 0.1%
Cadmium (Cd) 0.01% < 0.01%
Hexavalent Chromium (Cr6+) 0.1% < 0.1%
Polybrominated biphenyls (PBB) 0.1% < 0.1%
Polybrominated diphenyl ethers (PBDE) 0.1% < 0.1%
Certain components of products as stated above are exempted under the Annex of the RoHS Directives as noted below:
Examples of exempted components are:
1. Mercury in compact uorescent lamps not exceeding 5 mg per lamp and in other lamps not specically mentioned in the Annex of
RoHS Directive.
2. Lead in glass of cathode ray tubes, electronic components, uorescent tubes, and electronic ceramic parts (e.g. piezoelectronic devices).
3. Lead in high temperature type solders (i.e. lead-based alloys containing 85% by weight or more lead).
4. Lead as an allotting element in steel containing up to 0.35% lead by weight, aluminium containing up to 0.4% lead by weight and as a
cooper alloy containing up to 4% lead by weight.
iii
ViewSonic VFA710w
ENGLISH
Copyright Information
Copyright©ViewSonic Corporation, 2010. All rights reserved.
ViewSonic, the three birds logo, OnView, ViewMatch, and ViewMeter are registered trademarks of ViewSonic Corporation.
Disclaimer:ViewSonic Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental
or consequential damages resulting from furnishing this material, or the performance or use of this product.
In the interest of continuing product improvement, ViewSonic Corporation reserves the right to change product specications without
notice. Information in this document may change without notice.
No part of this document may be copied, reproduced, or transmitted by any means, for any purpose without prior written permission
from ViewSonic Corporation.
For Your Records
Product Name:
Model Number:
Document Number:
Serial Number:
Purchase Date:
VFA710w-10
ViewSonic Digital Photo Frame
VS12557-1M
VFA710w-10_UG_ENG Rev. 1C 04-09-10
__________________________________
__________________________________
Product disposal at end of product life
ViewSonic is concerned about the preservation of our environment. Please dispose of this product properly at the end of its useful life.
Your local waste disposal company may provide information about proper disposal.
ix
TABLE OF CONTENTS
Introduction.............................................................................................................................................................................................1
Main Features .........................................................................................................................................................................................2
Overview..................................................................................................................................................................................................3
Attaching the mount .............................................................................................................................................................................4
Connecting to the power ......................................................................................................................................................................5
Inserting Media.....................................................................................................................................................................................6
Viewing Photos.......................................................................................................................................................................................7
Main menu............................................................................................................................................................................................7
Playing a slideshow..............................................................................................................................................................................8
Using the OSD menu ...........................................................................................................................................................................9
Viewing thumbnails ............................................................................................................................................................................10
Changing Frame Settings....................................................................................................................................................................11
Setting items.......................................................................................................................................................................................12
Frequently Asked Questions...............................................................................................................................................................13
Specification .........................................................................................................................................................................................15
ViewSonic VFA710w
x
1
Introduction
Thank you for purchasing this Digital Photo Frame.
This Digital Photo Frame is compatible with SD, MMC, and MS memory card formats, which enables you to view digital
photo directly from your camera’s memory card.
This manual contains important safety information and operation instructions, so please read all the instructions carefully
before using the Digital Photo Frame and keeps it for future reference.
We have done our best to produce a complete and accurate manual; however, we cannot ensure
there are no errors or omissions. We also have no responsibility for damages or loss of data caused
by improper operation.
The instruction manual is subject to change for improvement without notice.
Trademarks and trade names used in this user’s manual are owned by their respective companies
or organizations.
ViewSonic VFA710w
2
Main Features
y7 inch Analog LCD: 480*234 16:9
yDecorative appearance, good quality
yDisplays digital photos (JPEG) without a computer
yAutomatic slide show with multiple transition effects
yCompatible with SD/MMC/MS memory cards
yUSB Host for connecting to the USB mass storage
ViewSonic VFA710w
3
Overview
• Front View • Back and Side View
1. Front View
2. SD/MMC/MS-card slot
3. USB HOST
4. 5V DC Input socket
5. [g] Right/Next button
6. [X] Play/Pause; Confirm/Enter; hold to enter main menu
7. [i] Up button; Back to preview while playing a slideshow
8. [h] Previous/Left button
9. [j] Down button; Rotate photo while playing a slideshow
10. On/Off switch
11. Adjustable mounting
ViewSonic VFA710w
4
Attaching the mount
1. Place the frame on a flat surface with its back facing you.
2. Place the mount carefully in the slot on the back of the frame.
3. Turn the mount counter-clockwise by 45° until it locks. It will now be possible to set the device in the landscape
orientation.
4. Turn the mount counter-clockwise by 90° until it locks. It will now be possible to set the device in the portrait orientation
5. After the mount has been attached, you can adjust the height of the mount by pushing the mount gradually to the
required alignment.
ViewSonic VFA710w
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Marco de fotos digital de ViewSonic
ViewSonic
ViewSonic VFD1027w-11 Manual de usuario
ViewSonic
ViewSonic VFA713W-10 Manual de usuario
ViewSonic
ViewSonic DPG807BK - Digital Photo Frame Manual de usuario
ViewSonic
ViewSonic VFP838-11 Manual de usuario
ViewSonic
ViewSonic VFM886-50E Manual de usuario
ViewSonic
ViewSonic VFD1078W-11E Manual de usuario
ViewSonic
ViewSonic VS13471 Manual de usuario
ViewSonic
ViewSonic DPG807BK-51P Manual de usuario
ViewSonic
ViewSonic DPA709WD Manual de usuario
ViewSonic
ViewSonic DPG807BK - Digital Photo Frame Manual de usuario
ViewSonic
ViewSonic DF88W-523 Manual de usuario
ViewSonic
ViewSonic VFD820-70 Manual de usuario
ViewSonic
ViewSonic VFM735w-51P VS12403 Manual de usuario
ViewSonic
ViewSonic VFD1028w-11 Manual de usuario
ViewSonic
ViewSonic VFM620w-70 Manual de usuario
ViewSonic
ViewSonic DP701W4WH Manual de usuario
ViewSonic
ViewSonic VFD875 Manual de usuario
ViewSonic
ViewSonic DPX704WH Manual de usuario
ViewSonic
ViewSonic DF87G Manual de usuario
ViewSonic
ViewSonic VFA721w-50 Manual de usuario
