Viavi Certifier40G Manual de usuario
CERTIFIER40G
Fiber Certification Testing
User Manual
Certifier Series (C40G)
Notices
No part of this manual may be reproduced in any form or by any means (including electronic storage
and retrieval or translation into a foreign language) without prior agreement and written consent from
Viavi Solutions as governed by international copyright Laws.
Warranty
The material contained in this document is provided “as is,” and is subject to being changed, without
notice, in future editions. Further, to the maximum extent permitted by applicable law, disclaims
all warranties, either express or implied, with regard to this manual and any information contained
herein, including but not limited to the implied warranties of merchantability and fitness for a
particular purpose. Viavi Solutions shall not be liable for errors or for incidental or consequential
damages in connection with the furnishing, use, or performance of this document or of any
information contained herein. Should Viavi Solutions and the user have a separate written
agreement with warranty terms covering the material in this document that conflict with these
Terms, the warranty terms in the separate agreement shall control.
WARNING
A CAUTION notice denotes a hazard.
It calls attention to an operating procedure, practice, or the like that, if not correctly
performed or adhered to, could result in damage to the product or loss of important
data. Do not proceed beyond a CAUTION notice until the indicated conditions are
fully understood and met.
CAUTION
Operating procedure, practice, if not correctly performed or adhered to, could result
in personal injury or death. Do not proceed beyond a WARNING notice until the
indicated conditions are fully understood and met.
General Safety Information
WARNING
Do not use the device if it is damaged. Before you use the device, inspect the casing. Look for cracks
or missing plastic. Do not operate the device around explosive gas, vapor, or dust.
Always use the device with the cables provided.
Observe all markings on the device before establishing any connection.
When servicing the device, use only the specified replacement parts.
Do not operate the device with the cover removed or loosened.
Use only the power adapter provided by the manufacturer to avoid any unexpected hazards.
CAUTION
If the device is used in a manner not specified by the manufacturer, the device protection may be
impaired.
Always use dry cloth to clean the device. Do not use ethyl alcohol or any other volatile liquid to clean
the device.
Do not permit any blockage of the ventilation holes of the device.
Environmental Conditions
This instrument is designed for indoor use and in an area with low condensation. The table below
shows the general environmental requirements for this instrument
Environmental conditions Requirements
Operating Temperature 0 °C to 40 °C
Operating humidity 20% to 85% RH non-condensing
Relative humidity 10% to 80%
NOTE
The CERTIFIER40G, CERTIFIER10G complies with the following Safety and Regulatory requirements.
DIN EN 55024, Edition:2003-10 (IEC/CISPR 24:1997, modified + A1:2001 + A2:2002); EN 55024:1998 +
A1:2001 + A2:2003
DIN EN 55022; VDE 0878-22:2008-05 (IEC/CISPR 22:2005, modified + A1:2005); EN 55022:2006 +
A1:2007
Regulatory Markings
The CE mark is a registered trademark of the
European Community. This CE mark shows
that the product complies with all the
relevant European Legal Directives.
Manufacturer‘s Name
Psiber Data Pte. Ltd
Manufacturer’s Address
3 Science Park Drive #03-08,
The Franklin Singapore Science Park 1,
Singapore 118223
Declares under sole responsibility that the product as originally delivered
Description
Cable Certification Tester Kit
Equipment
Cable Certifier
Complies with the essential requirements of the following applicable European Directives and
carries the CE marking accordingly:
DIN EN 55024, Edition:2003-10 (IEC/CISPR 24:1997, modified + A1:2001 + A2:2002); EN
55024:1998 + A1:2001 + A2:2003
DIN EN 55022;
VDE 0878-22:2008-05 (IEC/CISPR 22:2005, modified + A1:2005);
EN 55022:2006 + A1:2007
Signature
Arvind C Patel
Quality Management
Psiber Data Pte. Ltd.
www.psiberdata.com
Date :
December 14, 2010
Declaration of Conformity
Contents
Chapter 1: Getting Started ..................................................................................................................8
Unpacking the box
....................................................................................................................... 8
Chapter 2: Configuring Certifier.......................................................................................................10
Certifier User Interface
................................................................................................................ 10
Touch Screen Layout.............................................................................................................. 10
The One Touch Access Buttons ............................................................................................... 12
Chapter 3: Setting Reference............................................................................................................21
Chapter 4: Configuring an AUTOTEST............................................................................................30
Testing Guide for Dual-Ended Testing ...................................................................................... 31
Testing Guide for Single-Ended Loopback Testing...................................................................... 32
Chapter 5: Performing an AUTOTEST .............................................................................................34
Managing test result(s) .......................................................................................................... 35
Exporting test results into J-Report PC Software........................................................................ 36
1
Chapter 1: Getting Started
Unpacking the box
Single Mode Fiber
Single Mode Adapters
SC-SC Duplex Reference Cords
Mating Coupler
Multi Mode Fiber
Multi Mode Adapters
SC-SC Duplex Reference Cords
Mating Coupler
Encircled Flux Compliant Multi Mode Fiber
EF Compliant MM Adapters
FC-SC Modally Transparent
Reference Cords SC-SC Tail
Cords
Mating Coupler
Optional SM/MM/MMEF LC Cord Kits available.
2
Chapter 2: Configuring Certifier
Certifier User Interface
Touch Screen Layout
The Graphical User Interface (GUI) in version 7.0’s firmware has been updated with a more
responsive system and quick-access menus.
Certifier boots up to the SETUP screen. It is categorised into 5 groups:
1. Status bar
2. Configuration group
3. Test Settings group
4. Project Settings group
5. System Settings group
Tabla de contenidos
Otros manuales de Equipo de prueba de Viavi
Viavi
Viavi MTS 2000 Manual de usuario
Viavi
Viavi COSA-4055 Manual de lista de piezas
Viavi
Viavi T-BERD/MTS-5800 Manual de lista de piezas
Viavi
Viavi T-BERD MTS 5800 Manual de lista de piezas
Viavi
Viavi HST-3000 Manual de lista de piezas
Viavi
Viavi 3900 Series Manual del propietario
Viavi
Viavi SmartClass FBP-OLP-82 Manual de usuario
Viavi
Viavi CT-X Manual de usuario
Viavi
Viavi T-BERD 5800 Manual de usuario
Viavi
Viavi OLP-88 Manual de usuario
Viavi
Viavi T-BERD/MTS-5800 Manual de lista de piezas
Viavi
Viavi T-BERD MTS 5800 Manual de lista de piezas
Viavi
Viavi AVX-10K Manual de usuario
Viavi
Viavi SmartClass Fiber OLS-85 Manual de usuario
Viavi
Viavi OneExpert CATV Manual de usuario
Viavi
Viavi SmartClass Fiber MPOLx Manual de lista de piezas
Viavi
Viavi E4100 Series Manual de lista de piezas
Viavi
Viavi ALT-9000 Manual de usuario
Viavi
Viavi T-BERD 5800 Manual de lista de piezas
Viavi
Viavi OCC-4056 Manual de lista de piezas
Manuales populares de Equipo de prueba de otras marcas
SMART
SMART KANAAD SBT XTREME 3G Series Manual de usuario
Agilent Technologies
Agilent Technologies BERT Serial Manual de usuario
Agilent Technologies
Agilent Technologies N3280A Manual de usuario
Vernier
Vernier Go Direct Voltage Manual de usuario
Lifeloc
Lifeloc R.A.D.A.R. Manual de usuario
Fluke
Fluke T5-600 Instrucciones de funcionamiento e instalación
