Verona Prestige VPFSEE365SS Manual de usuario
ELECTRIC RANGE
for residential use only
Models: VPFSEE365..
INSTALLATION INSTRUCTIONS
IMPORTANT - PLEASE READ AND FOLLOW
• Before beginning, please read these instructions completely and carefully.
• Do not remove permanently axed labels, warnings, or plates from the product. This may
void the warranty.
• Please observe all local and national codes and ordinances.
• Please ensure that this product is properly grounded.
• The installer should leave these instructions with the consumer who should retain
for local inspector’s use and for future reference.
Electrical installation must be in accordance with the National Electrical Code, ANSI/NFPA70
- latest edition and/or local codes.
IN CANADA: Electrical installation must be in accordance with the current CSA C22.1
Canadian Electrical Codes Part 1 and/or local codes.
R
FOR INSTALLER ONLY
THIS RANGE IS FOR RESIDENTIAL USE ONLY
Some models are supplied with a protective lm on steel and aluminium
parts. This lm must be removed before installing/using the appliance.
22
33
This appliance is designed and manufactured solely for the cooking of domestic (household)
food and in not suitable for any none domestic application and therefore should not be used in a
commercial environmement.
The appliance warranty will be void if the appliance is used within a none domestic environmement
i.e. a semi commercial, commercial or communal environment.
WARNING
- Slide range back so bolt head, on the adjustable bracket assembly, is
-under anti-tip bracket.
- Look for the anti-tip bracket securely attached to oor or wall.
- See installation instructions for details.
- Look for the adjustable bracket assembly securely attached to
-the back of the range.
- Slide range forward.
To verify the anti-tip bracket is installed and engaged:
Tip-Over Hazard
Anti-tip bracket
Adjustable bracket
assembly to be xed to
the back of the range
A child or adult can tip the range and be killed.
Install anti-tip device to range and/or structure per installation
instructions.
Engage the range to the anti-tip device Installed to the structure.
Re-engage anti-tip device if range is moved.
Failure to follow these instructions can result in death or serious
burns to children and adults.
WARNING: This product can expose you to chemicals including
formaldehyde, which is known to the State of California to cause cancer,
and lead, which is known to the State of California to cause birth defects or other
reproductive harm. For more information go to www. P65Warnings.ca.gov.
44
Screwdriver
Tape
measurePencil
Adjustable
pliers
Adjustable
wrench
Suitable protective
gloves Drill
Hammer
INSTALLATION INSTRUCTIONS
WARNING!
THIS APPLIANCE MUST BE INSTALLED BY A QUALIFIED INSTALLER.
Installation must conform with local codes.
Improper installation, adjustment, alteration, services, or maintenance can cause injury or property damage. Consult a
qualied installer or a service agent.
TOOLS NEEDED FOR INSTALLATION (NOT SUPPLIED WITH THE APPLIANCE)
IMPORTANT: The use of suitable protective clothing/gloves is
recommended when handling, installing of this appliance.
55
GENERAL INFORMATION
1. WARNING!!
This appliance shall not be used for space heating. This
information is based on safety considerations.
2. AlI openings in the wall behind the appliance and in the oor
under the appliance shall be sealed.
3. Keep appliance area clear and free from combustible
materials, gasoline, and other ammable vapors.
4. Do not obstruct the ow of ventilation air.
5. Disconnect the electrical supply to the appliance before
servicing.
6. When removing appliance for cleaning and/or service;
A. Disconnect AC power supply.
B. Carefully remove the range by pulling outward.
CAUTION: Range is heavy; use care in handling.
7. Electrical Requirement
Electrical installation should comply with national and local
codes.
8. The misuse of oven door (e.g. stepping, sitting, or leaning on
them) can result in potential hazards and/or injuries.
9. When installing or removing the range for service, a rolling lift
jack should be used. Do not push against any of the edges of
the range in an attempt to slide it into or out of the installation.
Pushing or pulling a range (rather than using a lift jack) also
increases the possibility of bending the leg spindles or the
internal coupling connectors.
WARNING!!
ELECTRICAL GROUNDING INSTRUCTIONS
The range must be electrically grounded in accordance with
local codes or, in the absence of local codes, with the National
Electrical Code, ANSI/NFPA No. 70-latest edition, in Canada
Canadian Electrical Code. Installation should be made by a
Iicensed electrician.
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
If an external electrical source is utilized, the installation must
be electrically grounded in accordance with local codes or, in
the absence of local codes, with the national Electrical Code,
ANSI/NFPA 70.
REPLACEMENT PARTS
Only authorized replacement parts may be used in performing
service on the range. Replacement parts are available from factory
authorized parts distributors. Contact the nearest parts distributor
in your area.
66
PROXIMITY TO SIDE CABINETS
1. This range may be installed directly adjacent to existing 36”
(914 mm) high base cabinets.
Range dimensions:
• width: 35” 7/8 (911 mm)
• depth: 23” 31/32 (609 mm)
• height (without backguard): MIN 36” (914 mm) MAX 37”
13/32 (950 mm)
• backguard (height): 8” (203 mm) or 3" (76 mm)
Grounded outlet: should be located from the left to the right
side of the range; from 6” 11/16 (170 mm) to 8” 21/32 (220
mm) [depending on feet regulation] from the floor.
Fig. 1.1a
Fig. 1.1b
2. The range CANNOT be installed directly adjacent to sidewalls,
tall cabinets, tall appliances, or other side vertical surfaces
above 36” (914 mm) high.
There must be a minimum of 2” (50 mm) side clearance from
the range to such combustible surfaces TO THE LEFT or TO
THE RIGHT above the 36” (914 mm) high countertop.
IMPORTANT: One side (left or right) above the 36” (914 mm)
high countertop must always be kept clear.
Installation with 3" backguard: There must be a minimum of
12” (305 mm) clearance from the back of the 3" backguard to
such combustible surface on the back of the range above the
36” (914 mm) high countertop.
3. The maximum upper cabinet depth recommended is 13” (330
mm). Wall cabinet above the range must be a minimum of 30”
(762 mm) above the countertop for a width of minimum 35”
7/8 (911 mm): it has to be centred with the range. Side wall
cabinets above the range must be a minimum of 18” (457 mm)
above the countertop.
8" backguard
3" backguard
8"
(203 mm)
23"
31/32
(609 mm)
(911 mm)
35" 7/8
MIN 36" (914 mm)
MAX 37" 13/32 (950 mm)
3"
(76 mm)
23"
31/32
(609 mm)
(911 mm)
35" 7/8
MIN 36" (914 mm)
MAX 37" 13/32 (950 mm)
installation
1
77
Dotted line showing the position
of the range when installed
Area for
ELECTRICAL
connection
6” 11/16 ÷ 8” 21/32 (170÷220 mm)
[depending on feet regulation]
Fig. 1.2
ELECTRIC CONNECTION
1
88
Fig. 1.3b
Fig. 1.3a
PROXIMITY TO SIDE CABINETS
RANGE WITH 8" BACKGUARD
(457 mm)
18" min.
30" min.
(762 mm)
(914 mm)
36"
0"
(0 mm)
0"
(0 mm)
20" min. (500 mm)
2" (50 mm)
13" max. (330 mm)
(457 mm)
18" min.
30" min.
(762 mm)
(914 mm)
36"
0"
0"
(0 mm)
(0 mm)
20" min. (500 mm)
2" (50 mm)
13" max. (330 mm)
OVEN VENT
OVEN VENT
1
99
Fig. 1.3c
Fig. 1.3d
PROXIMITY TO SIDE
CABINETS
RANGE WITH 3" BACKGUARD
(457 mm)
18" min.
30" min.
(762 mm)
(914 mm)
36"
0"
0"
(0 mm)
(0 mm)
20" min. (500 mm)
13" max. (330 mm)
2" (50 mm)
12"
min. (305 mm)
(457 mm)
18" min.
30" min.
(762 mm)
(914 mm)
36"
0"
(0 mm)
0"
(0 mm)
20" min. (500 mm)
2" (50 mm)
13" max. (330 mm)
12"
min. (305 mm)
OVEN VENT
OVEN VENT
1
1010
Fig. 1.4
FITTING THE ADJUSTABLE FEET
The adjustable feet must be fitted to the base of the cooker before use.
Rest the rear of the cooker on a piece of the polystyrene packaging exposing the base
for the fitting of the feet.
ATTENTION: Most important! Pay special attention not to damage the range during
this operation.
Fit the 4 legs by screwing them tight into the support base as shown in picture 1.5.
Fig. 1.5
LEVELLING THE COOKER
The cooker may be levelled by screwing the lower ends of the feet IN or OUT (fig. 1.6).
It is important to observe the directions of figure 1.6.
+ 1" 31/32
+ 50 mm
0 mm
0"
Fig. 1.6
Fig. 1.7a Fig. 1.7b Fig. 1.7c
MOVING THE COOKER
WARNING
When raising cooker to upright position always ensure two people carry out this
manoeuvre to prevent damage to the adjustable feet (fig. 1.7a).
WARNING
Be careful: do not lift the cooker by the door handle when raising to the upright position
(fig. 1.7b).
WARNING
When moving cooker to its final position
DO NOT DRAG
(fig. 1.7c).
Lift feet clear of floor (fig. 1.7a).
1
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Rango de Verona
Verona
Verona VDFSGE365W Manual de usuario
Verona
Verona VEFSGG 365 Manual de usuario
Verona
Verona VEFSGE 365 ND Instrucciones de operación
Verona
Verona VEFSGG 304 Series Instrucciones de operación
Verona
Verona VEFSGE 304 SC Manual de usuario
Verona
Verona VCLFSGG 365 D Series Instrucciones de operación
Verona
Verona VEFSGG 244 Instrucciones de operación
Verona
Verona VEFSGG 244 Manual de usuario
Verona
Verona VEFSEE 244 P Series Manual de usuario
Verona
Verona VDFSGG365 Series Manual de usuario
Verona
Verona VEFSGE 365 Instrucciones de operación
Verona
Verona VEFSEE 365 Series Instrucciones de operación
Verona
Verona VPFSGG365 Series Manual de usuario
Verona
Verona Prestige VPFSEE365 Series Instrucciones de operación
Verona
Verona VDFSGE365 Series Manual de usuario
Verona
Verona VEFSGE486DGP series Instrucciones de operación
Verona
Verona VEFSGE365ND Manual de usuario
Verona
Verona VEFSGG 365 Manual de usuario
Verona
Verona VPFSEE365D Series Instrucciones de operación
Verona
Verona VEFSGG30 Hoja de especificaciones
