The VenueTM Party Pack Fogger sets the right mood for showing your lights at their optimal best. Perfect for club, dance
floor, or special event.
SPECIFICATIONS
Power Input: 120VAC 60Hz
Fuse: 7A 125V
Fog Output: 2500 Cubic Feet/Minute
Size: L 12.9” x W 6.3” x H 5.1”
Heater: 700 Watts
Warm-up Time: 4 Minutes
Tank Capacity: 1 Liter
Weight: 8.1 lbs / 3.7 kg
IMPORTANT SAFETY INSTRUCTION
• For indoor use only. Do not expose the fogger to moisture.
• Place the fogger horizontally on oor or hang it from the ceiling at no more than a 15-degree angle.
• Keep at least 8” away from all other objects to allow for ventilation and cooling.
• Keep out of reach of children.
• Do not place the fogger close to any ammable or explosive substance in order to avoid re or explosion.
• Point the nozzle away from people when in use.
• Do not operate when fog uid is running now. Before relling unit, turn off the machine.
• Be careful not to exceed the maximum uid level.
• Unplug the unit when not in use.
HOW TO OPERATE
• Place the unit horizontally and ll the tank with high quality fog uid such as Black Label Fog Fluid.
• Plug the remote into socket marked “Control Input” which is found on the back on the unit.
• Connect the machine with the proper power supply and turn on the power switch.
• Wait a few minutes until the unit warms up. When the red indicator on the remote lights up, the unit is ready for use. Now
you can press the button on the remote to begin fogging.
• It is normal for your fogger to have a recycling period after long bursts. At that point the unit will shut itself down for a
short period in order to heat back up. During this time, no fog can be produced. The red light on the remote will illuminate
when the unit is ready for action.
• You should turn off the fog machine before relling.
MAINTENANCE
• Always use a high quality fog liquid such as Black Label Fog Fluid.
• Do not operate the machine when uid is low. Be careful not to exceed the maximum uid level.
• To maintain optimum performance and minimize wear, unit should be cleaned frequently -- usage and environment are
contributing factors in determining how often. As a general rule, unit should be cleaned after every 40 hours of use. Clean
with a solution of 80% water and 20% vinegar. Empty the tank of any remaining fog liquid and pour in the water and
vinegar solution. Spray until the tank is empty. Clean the nozzle separately with a 100% vinegar solution. Dust build up,
and/or using heavy fog fluid may reduce fog output performance and can cause overheating. This can lead to a reduction
in the fogger’s life and will increase mechanical wear.
• Be sure to power off unit before conducting maintenance.
• If you experience low output, mechanical noise, or no output at all, please unplug immediately. Check the uid level, the
external fuse, remote connection, and the power from the wall. If all of these are OK, plug the unit in again. If fogger does
not function after 30 seconds, disconnect power or permanent damage to the unit may result. Return the machine to your
dealer. Always drain the tank before mailing or transporting the unit.
• Unplug the unit when not in use.
• In the unlikely event your unit may require service, please contact your dealer or visit www.venuelightingeffects.com
