Vents Lumis 100 Manual de usuario

USER’S MANUAL

AXIAL FAN WITH INTEGRATED LIGHT SOURCE

Lumis 100

V01-LUMIS-01_EN.indd 1 17.08.2015 11:09:14

mepokerkft.hu

CONTENTS

Safety requirements 3

Purpose 5

Delivery set 5

Designation key 5

Technical data 6

Unit design and operating principle 6

Mounting and set-up 7

Technical maintenance 9

Transportation and storage regulations 10

Manufacturer's warranty 10

Acceptance certificate 12

Seller information 12

Installation certificate 13

Warranty card 13

V01-LUMIS-01_EN.indd 2 17.08.2015 11:09:14

mepokerkft.hu

This user’s manual consisting of the technical details, operating instructions and technical

specication covers the installation and mounting of the Lumis 100 axial fan with integrated

light source (hereinafter referred to as «the fan» or «the unit» as mentioned in the «Safety

requirements» and «Manufacturer’s warranty» sections as well as in warnings and information

blocks).

SAFETY REQUIREMENTS

Read the user’s manual carefully prior to installing and operating the unit.

Fulfil the user’s manual requirements as well as the provisions of all the applicable

local and national construction, electrical and technical norms and standards.

The warnings contained in the user’s manual must be considered most seriously

since they contain vital personal safety information.

Failure to follow the rules and safety precautions noted in this user’s manual may

result in an injury or unit damage.

After a careful reading of the manual, keep it for the entire service life of the unit.

While transferring the unit control the User’s manual must be turned over to the

receiving operator.

Symbol legend:

WARNING!

DO NOT!

UNIT MOUNTING AND OPERATION SAFETY PRECAUTIONS

• Disconnect the unit from power

mains prior to any installation

operations.

• Unpack the unit with care.

• Do not lay the power cable of the

unit in close proximity to heating

equipment.

• While installing the unit follow

the safety regulations specific to

the use of electric tools.

• Do not lay the power cable of the

unit in close proximity to heating

equipment.

• Do not operate the unit outside

the temperature range stated

in the user's manual as well

as in aggressive or explosive

environments.

V01-LUMIS-01_EN.indd 3 17.08.2015 11:09:15

mepokerkft.hu

• Do not use damaged equipment

or cables when connecting the

unit to power mains.

• Disconnect the unit from power

supply prior to any technical

maintenance.

• Do not touch the unit controls

with wet hands. Do not carry out

the installation and maintenance

operations with wet hands.

• Do not wash the unit with water.

Protect the electric parts of the

unit against ingress of water.

• Do not allow children to operate

the unit.

• Use the unit only for its intended

purpose.

• Do not store any explosive or

highly flammable substances in

close proximity to the unit.

• When the unit generates

unusual sounds, odour or emits

smoke disconnect it from power

supply and contact the Seller.

• Do not open the unit during

operation.

• Do not direct the air flow

produced by the unit towards

open flame or ignition sources.

• Do not block the air duct when

the unit is switched on.

• In case of continuous operation

of the unit periodically check

the security of mounting.

V01-LUMIS-01_EN.indd 4 17.08.2015 11:09:15

mepokerkft.hu

PURPOSE

The unit described herein is the exhaust axial fan designed for exhaust ventilation and for

lighting of small and medium sized residential premises. The fan is designed for use in Ø100

mm air ducts. The fan can be equipped with a back valve to prevent air back drafting when the

fan is switched off.

THE UNIT MAY NOT BE OPERATED BY CHILDREN OR

PERSONS WITH REDUCED PHYSICAL, MENTAL OR SENSORY

CAPACITIES, OR LACKING THE APPROPRIATE TRAINING.

THE UNIT MUST BE INSTALLED AND CONNECTED ONLY BY

PROPERLY QUALIFIED PERSONNEL AFTER THE APPROPRIATE

BRIEFING. THE CHOICE OF UNIT INSTALLATION LOCATION MUST

PREVENT UNAUTHORIZED ACCESS BY UNATTENDED CHILDREN.

DELIVERY SET

Fan 1 item

User's manual 1 item

Power supply unit 1 item

Fastening kit 1 item

Packing 1 item

DESIGNATION KEY

Lumis 100 K L turbo

Fan series

Exhaust spigot diameter [mm]

100

Non-return valve

Ball bearings

Increased capacity

V01-LUMIS-01_EN.indd 5 17.08.2015 11:09:15

mepokerkft.hu

TECHNICAL DATA

The fan is designed for indoor application and for connection to single-phase AC 220-240 V

/ 50(60) Hz power mains at the ambient temperature ranging from +1°C up to +45°C.

Ingress protection rating - IP 24.

The fan requires no grounding.

Connected air duct diameter Ø100 mm.

The unit design is constantly being improved, so some models can slightly differ from those

ones described in this manual.

178 Ø118

Ø 99,4

133,5

DESIGN AND OPERATING PRINCIPLE

The casing and the impeller are made of high-quality durable ABS plastic, UV resistant.

The 10 watt LED backlight lamp is integrated in the fan casing.

The impeller design enhances the fan efficiency and prolongs the motor service life.

The fan is equipped with an energy-efficient motor with overheating protection. The

maintenance-free motor is designed for continuous operation.

Modifications and options:

• Lumis 100 K - the fan is equipped with a back valve to prevent air back drafting (at

customer’s request).

• Lumis 100 L - the motor is equipped with ball bearings for longer service life (appr. 40

thousand hours) and fan mounting at any angle. The bearings are maintenance-free

and contain enough grease for the entire operating period.

• Lumis 100 turbo - high-powered motor.

V01-LUMIS-01_EN.indd 6 17.08.2015 11:09:15

mepokerkft.hu

MOUNTING AND SET-UP

The ventilator is designed for ceiling mounting. The fan is mounted directly into the

ventilation shaft. Flexible duct connection is recommended in case of the remote ventilation

shaft location. The air duct is connected to the fan exhaust flange through a clamp.

Fan mounting and connection.

1 2 3

L N

Ø 100 mm

Install the air duct. Route the wires

and prepare a Ø100 mm hole.

Make a hole in the fan casing

for routing the power wires.

V01-LUMIS-01_EN.indd 7 17.08.2015 11:09:15

mepokerkft.hu

L (~) SN (~)

Power

supply unit

black

red

brown

blue

N L

OFF

L (~) S1

N (~)

Power

supply unit

black

red

blue

brown

N L

S1 S2

OFF

Simultaneous

switching on

of the fan

and the lamp.

Separate

switching on

of the fan

and the lamp.

Connect the wires according to the Wiring diagram.

Connect the power supply unit

and install it in a false ceiling.

Route the wires though the

hole in the casing and install

the fan in the air duct.

Fix the fan on the ceiling surface

using the screws.

Connect the connectors and install

the lamp on the fan casing by turning

it clockwise.

V01-LUMIS-01_EN.indd 8 17.08.2015 11:09:16

mepokerkft.hu

TECHNICAL MAINTENANCE

L N

1 2

3 4

5 6

V01-LUMIS-01_EN.indd 9 17.08.2015 11:09:16

mepokerkft.hu

TRANSPORTATION AND STORAGE REGULATIONS

Store the unit in the manufacturer’s original packing box in a dry closed ventilated premise

with temperature range from +5 °C to + 40 °C.

Storage environment must not contain aggressive vapours and chemical mixtures provoking

corrosion, insulation and sealing deformation.

Use hoist machinery for handling and transportation to prevent possible mechanical

damages of the unit.

Follow the applicable moving regulations specific to the particular cargo type while loading

and unloading.

The unit can be carried in the original packing by any mode of transport provided proper

protection against precipitation and mechanical damage.

Avoid sharp blows, scratches or rough handling during loading and unloading.

MANUFACTURER’S WARRANTY

The manufacturer hereby warrants normal operation of the unit for 60 months after the retail

sale date provided the user’s observance of the transportation, storage, mounting and operation

regulations.

Should any malfunctions occur in the course of the unit operation through the Manufacturer’s

fault during the guaranteed period of operation the user is entitled to elimination of faults by the

manufacturer by means of warranty repair at the factory free of charge.

The warranty repair shall include work specific to elimination of faults in the unit operation

to ensure its intended use by the user within the guaranteed period of operation. The faults are

eliminated by means of replacement or repair of the unit components or a specific part of such

unit component.

The warranty repair does not include:

• routine technical maintenance

• unit installation / dismantling

• unit setup

To benefit from warranty repair the user must provide the unit, the user’s manual

with the purchase date stamp and the payment document certifying the purchase.

The unit model must comply with the one stated in the user’s manual.

Contact the Seller for warranty service.

V01-LUMIS-01_EN.indd 10 17.08.2015 11:09:16

mepokerkft.hu

Tabla de contenidos

Otros manuales de Admirador de Vents

Vents

Vents TwinFresh Comfo RA1-25 Manual de usuario

Vents

Vents TT PRO Series Manual de usuario

Vents

Vents VKM Series Manual de usuario

Vents

Vents Simple 100 Manual de usuario

Vents

Vents OV 200 EC Manual de usuario

Vents

Vents KSB EC Series Manual de usuario

Vents

Vents SERIES Manual de usuario

Vents

Vents 100 Solid Manual de usuario

Vents

Vents TwinFresh Expert RW1-50 Manual de usuario

Vents

Vents VKO Series Manual de usuario

Vents

Vents 125 IFK Manual de usuario

Vents

Vents Solo RA1-35 R Manual de usuario

Vents

Vents iFan Celsius Manual de usuario

Vents

Vents Quiet Manual de usuario

Vents

Vents FlexiVent 0811125/63x2 Manual de usuario

Vents

Vents VKV Series Manual de usuario

Vents

Vents TwinFresh Comfo RA-50 V.3 Manual de usuario

Vents

Vents Quiet-Disc Manual de usuario

Vents

Vents VUT 180 P5 Manual de usuario

Vents

Vents TwinFresh Expert RW-30 V.2 Manual de usuario

Vents

Vents Boost-I 150 Manual de usuario

Vents

Vents VKV EC Series Manual de usuario

Vents

Vents P2-1-300 Manual del propietario

Vents

Vents VK EC Series Manual de usuario

Manuales populares de Admirador de otras marcas

ELTA FANS

ELTA FANS H03VV-F Manual de usuario

Hunter

Hunter 20714 Manual de instrucciones

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manual de usuario

Hunter

Hunter Caraway Manual de instrucciones

Panasonic

Panasonic FV-15NLFS1 Manual de usuario

Kompernass

Kompernass KH 1150 Manual de usuario

VES

VES FALA100/12V/TR Manual de usuario

Vertiv

Vertiv Liebert DCD Manual de usuario

Westinghouse

Westinghouse GFP Series Manual de usuario

Venmar

Venmar KUBIX HRV PLUS Series Manual de usuario

Maico

Maico ECR 31 Manual de usuario

Sonnenkonig

Sonnenkonig Dinky Manual de usuario

S&P

S&P ECOWATT HXBR Manual de usuario

Wider

Wider IMP03369BH Manual de usuario

Panasonic

Panasonic F-60DHN Manual de usuario

Hinkley

Hinkley HIGHLAND Manual de usuario

Broan

Broan 766BN Manual de usuario

Premium

Premium PFS16022 Instrucciones de montaje