Velleman WC30CT Manual de usuario

WC30CT VELLEMAN

WC30CT – DCF Wall Clock

1. Safety

• Do not open the housing and do not expose the device to rain, water, dust, water, extreme temperatures or direct sunlight.

• Only use the device in open air.

• Do not use the device in close proximity to heat sources e.g. radiators.

• Avoid intense vibrations and other mechanical loads.

• Wait 2 hours before activating the device when it is introduced into a new temperature environment (e.g. after transport).

2. Batteries

• Consult a physician immediately if a battery is swallowed.

• Never try to reactivate empty batteries and never open or burn batteries.

• Use only batteries of the same brand and replace all batteries at once.

• The batteries may drain excessively if these instructions are not respected.

• Do not short batteries and do not include them in the domestic waste.

• Dispose of your empty batteries in the legally required fashion. Only throw away completely empty batteries.

• Replace the batteries as follows : open the battery compartment (2), remove the old batteries, insert the new ones and close

the battery compartment. Mind the polarity indications when installing the batteries.

3. General

The WC30CT can be used as a free-standing device and can be hung from the wall. Position the device near a window to

ensure correct reception of the DCF signal. Steel doors and concrete walls can impede signal reception, as can electric

appliances. Do not position the device in close proximity to TV’s, stereos, etc.

This device can either display the time and date through reception of the DCF signal or the user can enter the time and date

manually.

Deploy the two supports (3) to use the WC30CT as a free-standing clock.

Wall mounting : drive a round-headed screw into the wall and let it protrude ± 3 to 4mm. Be careful not to damage any water or

gas pipes. Hang the device from the screw.

4. Setting the Correct Date and Time

Using the DCF Signal

The device will tryto receive theDCF signal as soon as thebatteries areinstalled orthe WAVE button is pressed. It may take the

device up to 7 minutes to locatethe signal. Note that the buttons at the back of the device will not work during this time. As soonas

reception of the DCF signal is clear, the message “WAVE OK” and the symbol are displayed (the symbol nolonger

flashes).

The user doesn’t need to set the clock, the calendar or the day of the week.

WC30CT VELLEMAN

Manual Time Setting

Hold the MODE button for 3 seconds to make the digits for the year, month, date and day of the week flash. Set the year, month &

datewith the YEAR, MONTH & DATE buttons. The day of the week changes automatically when the date is adjusted.

Remember that the digits change fasterwhen a button is held.

Press MODE to make the digits for the clock flash. Set the hours, minutes and seconds with the HOUR, MIN & SEC buttons

respectively.

Press MODE again to make the digits for the display language flash. Select the display language with the COUNTRY button :

English, Dutch, French or German (EN

ENEN

EN, DU

DUDU

DU, FR

FRFR

FR or GE

GEGE

GE).

Important Remark : the manual time setting will be overridden if a DCF signal is received.

5. Selecting the Displayed Data

Select the displayed data with the MODE button at the back of the device. Press it to toggle between alarm time display and

normal clock display.

6. Setting the Alarm Time

Press MODE inthe normal display mode to display the current alarm time. Enter the hours and minutes with the HOUR and MIN

buttons. Press the ALM button repeatedly to select the alarm mode :

• symbol is displayed: the alarm will go off for oneminute once every24 hours. Press anarbitrary button to stopthe alarm.

• and are displayed : press an arbitrary button to stop the alarm temporarily. The alarm is reactivated some time later.

Press MODE againtoreturnto thenormal displaymode.

7. Temperature Readout

Press the °C/°F-button to select a temperature readout in °C or °F when the device is in the normal display mode.

8. Selecting 12hr- or 24hr-mode

Press the "12/24"-button when the device is in the normal display mode to display the time either in 12hr- or 24hr-mode.

9. Reset Button

Press the small yellow button at the back with a sharp object to reset the device.

10. Maintenance and Safety Instructions

Use a soft cloth moistened with mild detergent to clean the device. Do not use abrasives or solvents on the device. Do not drop the

device on a hard surface. Do not use it outdoors and shield it from direct sunlight.

11. Replacing Batteries

Insert two newAA-batterieswhen the screen becomes illegible.

12. Maintenance

Wipe the device with a clean cloth and some mild detergent.

13. Warranty

The warranty conditions are mentioned on the included warranty card.

Otros manuales de Reloj de Velleman

Velleman

Velleman WC120 Manual de usuario

Velleman

Velleman WT4406 Manual de usuario

Velleman

Velleman WC30DT Manual de usuario

Velleman

Velleman WC30D3 Manual de usuario

Velleman

Velleman WC30D2 Manual de usuario

Velleman

Velleman WT705G Manual de usuario

Velleman

Velleman WC1857 Manual de usuario

Velleman

Velleman PEREL WC104 Manual de usuario

Velleman

Velleman WC40D Manual de usuario

Velleman

Velleman Whadda WPM352 Manual de usuario

Velleman

Velleman wc4171 Manual de usuario

Velleman

Velleman WC103 Manual de usuario

Velleman

Velleman WT8093 Manual de usuario

Velleman

Velleman WST8089 Manual de usuario

Velleman

Velleman CAMCOLVC11 Manual de usuario

Velleman

Velleman ED8A101 Manual de usuario

Velleman

Velleman WC30D4 Manual de usuario

Velleman

Velleman WTPC108 Manual de usuario

Velleman

Velleman WT8732 Manual de usuario

Velleman

Velleman MB02C Manual de usuario

Velleman

Velleman WCM1 Manual de usuario

Velleman

Velleman WC50D Manual de usuario

Velleman

Velleman WC8205 Manual de usuario

Velleman

Velleman WT3752 Manual de usuario

Manuales populares de Reloj de otras marcas

Silicon Laboratories

Silicon Laboratories SI5324 Manual de usuario

Heathkit

Heathkit GC-1005 Manual de usuario

Oregon Scientific

Oregon Scientific PRYSMA RMR221P Manual de usuario

Andrew O'Malley

Andrew O'Malley DOTKLOK Manual de usuario

ALGE-Timing

ALGE-Timing ASC3 Manual de usuario

Bodet

Bodet Profil 960 Manual de usuario

Nixie Clock

Nixie Clock Divergence Meter Manual de usuario

La Crosse Technology

La Crosse Technology WS-8256-AL Manual de usuario

Mini Gadgets

Mini Gadgets MCPro Manual de usuario

Casio

Casio TMR-200 Manual de usuario

Progetti

Progetti ILTEMPOSTRINGE Manual

BVItech

BVItech BV-101 Manual de usuario

Progetti

Progetti KALIMERO Manual

La Crosse Technology

La Crosse Technology WT-3141b Manual

La Crosse Technology

La Crosse Technology W86531 Manual de usuario

Sharp

Sharp SPC900 Manual de usuario

La Crosse Technology

La Crosse Technology 404-50447 Manual de usuario

Datexx

Datexx DF0063 Manual de usuario