Varifan ECS-1M Manual de usuario

Page 1

ECS-1M

USER’S MANUAL

ENVIRONMENT CONTROL SYSTEM

1 stage

computer compatible

Varifan

ECS-1M

ADJUST

MIN SPEED

TIMER

off

DIFF

reduc.

per day

www.monitrol.com

Page 2

ECS 1M

Although the manufacturer has made every effort to

ensure the accuracy of the information contained

herein, this document is subject to change without

notice due to ongoing product development.

WARNING AND PRECAUTIONS

Equipment, probe failure, blown fuses and/or tripped

breakers may prove harmful to the contents of the

building. Therefore it is strongly recommended to install

backup devices and alarm or warning devices. Spare

equipment should also be available at the owner’s site.

Equipment manufactured by the manufacturer is

protected against normal line surges. High surges

caused by thunder storms or power supply equipment

may damage this equipment. For added security

against line voltage surges, it is recommended that

surge and noise suppression devices be installed at the

electrical distribution panel. Use of shielded cable for

probes is recommended for protection against

lightning. These devices are available from most

electrical supply distributors.

RECOMMENDATIONS

The manufacturer recommends that all installation

procedures described herein be performed by a

qualified electrician or installation technician.

Furthermore the manufacturer recommends to test all

the functions and equipment connected to the ECS,

including the alarm system and backup devices, after

installation, after modifications, and once a month after

that.

Fuse verification and replacement, as well as the

proper setting of control values, shall be the

responsibility of the owner of this equipment.

www.monitrol.com

Page 3

CHAPTER 1 - INTRODUCTION

1. General ...........................................................................5

1.1 Description.......................................................................5

Definition of terms.........................................................................7

CHAPTER 2 - INSTALLATION

2.1 Unpacking........................................................................9

2.2 Mounting ........................................................................10

2.3 Switch Settings................................................................10

2.3.1 Line Voltage Selector Switch ..........................................10

2.3.2 Software Settings Switch ................................................11

2.4 Connection Procedure ....................................................11

2.4.1 Input Power.....................................................................11

2.4.1.1 115 VAC..........................................................................11

2.4.1.2 230 VAC..........................................................................12

2.4.2 Fan 1...............................................................................12

2.5 Temperature/Humidity Probes........................................12

2.5.1 Single Temperature Probe..............................................13

2.5.2 Averaging........................................................................13

2.5.3 Humidity Probe................................................................13

2.6 Alarm...............................................................................13

2.7 Powering Up....................................................................14

CHAPTER 3 - USER GUIDE

LED Status Window........................................................21

Control Dials....................................................................21

PRIMARY FUNCTIONS

Main Set Point Temperature...........................................23

Fan 1 Differential.............................................................24

Fan 1 Minimum Speed....................................................25

Fan 1 Duty Cycle.............................................................26

TABLE OF CONTENTS

www.monitrol.com

Page 4

ECS 1M

CONTENTS CONTINUED...

Ramping......................................................................... 27

Record Low Temperature .............................................. 28

Record High Temperature ............................................. 29

Ambient Room Temperature Display ............................. 30

SECONDARY FUNCTIONS

Relative Humidity Set Point............................................ 31

Fan 1 Motor.................................................................... 32

Fan 1 Minimum Humidity Speed.................................... 33

Fan 1 Maximum speed................................................... 34

Minimum Ramping ......................................................... 35

Low Temperature Alarm................................................. 36

High Temperature Alarm................................................ 37

Relative Humidity Display............................................... 38

APPENDIX

Motor Compatibility Table............................................................ 39

Troubleshooting........................................................................... 40

Specification................................................................................ 41

Record Form ............................................................................... 42

www.monitrol.com

Page 5

1. GENERAL

This document provides a description of the ECS 1M

control panel. This document is organized as follows:

Introduction

Installation

User’s Guide

Appendix

1.1 DESCRIPTION

Congratulations on the purchase of your ECS 1M

environmental control system. The ECS M product line

provides you with full control over temperature,

humidity, air flow, and heat resulting in a comfortable

environment for your livestock.

The ECS M product line offers a number of added

features over existing ECS controls such as:

Compatible with EPM-10 and DIP-1.

Hi/Lo temperature indication.

Automatic temperature reduction (ramping).

Adaptable variable speed outputs for a wide

selection of fan model types.

Humidity probe.

Full torque fan start preventing motor damage.

The ECS 1M provides microprocessor control over a

single stage output.

This stage controls a variable speed fan which can

operate at a continuous low speed to ensure good

quality of air when the room temperature is below the

main set point. In addition, the first stage may be

programmed to cycle on and off. When the room

temperature rises above the main set point, the fan

accelerates to increase the air flow.

CHAPTER 1 - INTRODUCTION

www.monitrol.com

Page 6

ECS 1M

DESCRIPTION CONTINUED...

The ECS 1M provides you with full control over one

stage via the use of an easy to follow display panel. All

programmable features can be customized to meet

your requirements. The ECS 1M keeps you constantly

informed by displaying the status of all of its outputs as

well as the ambient temperature. With an optional

humidity probe, the ECS 1M displays current humidity

levels.

Safety of livestock is ensured by the continuous

control of climate and timely alarm notification should

environmental conditions exceed alarm set points.

Further security may be obtained by connecting all

ECS series controls in a network configuration to a

computer via the use of an optional RCM 40 remote

monitoring unit. This provides remote control

monitoring of each room. The control panel variable

output is fused, and all programmable settings are

maintained whether or not the ECS 1M is powered.

The ECS 1M provides an automatic constant

temperature reduction (ramping) feature for your

maturing livestock. A built in low temperature safety

factor prevents temperatures reaching dangerous

limits.

The ECS 1M can control an EPM-10. This control is

designed to position an air inlet baffle board or air inlet

curtain without the use of a feedback potentiometer or

0 - 10 volts analog signal. The EPM-10 provides an

automated positioning of your air inlet according to

the signal sent by the ECS 1M, or alternatively by

manual position knob control on the EPM-10 .

With ECS 1M in control of your climate, you are

assured of optimal living conditions for your livestock.

www.monitrol.com

Page 7

MAIN SET POINT

The desired room temperature. Other temperature

settings on the ECS 1M are relative to the main set

point temperature.

RELATIVE TEMPERATURE

A value added to or subtracted from the main set point

which results in a new temperature at which a desired

action starts or stops.

AMBIENT TEMPERATURE

The actual temperature of the room.

AMBIENT HUMIDITY

The actual humidity level of the room.

MINIMUM FAN SPEED

The desired minimum speed for variable speed fans.

RAMPING

An automatic daily reduction in the main set point and

all temperature settings relative to this.

DEFINITION OF TERMS

www.monitrol.com

Page 8

ECS 1M

www.monitrol.com

Page 9

Chapter 2 describes the installation of the ECS 1M

control panel.

2.1 UNPACKING

Unpack the ECS 1M from its box and inspect

contents for damage. Should the contents appear to

be damaged, contact your local distributor for return

material procedures.

The package should contain the following standard

items:

1 ECS 1M control .

1 installed temperature probe (model number

2004-1K).

2 cable fasteners or fuses.

1 User manual.

The following optional items may be included:

3 additional temperature probes for temperature

averaging,

1 humidity probe. The ECS 1M requires the RHT-

1 humidity probe for maximum accuracy of

monitoring and control of humidity levels.

The manufacturer recommends that the installation

instructions which follow be adhered to as closely

as possible, and all work be performed by a certified

electrician. Failure to do so may void the warranty!

CHAPTER 2 - INSTALLATION

www.monitrol.com

Page 10

ECS 1M

2.2 MOUNTING

Mount the control panel to the wall using the mounting

holes located on the flange of the control housing

Once the ECS 1M is in place, use a screwdriver to

remove the six screws holding the faceplate to the

housing.

2.3 SWITCH SETTINGS

The ECS 1M is configured for a variety of options via two

switches as follows:

2.3.1 - Line Voltage Selector Switch

This switch is located on the surface of the main (bottom)

board and adapts the control panel for 115 VAC or 230

VAC line voltage.

Refer to Figures 1, and 2.

To limit the unit’s exposure to noxious gases install the

unit in a hallway.

Make certain that the unit is mounted right side up with

the cable entry holes facing down.

The ECS 1M will operate in a temperature range of 32°F -

120 °F (0 °C - 50 °C).

* It is prohibited to use overhead cables outside the building.

Mounting hardware is not shipped with the unit.

230V

115V

www.monitrol.com

Tabla de contenidos

Otros manuales de Sistema de control de Varifan

Varifan

Varifan MSC-10 Manual de usuario

Varifan

Varifan ECS-2M Manual de usuario

Varifan

Varifan IC-610 Manual de usuario

Varifan

Varifan CM10-2 Manual de usuario

Varifan

Varifan ECS 5M Manual de usuario

Varifan

Varifan MST-5C Manual de usuario

Varifan

Varifan CPS-3M Manual de usuario

Varifan

Varifan MST-2B Manual de usuario

Varifan

Varifan DIP-1/115 Manual de operación

Varifan

Varifan CPS-2C Manual de operación

Varifan

Varifan DIP-1C Manual de operación

Varifan

Varifan IC-664 Manual de usuario

Varifan

Varifan ECS-4+ Manual de usuario

Varifan

Varifan ECS 5M Manual de usuario

Varifan

Varifan IC-68ND Manual de usuario

Varifan

Varifan MVS-1C Manual de usuario

Varifan

Varifan VPM-1 Manual de usuario

Varifan

Varifan SVIM-1LE Manual de usuario

Manuales populares de Sistema de control de otras marcas

Pentair Pool Products

Pentair Pool Products Compool Manual de usuario

ComfortNET

ComfortNET CTK04 Manual de usuario

Fireye

Fireye InSight II 95DSS3 Manual de usuario

CAME

CAME G3000 Manual de usuario

Idemia

Idemia MorphoAccess VP MD Manual de usuario

Axis

Axis P1445-LE-3 Manual de usuario

HEIDENHAIN

HEIDENHAIN TNC 150 B Manual de usuario

CNC-Step

CNC-Step High-Z T-Series Manual de usuario

Doosan

Doosan DVF Series Manual de usuario

Honeywell

Honeywell KAP 140 Manual de usuario

Honeywell

Honeywell vk41 series Manual de usuario

AirBench

AirBench FPW Guía de instalación

Cypress

Cypress HHR-3160 Manual de usuario

CAME

CAME GLT40AOS Manual de usuario

Zonex

Zonex GEN II -VVT Guía del usuario

Altronics

Altronics K 9650 Manual de usuario

micro-trak

micro-trak RoadMaster Manual de usuario

micro-trak

micro-trak Calc-An-Acre II Manual de usuario