Vantec NexStar FX Manual de usuario
Copyright © 2010 Vantec Thermal Technologies. All Rights Reserved.
User’s Manual
Package Contents:
1 NexStar FX Gigabit NAS Enclosure x1
2 AC Adapter x1
3 Installation Guide x1
4 Rubber Feet x4
5 User’s CD x1
6 Ethernet Cable x1
7 User’s Manual x1
8 Stand x1
1
2
3
4 8
5
6
7
TRADEMARKS
MS-DOS, Xbox, Microsoft, Windows NT/2000/XP/Vista/7 are trademarks of Microsoft Corporation.
PS3 and Playstation are trademarks of Sony Corporation.
Apple, iTunes, Macintosh and Mac are trademarks of Apple Computer.
NexStar is a registered trademark of Vantec Thermal Technologies.
*All other third-party brands and names are the property of their respective owners.
If any of these items is missing or damaged, please contact your vendor
immediately.
1
Table of Contents
Safety Instructions
Package Content / Part Layout
1. Hardware Installation
2. NexStar FX Setup
3. Conguring the NexStar FX
3.1 Login
3.2 Language Setting
3.3 Disk Tools
3.4 System Settings
3.5 Account Settings
3.6 Server Settings
3.7 Media Server
3.8 Backup (NAS to NAS)
3.9 Log Files
4. Mapping a Network Disk
5. Turn on Network Discovery (UPnP)
6. Q&A
7. Warranty
8. Contact
02
03
04
06
08
08
08
10
14
18
24
28
29
30
31
33
35
35
2
Safety Instructions
Before starting, take a few minutes to read this manual. Read all instructions
and save this manual for later reference.
Do not bump or drop the NexStar FX. Do not place the NAS on an
unstable cart, stand or table. It may fall and cause serious damage to the
product.
Gaps and openings in the front/back panel are provided for ventilation. Never
block or cover these openings, as it may cause the system to overheat and
become unreliable. Do not place the NAS System on a bed, sofa, rug, or
other similar surfaces.
This appliance must be grounded. The NAS System is equipped with a 3-wire
grounded type power cord. This power cord will only t into a grounded type
of power outlet.
If an extension cord or a power switch is used with the NAS System, make sure
that the total consumption of all the products plugged into the wall outlet does
not exceed the ampere rating.
Unplug the power cord from the wall outlet before cleaning. Keep the NAS
System dry. Do not use liquid cleaners, aerosol cleaners. Use a damp cloth for
cleaning.
Back panel of the NexStar FX should never be removed! Removing or opening the
NexStar FX may expose you to dangerous voltages.
Do not place the NAS System near or over a radiator or other heat source.
Do not use the NAS System near water.
Do not place the NAS System where the cord will be Walked on.
Copyright © 2010 Vantec Thermal Technologies. All Rights Reserved.
User’s Manual
x
x
3
Warning
NexStar FX NAS System
Caution
This symbol is used to remind user to pay attention to important descriptions
regarding usage and maintenance or additional important information related to this
NAS system.
Note
This symbol is used to provide user with useful information that can make
procedure such as conguration easier to accomplish.
Power Switch
Reset Button
Ethernet Port
USB Port
Power Port
4
1. Hardware Installation
Remove the magnetic front cover
Insert SATA Hard Disk
1.
2.
5
Put back the front cover
Connect the power adapter
Rebound type power switch is used to protect the operation system.
Power on – require 2-3 minute booting up NAS system.
Power off – require 2 minute shutting down NAS system. Alternatively, the
device can also be turned off from web GUI.
Turn on
Power
Switch
Use the ethernet cable to
connect the NAS to the
Router/ Switch in the network
4.
3.
6
2. NexStar FX Setup
Please check your network environment and select the appropriate installation method before installing the
NAS.
2.1 Connect to Network for Ofce /Home
Connect the NAS and PC to the same hub/ switch/ router.
2.2 Connect to PC for Individual System
Connect the NAS directly to your PC by a network cable.
2.3 Conguring NAS System
Open web browser and enter the IP address of the NexStar FX. Congure the NexStar FX using Web GUI. To
nd the IP address of the NexStar FX, please use the Search Utility included in the CD-ROM.
2.4 NexStar FX NAS Search Utility
Insert the NexStar FX user’s CD-Rom in to your computer. Once the autorun initializes, click on “Install
Search Utility”.
7
2.4.1 NexStar FX NAS Search Utility
Click the Setup button to begin.
2.4.2 NexStar FX NAS Search Utility Setup
If the NAS is in the same subnet, the NexStar FX will be automatically listed as depicted in the picture below.
Select the detected NexStar device and double click to enter GUI set up, or click OK to change IP settings
using this utility.
If you are unable to locate the NexStar FX, please make sure the system is
properly connected to the network. You might have to congure your rewall
or temporarily disable it. Once everything has been prepared, please use the
Search Utility again.
8
3. Conguring the NexStar FX
3.1 Login
Input the Username and Password in the login page, “admin” is the default Username & Password.
Changing security privilege is recommended.
3.2 Language Settings
The language can be changed for the entire web interface. Available in English, Germany, Spanish, French,
Japanese and Chinese.
Otros manuales para NexStar FX
1
Tabla de contenidos
Otros manuales de Recinto de Vantec
Vantec
Vantec NST-510S3-BK Manual de usuario
Vantec
Vantec NexStar NST-D100FBSU Manual de usuario
Vantec
Vantec NST-210S2-BK Manual de usuario
Vantec
Vantec NexStar MX Manual de usuario
Vantec
Vantec NexStar-3 MX Manual de usuario
Vantec
Vantec NexStar NST-D100UFS Manual de usuario
Vantec
Vantec NST-210S2-BK Manual de usuario
Vantec
Vantec NexStar VAULT AV Manual de usuario
Vantec
Vantec EZ-SWAP 2 MRK-300FD-BK Manual de usuario
Vantec
Vantec SuperSpeed NexStar 3 Manual de usuario
Vantec
Vantec NST-400MX-53 Manual de usuario
Vantec
Vantec NexStar TX Manual de usuario
Vantec
Vantec NexStar DX Manual de usuario
Vantec
Vantec EZ SWAP MRK-M3501T Manual de usuario
Vantec
Vantec NexStar MX NST-225MX-S3 Manual de usuario
Vantec
Vantec NST- 360S2i-WH Manual de usuario
Vantec
Vantec NexStar-3 MX Manual de usuario
Vantec
Vantec NexStar LX Manual de usuario
Vantec
Vantec NexStar-HX4 Manual de usuario
Vantec
Vantec NexStart.3 NST-260U2-RD Manual de usuario
