Valor Vega 200 Gas Instrucciones de uso

5138118/01

Vega 200 Gas

Model 944

CAST-IRON GAS STOVE

Fitted with a Ceramic Coal fuel effect.

(GC No. 32-264-20)

INSTALLER AND OWNER GUIDE

For further advice please contact the retailer or company

from where you purchased your stove

INSTALLER: Please leave this guide with the owner

(including photocopying), stored in any medium by electronic means (including in any

retrieval system or database) or transmitted, in any form or by any means, whether

electronic, mechanical, recording or otherwise, without the prior written permission of

the copyright owner.

Applications for the copyright owner's permission to reproduce any part of this

publication should be made, giving details of the proposed use, to the following

address: The Company Secretary, Brooks House, Coventry Road, Warwick,

CV34 4LL.

Warning: Any person who does any unauthorised act in relation to a copyright work

may be liable to criminal prosecution and civil claims for damages.

Because our policy is one of constant development and improvement, details may vary slightly from

those given in this publication.

Page 2

THIS APPLIANCE IS FOR USE WITH NATURAL GAS (G20).

WHEN CONVERTED USING CONVERSION KIT NO. 0595261 THIS APPLIANCE

IS FOR USE WITH PROPANE GAS (G31).

THIS APPLIANCE IS SUITABLE ONLY FOR INSTALLATION IN THE UNITED

KINGDOM (GB) AND THE REPUBLIC OF IRELAND (IE).

Page 3

INSTALLER GUIDE

FOR OWNER GUIDE SEE PAGES 19 TO 26

Page 4

LIST OF CONTENTS

Section Heading Page

INSTALLER GUIDE 3 - 18

OWNER GUIDE 19 - 26

1. IMAGE 5

2. SAFETY 5

3. APPLIANCE DATA AND EFFICIENCY 7

General information. 7

Efficiency. 7

3. UNPACKING 8

4. STOVE SET UP 9

Legs and front cover. 9

Deflector, diverter box and flue restrictor plate. 9

Thermal switch. 10

Burner module. 10

5. GENERAL INSTALLATION REQUIREMENTS 11

Regulations, Standards and Law. 11

The Hearth. 12

Clearances. 12

Flue / Chimney. 13

Ventilation. 13

Location. 13

Propane gas. 14

Gas connection. 14

Fitting the ceramic fuel effect. 14

Fitting the control knob. 14

6. OPERATING THE STOVE 15

Pre-lighting checks. 15

Lighting the burner. 15

Operating the burner. 15

Inlet pressure check. 16

Check for spillage. 16

Flame supervision and spillage monitoring system. 16

7. FINAL REVIEW AND SERVICING 17

Final Review. 17

Servicing. 18

Checking the aeration setting of the burner. 18

INSTALLER GUIDE

1. IMAGE

2. SAFETY

This product uses fuel effect pieces containing Refractory Ceramic Fibres

(RCF), which are man-made vitreous silicate fibres. Excessive exposure to

these materials may cause irritation to eyes, skin and respiratory tract.

Consequently, it is important to take care when handling these articles to

ensure that the release of dust is kept to a minimum. To ensure that the release

of fibres from these RCF articles is kept to a minimum, during installation and

servicing we recommend that you use a HEPA filtered vacuum to remove any

dust and soot accumulated in and around the stove before and after working on

the stove. When replacing these articles we recommend that the replaced items

are not broken up, but are sealed within a heavy duty polythene bag, clearly

labelled as RCF waste. RCF waste is classed as a stable, non-reactive

hazardous waste and may be disposed at a landfill licensed to accept such

waste. Protective clothing is not required when handling these articles, but we

recommend you follow the normal hygiene rules of not smoking, eating or

drinking in the work area and always wash your hands before eating or

drinking. This appliance does not contain any component manufactured from

asbestos or asbestos related products.

Page 5

INSTALLER GUIDE

Installer

Vega 200 gas stoves are efficient appliances giving off convected, conducted and

radiated heat. All the surfaces of the stove, except the controls, are working surfaces

and become hot in use. They must not be touched or have any combustible objects

or materials placed on or near them. A fire guard complying with BS 8423 should be

fitted for the protection of young children, the elderly, the infirm or pet animals.

The appliance is fitted with a flue safety device. If the appliance closes down after a

period of operation for no apparent reason, the consumer should be informed to stop

using the appliance until the installation and appliance have been thoroughly

checked. Under no circumstances should the flue safety device be altered or

bypassed in any way. Only a genuine manufacturers replacement part should be

fitted.

Before continuing any further with the installation of this appliance please read the

following guide to manual handling:

The approximate lifting weight of this appliance is 70 kg. We therefore recommend

that two people should be sufficient to lift the stove. If fitting or moving the stove alone

we recommend the use of suitable lifting apparatus.

When lifting always keep your back straight. Bend your legs and not your back.

Avoid twisting at the waist. It is better to reposition your feet.

Avoid upper body/top heavy bending. Do not lean forward or sideways whilst

handling the stove.

Always grip with the palm of the hand. Do not use the tips of fingers for support.

Always keep the stove as close to the body as possible. This will minimise the

cantilever action.

Use gloves to provide additional grip.

Always use assistance if required.

Page 6

INSTALLER GUIDE

3. APPLIANCE DATA AND EFFICIENCY

General information.

*When converted using kit 0595261.

The appliance data label is located on a plate at the base of the stove.

Efficiency.

The efficiency of this appliance has been measured as specified in BS EN 613 and

the result is as below :

Model Efficiency % (Gross)

944 73

944 when converted to LPG. 75

The gross calorific value of the fuel has been used for this efficiency calculation. The

test data from which it has been calculated has been certified by by BSI (0086). The

efficiency value may be used in the UK Government's Standard Assessment

Procedure (SAP) for energy rating of dwellings.

Page 7

Gas Natural (G20) Propane (G31) *

Inlet Pressure 20mbar 37mbar

Input - Max. (Gross) 6.85kW (23,372 Btu/h) 6.7kW (22,860 Btu/h)

Input - Min. (Gross) 2.3kW (7,850 Btu/h) 4.0kW (13,650 Btu/h)

Inlet Test Pressure (Cold) 20.0 ± 1.0mbar

(8.0 ± 0.4in w.g.)

37.0 ± 1.0mbar

(14.85 ± 0.4in w.g.)

Gas Connection 8mm pipe 8mm pipe

Burner Injector Cat 82 - 072 Size 130

Pilot Copreci Ref. O.D.S

21500/212

Copreci Ref. O.D.S

21500/212 Fitted with RBM

180 - 02 injector

Ignition Integral piezo (Mounted on

gas valve)

Integral piezo (Mounted on

gas valve)

Aeration See page 18 Non-adjustable

INSTALLER GUIDE

The conversion of net efficiency to gross was achieved by multiplying the net

efficiency by the following conversion factor from Table E3 of SAP 2005, rounding

down to the nearest whole number.

3. UNPACKING

Before installation, check that the following components, where required, have been

delivered.

Loose parts box - Contains the deflector, flue spigot, diverter box, four feet, lower

front panel, restrictor plate, rear burner support, bolts, wall plugs, washers and

screws.

The stove is supplied with a locked door. Using a suitable sized spanner turn the

locking bolt on the front of the door in a counter clockwise direction. Carefully remove

and unpack the contents of the stove.

Stove body - Contains the stove body and two boxes as below.

Box 1 - Contains the burner assembly, the flue safety switch and leads assembly, the

inlet ‘T’ connector and the control knob and control knob spindle extension.

Box 2 - Contains the ceramic fuel effect.

Page 8

INSTALLER GUIDE

Gas Conversion factor from net to gross efficiency

Natural Gas 0.901

LPG 0.921

4. STOVE SET UP

Legs and front cover (See figure 1).

 Locate the four leg securing studs into

the four holes in the base of the body.

 Locate the four legs to the underside of

the casting body. There are two feet with

additional floor securing brackets. We

recommend that these be placed at the

rear of the stove. Note: If lying the stove

on its top it is advisable to remove the

door before hand as it is not designed to

stay in place when inverted.

 Place the front cover plate on top of

the front legs.

 Secure the legs and front cover to the

underside of the casting body using the

nuts and washers supplied. The bolts

should have the locking washer added first

followed by the flat washer. The legs are

fitted with height adjustment bolts that are

to be used for levelling purposes only.

Deflector, diverter box and flue restrictor plate.

 This appliance is supplied with a flue restrictor for use where the flue draught is

excessive. There may however, be certain circumstances where fitting the restrictor

causes the fire to fail the spillage test. In such cases the restrictor will have to be

removed. After

removal conduct the

spillage check again.

 The deflector,

diverter box and flue

restrictor plate should

be assembled to the

stove as in figure 2.

The deflector must be

fitted first and is

secured in place

using the front bolt

that secures the flue

collar. Unscrew and

remove the nut and

washer from the front

Page 9

Figure 2.

INSTALLER GUIDE

Figure 1.

Page 10

bolt and position the deflector as

in figure 3, securing it using the

nut and washer. It MUST be

sealed against the top of the stove

casting. It is important that it sits

on top and between the raised

cast areas on the rear of the stove

body (See figure 3). The flue

spigot is screwed to the cast collar

and clamps the flue restrictor plate

in place (See figure 2).

Thermal switch.

The thermal switch should be fitted to the inside of the diverter box as in figure 4.

Secure using the nut and bolt supplied. Never modify the fixing bracket and always

ensure that the switch is fitted correctly. NEVER USE THE STOVE IF THE THERMAL

SAFETY SWITCH HAS BEEN REMOVED OR IF IT IS DAMAGED IN ANY WAY.

Burner module.

 Unpack the burner

module.

 Secure the control

knob assembly to the

gas valve, the screw

tail should secure onto

the flat on the gas

valve spindle.

 Secure the rear leg

at the back of the stove

base using two No.4 x

10mm screws supplied

(See figure 5).

 Offer the burner module into

the stove and connect the

thermal switch leads to the tags

mid way along the

thermocouple.

INSTALLER GUIDE

Figure 5.

Figure 4.

Figure 3.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cocina de Valor

Valor

Valor 550 Manual de usuario

Valor

Valor Portrait President FS Stove 531CSB Manual de usuario

Valor

Valor Madrona MF28EN Manual

Valor

Valor Madrona MF28ILN Instrucciones de funcionamiento

Valor

Valor MADRONA MFCS01 Manual de usuario

Valor

Valor Firefox 5 910 Manual de usuario

Valor

Valor The Arden Manual

Valor

Valor ardeche 8121 Guía de instalación

Valor

Valor 910 Brunswick Instrucciones de uso

Valor

Valor MADRONA MF28JN Guía de planificación

Valor

Valor Portrait Series Manual de usuario

Valor

Valor Willow Manual

Valor

Valor Hamlet Manual

Valor

Valor The Arden Manual

Valor

Valor Inspire L Instrucciones de uso

Valor

Valor Ridlington 944 Instrucciones de uso

Valor

Valor ovation 810 Guía de instalación

Valor

Valor 550 Manual de usuario

Manuales populares de Cocina de otras marcas

Arada

Arada Cassette Stove Manual de usuario

Parmco

Parmco FS 600 Manual de usuario

MCZ

MCZ SUITE AIR 10 M2 Manual de usuario

HearthStone

HearthStone Stowe DV 8321 Guía de solución de problemas

Cattara

Cattara FAMILY Manual de usuario

Stanley

Stanley Argon F500 OVAL Manual de usuario

Avalon

Avalon B-VENT Manual de usuario

Nordpeis

Nordpeis Vega Manual de usuario

Exquisit

Exquisit EKC601-5 Manual de operación

Stanley

Stanley Oisin Oil MK II Manual del propietario

Thermocet

Thermocet Brookfield S/CC Manual de usuario

HASE

HASE delhi Manual de usuario

Vermont Castings

Vermont Castings Intrepid 2 Manual de usuario

Italiana Camini

Italiana Camini CLASSICA Guía de inicio rápido

Avalon

Avalon Vashon Avanti DVS FS Manual de usuario

Spartherm

Spartherm ambiente a1 Manual de usuario

Dimplex

Dimplex MCFSTV12AU Manual de usuario

Warmlite

Warmlite WL46040 Manual de usuario