Valor Firelite OXYSAFE 2 Manual de usuario

600B691/08

OWNER’S GUIDE

THIS APPLIANCE IS FOR USE WITH NATURAL GAS (G20)

THIS APPLIANCE IS FOR USE IN THE UNITED KINGDOM (GB) AND THE

REPUBLIC OF IRELAND (IE) ONLY.

This guide is intended to help you care for your Valor gas fire. Please read thoroughly

before using and keep for future reference

We trust that this guide gives sufficient details to enable your appliance to be operated

and maintained satisfactorily. However, if further information is required, our

Valor Technical Helpline will be pleased to help.

Please telephone 08706 061 065 (National call rates apply).

This guide to be left with the owner

Firelite &Regency

OXYSAFE 2 OXYSAFE 2

MODEL 3370 MODEL 3371

(GC No. 32-032-31)

Contour

OXYSAFE 2

MODEL 338

(GC No. 32-032-32)

RADIANT/CONVECTOR

GAS FIRES

OWNER’S GUIDE

Page 2

Safety First.

Valor fires are CE Approved and designed to meet the appropriate British Standards and

Safety Marks.

Quality and Excellence at the heart of every Valor fire.

All Valor fires are manufactured to the highest standards of quality and excellence and

are manufactured under a BS EN ISO 9001 quality system accepted by the British

Standards Institute.

The Highest Standards

Valor is a member of the Society of British Gas Industries which works to ensure high

standards of safety, quality and performance.

Careful Installation

Valor is a CORGI registered company. All our gas fires must be

installed by a competent CORGI Registered Installer in accordance

with our Installer Guide and should not be fitted directly on to a

carpet or floor of combustible material.

Valor Heating, Erdington, Birmingham B24 9QP

www.valor.co.uk

Because our policy is one of constant development and improvement, details may vary

slightly from those given in this publication

OWNER’S GUIDE

Page 3

LIST OF CONTENTS

SAFETY ..............................................................................................................................3

APPLIANCE DIMENSIONS............................................................................................6

OPERATING YOUR FIRE ..............................................................................................7

CLEANING ........................................................................................................................9

REPLACING THE RADIANTS ......................................................................................9

MAINTENANCE ............................................................................................................ 10

CUSTOMER CARE

Thank you for choosing Valor.

All Valor gas fires are designed to meet the most stringent quality, performance and

safety requirements to provide our customers with many years’ trouble-free service.

Your owner guide aims to improve your understanding and appreciation of your Valor

gas fire by providing simple and informative instructions to ensure that you benefit from

the excellent performance and features it has to offer.

If you require further assistance or any advice about gas in general,

the Valor Technical Helpline will be pleased to help.

Please telephone 08706 061 065 (National call rates apply in the United Kingdom).

SAFETY

IF YOU SMELL GAS

DON’T SMOKE

EXTINGUISH ALL NAKED FLAMES

DON’T TURN ELECTRICAL SWITCHES ON OR OFF

TURN OFF THE GAS SUPPLY AT THE METER

OPEN DOORS AND WINDOWS TO GET RID OF THE GAS

IMMEDIATELY CALL THE GAS EMERGENCY SERVICE – SEE YOUR

LOCAL TELEPHONE DIRECTORY

OWNER’S GUIDE

Page 4

Graph 1 Shelf clearances

•Have the fire installed by a competent person. In the United Kingdom, installation

must be in accordance with the latest edition of the Gas Safety (installation & use)

Regulations. In the Republic of Ireland, installation must be in accordance with all

national and local regulations in force.

•Have the chimney swept prior to installation if it was previously used for solid fuel.

•Have the fire installed in accordance with the installation instructions

•Allow a minimum clearance of 90mm from the top of the appliance case to the

underside of any shelf whether it is made from combustible or non-combustible

materials. This clearance is necessary to allow the case to be lifted off for servicing and

also allows

sufficient

access to

operate the

control

knob. For a

shelf made

from wood

or other

combustible

materials

deeper than

150mm the

minimum

clearance

must be as

shown in

graph 1.

Please bear

this in mind

if ever you add a shelf.

•Provide a suitable guard that complies with BS 6539 or 6778 for the protection of

young children, the elderly and the infirm. Such a guard is also recommended for the

protection of pet animals. (Although this fire conforms to all the applicable standards, it

is a heating appliance and certain parts of its surface will become hot.)

Note: The guard supplied with the fire acts as a fireguard conforming to BS1945:1971

and satisfies the Heating Appliance (Fireguard) (Safety) Regulations 1991.

OWNER’S GUIDE

Page 5

•Wait three minutes before attempting to relight if the fire is switched off or the flames

are extinguished for any reason. (Your fire is fitted with a safety device that will

automatically shut off the gas supply to the fire if, for any reason, the flames go out.)

•Get advice about the suitability of any wall covering near your fire. Soft wall

coverings (e.g. embossed vinyl, etc.) which have a raised pattern are easily affected by

heat. They may, therefore, scorch or become discoloured when close to a heating

appliance. Please bear this in mind whenever you are considering redecorating.

•Provide a minimum clearance of 50mm between the outer case sides and any corner

wall having combustible material or other combustible surface which projects beyond the

front of the fire (See figure 1). Please bear this in mind if ever you are considering

altering the room.

DON’T

•Hang clothing, towels or any other fabrics over the fire.

•Fill in the space behind the case.

•Use the fire without the dress guard being in position.

•Attempt to clean or service the fire until it has been switched off and allowed to cool

completely.

•Use the fire with damaged radiants.

OWNER’S GUIDE

Page 6

Figure 1. Dimensions & clearances

APPLIANCE DIMENSIONS

OWNER’S GUIDE

Page 7

Figure 3. Pilot flame viewing

(Shown with Firelite case)

Figure 2. Control

OPERATING YOUR FIRE

PLEASE NOTE

When operating your fire for the first time, some vapours may be given off which may

cause a slight odour and could possibly set off any smoke alarms in the immediate

vicinity. These vapours are quite normal with new appliances. They are totally harmless

and will disappear after a few hours use.

The Oxysafe flame sensing & flue blockage safety system.

For your safety, this appliance is fitted with a flue blockage safety device that will shut

down the appliance in the event of abnormal flue conditions. This device is NOT a

substitute for an independently mounted Carbon

Monoxide detector.

The device will also automatically shut off the gas

supply to the fire if the pilot flame goes out due to

lack of oxygen or for any other reason.

If this device starts to repeatedly shut off the gas, get

expert advice.

This device incorporates a probe that senses that the

heat from the pilot flame is correct. If this probe is

cool, the device will prevent any gas flow unless the

control knob is held down at the ignition position.

If, for any reason, the flames go out when the fire is hot

or if the fire is turned off when hot, always wait at

least three minutes before attempting to relight.

To light the fire

The control is shown in Figure 2.

•Depress the control knob and turn anticlockwise

towards the 1/IGN position. A spark should be

generated at the pilot while turning. The spark

should ignite the pilot. If it does not, keeping the

knob depressed, continue to turn the knob

anticlockwise. A second spark should ignite the

pilot. The pilot flame can be seen through the

opening immediately below the centre radiant –

See figure 3.

If the pilot does not light, turn the knob back to

OFF and try again.

OWNER’S GUIDE

Page 8

In the unlikely event of failure of the ignition mechanism the pilot can be lit with a long

match or taper – See the next page.

•When the pilot has lit keep the knob depressed for about ten seconds to allow the flame

sensing probe to warm up.

•The control knob can then be set to your preferred heat level. The settings are:

Knob

Position

Radiants Condition

2 Centre radiant on low. Outer radiants off.

3 Centre radiant fully on. Outer radiants off.

4 Centre radiant fully on. Outer radiants on low.

5 All radiants fully on.

•To turn off partially depress the knob and turn clockwise to off. Wait at least three

minutes before attempting to relight.

Lighting with a match or taper

•Depress the control knob and turn anticlockwise towards the 1/IGN position.

•While keeping the knob depressed, light the pilot by inserting a long match or taper into

the pilot viewing opening (See figure 3).

•When the pilot is alight, keep the knob depressed for about ten seconds to allow the

flame sensing probe to warm up before setting to your preferred heat level.

•For your own convenience, have the heater serviced as soon as possible.

OWNER’S GUIDE

Page 9

Figure 4. Replacing radiant (Shown with Firelite case)

CLEANING

Turn the fire off and allow it to cool before attempting any cleaning.

Normally the fire will only need dusting. The bright metal trims may be cleaned with a

damp cloth and dried with a soft duster. Obstinate marks can be removed from the guard

and trims using soapy water. Never use abrasive cleaners.

The radiants can be cleaned with a soft brush - see below for how to remove the radiants.

REPLACING THE RADIANTS

See figure 4.

Always use the

correct type of

replacement radiant.

Ask for Valor part

number 0544649 (GC

No. 125 164).

•Turn the fire off

and allow it to cool

before attempting to

remove the radiants.

•Remove the dress

guard by pressing

down the two hooks at

the top. Tilt the guard

forward and lift out.

•Lift the radiant

upward to clear the

metal retaining bar

then pull out bottom

first.

•Fit the new radiant

by inserting its top

under the top lip of the

radiant box then swing

the bottom of the

radiant over and

behind the retaining bar. It is important that the back face of the radiant should rest

against the rear ribs in the firebox. There will be a small gap between the bottom

front edge of the radiant and the retaining bar.

OWNER’S GUIDE

Page 10

•Replace the dress guard. Locate the bottom of the dress guard in the two holes in the

bottom panel apron. Push the guard back so that the two spring projections at the top of the

guard engage in the slots under the front decorative canopy.

MAINTENANCE

Regular maintenance

In order to achieve and maintain high levels of personal safety and performance

efficiency, it is essential that the opening at the back of the fire and the flue are kept clear

of any form of obstruction. It is possible that deposits of mortar or soot could fall and

accumulate causing the flue to be blocked or restricted and so preventing proper

clearance of dangerous exhaust fumes.

In the United Kingdom it is the law that a landlord must have any gas appliance, flue and

pipework which is situated in a tenant’s premises checked for safety at least every twelve

months by a competent person (In the U.K., a CORGI registered installer).

We recommend that all gas appliances and their flues, wherever situated, are checked

annually.

Servicing

•In the United Kingdom servicing can be carried out either by a Valor Service engineer

or a CORGI registered installer.

•If you require your fire to be serviced, please contact Valor Service on 08706 090

081 and quote the following details;

a) Model, name and number.

b) Appliance serial no. (To be found on a label near the bottom of the right side of the

case.)

•If you wish to replace any radiants and do not know where they can be obtained

please contact Valor Spares on 08706 000 454 for your nearest stockist.

•In the United Kingdom, for general advice about gas and your gas fire call the

VALOR TECHNICAL HELPLINE 08706 061 065.

•In the Republic of Ireland call 0044 08706 061 065 for all enquiries.

Tabla de contenidos

Otros manuales de Chimenea de interior de Valor

Valor

Valor LT1 2500KN Manual de usuario

Valor

Valor HORIZON 534XAN Instrucciones de instalación

Valor

Valor 1000KP Guía de planificación

Valor

Valor 739TLK Traditional Log Kit Manual de usuario

Valor

Valor Sunfire 337 Manual de usuario

Valor

Valor 530 B Vent Manual de instalación y operación

Valor

Valor 1500IN Instrucciones de funcionamiento

Valor

Valor HORIZON 534JN Guía de planificación

Valor

Valor LEGEND G4 780JN (NG) Instrucciones de instalación

Valor

Valor 1700JN Instrucciones de funcionamiento

Valor

Valor 1149 Edgemont Double Doors Manual de usuario

Valor

Valor quantum BR644 VA Manual de usuario

Valor

Valor Legend G3.5 700IN Manual de usuario

Valor

Valor Portrait Series Manual de usuario

Valor

Valor 2100SFK Manual de usuario

Valor

Valor Brava 347 Manual de instrucciones

Valor

Valor 1470RGL Manual de usuario

Valor

Valor 1100MN Manual de usuario

Valor

Valor 719 Manual de usuario

Valor

Valor LX2 2200LKN Manual de usuario

Valor

Valor H6 Series Manual de usuario

Valor

Valor Tuscany 637 Manual de usuario

Valor

Valor L1 1500KN Manual de usuario

Valor

Valor Legend 739ILN Manual

Manuales populares de Chimenea de interior de otras marcas

Brigantia

Brigantia 35-DVRS31N-2 Manual del propietario

Nordpeis

Nordpeis Bergen Manual de usuario

Superior

Superior BCT2536TMN Manual de usuario

Quadra-Fire

Quadra-Fire 5100I-GD-B Manual de usuario

Renaissance

Renaissance RUMFORD 1000 Manual de usuario

Lacunza

Lacunza IV-800 Manual de usuario

Baxi

Baxi 940 Instrucciones de uso

Dru

Dru Maestro 60/2 Tall RCH Manual de usuario

Diamond Fireglass

Diamond Fireglass SS-O22 Manual de usuario

HearthStone

HearthStone Windsor Bay 8830 Manual de programación

Napoleon

Napoleon ASCENT B42 Manual de usuario

Enviro

Enviro E33GI Manual de usuario

Smeg

Smeg L30 FABE Instrucciones de montaje

KEDDY

KEDDY K700 Manual de usuario

Godin

Godin 3451 Manual de usuario

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Manual de usuario

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 Manual de usuario

Desa

Desa CCFPDFT Manual de operación