V-tech KidiGo NexTag Manual de usuario

Instruction Manual

INTRODUCTION

Thank you for purchasing the KidiGo™NexTag™! Active play just got

an upgrade. This high-tech way to play indoors and out includes games

that are so fun, you won’t mind being “it”!

Power Button

Speaker

Battery CoverColor Light Button

Home Button

Tag Button

Mode Selector Switch

(Red base unit only)

Up and Down

Buttons

Arm Band Slot

Arm Band

INCLUDED IN THE PACKAGE

• 4 KidiGo™NexTag™units* • 4 arm bands

• Game Instruction

• Quick Start Guide

*One 5355 and three 5355A.

WARNING

All packing materials such as tape, plastic sheets, packaging locks,

removable tags, cable ties, cords and packaging screws are not part of

this toy, and should be discarded for your child’s safety.

NOTE

Please save this Instruction Manual as it contains important information.

ATTENTION

Pour la sécurité de votre enfant, débarrassez-vous de tous les produits

d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,

étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.

NOTE

Il est conseillé de sauvegarder ce manuel d’utilisation car il comporte

des informations importantes.

Unlock the Packaging Locks

Rotate the packaging locks 90 degrees

counterclockwise.

Pull out the packaging locks and discard.

ASSEMBLY INSTRUCTIONS

With the KidiGo™ NexTag™, safety comes

rst. Adult assembly is required. For your child’s

safety, do not let them play with this toy until it

is fully assembled.

1. First, remove the Battery Cover. Install the

batteries into each unit.(See Battery Removal

and Installation section below for detailed

instructions.)

2. Next, slide the tail of the Arm Band through

the Arm Band Slot. Be sure to keep the top

of the buckle on the outside so it faces the top

of the KidiGo™ NexTag™ Unit.

3. Then, pull the end of the tail through the other

Arm Band Slot and over.

4. Slide the battery cover under the strap and

secure it in place before tightening the Arm

Band.

5. Thread the tail of the Arm Band up through

the buckle.

6. Finally, pull the end of the Arm Band through

the other slot of the buckle and under the tab.

7. Now, you’re ready to go!

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.

2. Locate the battery cover on the back of

each unit, use a screwdriver to loosen

the screw and open the battery cover.

3. Remove old batteries by pulling up on

one end of each battery.

4. Install 2 new AA (AM-3/LR6) batteries into each unit following the

diagram inside the battery box. (For best performance, alkaline

batteries or fully charged Ni-MH rechargeable

batteries are recommended.)

5. Replace the battery cover and tighten the screw

to secure.

Attention: The red KidiGo™NexTag™ Unit

is in Try Me mode. To exit this mode, follow the

steps below:

1. Press and hold the Power Button to turn off the unit.

2. Press and hold the Power Button for more than one second to turn

on the unit and activate normal play mode.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.

• Only batteries of the same or equivalent type as recommended are

to be used.

• Do not short-circuit the supply terminals.

• Remove batteries during long periods of non-use.

• Remove exhausted batteries from the toy.

• Dispose of batteries safely. Do not dispose of batteries in re.

RECHARGEABLE BATTERIES

• Remove rechargeable batteries (if removable) from the toy before

charging.

• Rechargeable batteries are only to be charged under adult

supervision.

• Do not charge non-rechargeable batteries.

WARNING:

Adult assembly required for battery installation.

Keep batteries out of reach of children.

ATTENTION :

Les piles ou accumulateurs doivent être installés

par un adulte.

Tenir les piles ou accumulateurs hors de portée

des enfants.

PRODUCT FEATURES

1. Power Button

Turn the unit On by pressing the Power

Button. Press the Power Button again to

turn the unit Off.

2. Home Button

Press the Home Button to return to the

previous menu or select a game.

3. Up and Down Buttons

Press the Up and Down Buttons to scroll

through the game options.

4. Tag Button

When selecting a game, press the Tag Button

to confirm a selection. During gameplay,

players press the Tag Button to tag another

player or according the rules of each game.

5. Color Light Button

The Color Light Button will light up with

different colors to indicate game responses.

Press the Color Light Button as instructed

during some game play.

6. Mode Selector Switch

If you have an additional KidiGo™NexTag™ system (sold

separately), slide the Mode Selector Switch on one of the red

base units to pair them. Games can be played with 5-8 players.

7. Automatic Shut-Off

When idle for 1 minute the KidiGo™NexTag™ Units will turn off

automatically to conserve battery life. If it is in a game, there will

be no idle time and will not auto-shut off.

ACTIVITIES

1. Elimination Tag

One person is assigned the role of tagger. This is indicated by a

ashing white light on the tagger’s KidiGo™NexTag™Unit. The

tagger has ve minutes to try and tag the other players. When a

player is tagged, they are out. At the end of ve minutes if any

players remain, they are the winners.

*For playing with two combined sets and more than ve players, the system

will designate two taggers and the game will last a maximum of ten minutes.

2. You’re “It”

One person is assigned the role of tagger. This is indicated by

a ashing white light on the tagger’s KidiGo™NexTag™Unit.

When they tag a player, that person becomes the new tagger.

The player who is the tagger at the end of ve minutes loses and

the others win.

3. Zombie Tag

One player is assigned the role of zombie. This is indicated by a

ashing white light on the tagger’s KidiGo™NexTag™Unit. When

they tag a player, that player also becomes a zombie and can tag

other players to turn them into zombies. If the zombie team cannot

tag a human for one minute at any point, the humans win. If there

are more zombies than humans, the humans will have 30 seconds

to try to survive and win, otherwise the zombies win.

4. Secret Mission

Each player’s Color Light Button will indicate the color of the

other player who they must tag. When a player is tagged, the

game pauses and everyone is given a new target, as indicated by

the new color shown on each player’s Color Light Button. When

there are only two players left, they must duel and be the rst one

to tag the other’s KidiGo™NexTag™Unit. The game time limit

is 10 minutes.

*When playing with two combined sets and more than ve players, there

may be two targets with the same color. The tagger can tag either opponent.

5. Freeze Tag

One person is assigned the role of tagger. This is indicated by a

ashing white light on the tagger’s KidiGo™NexTag™Unit. The

tagger’s goal is to try to tag and freeze all the other players within

the ten-minute time limit. Once a player is tagged, they are frozen

and must remain in place. The frozen player can press and hold

their own Color Light Button for 30 seconds to unfreeze and

resume playing. At the end of the time limit, if all players except the

tagger are frozen, the tagger wins. Otherwise, the other players win.

*When playing with two combined sets and more than ve players, there will

be two taggers who can work together.

6. Capture the Flag

Players must rst divide into two teams, Team A and Team B. Team

A will use the red and blue KidiGo™NexTag™Units, and Team

B the green and orange. The units with solid lights are the bases,

and the units with ashing lights are the ags. To get ready to play,

each team should place their base approximately 15 to 20 feet away

from a center line that divides the teams’ territories and hide their

ags on their own side. Once the game begins, each team’s goal

is to retrieve the ags from the other side and bring them back to

their base. To register that a ag has been captured, press the ag

and base’s Color Light Buttons at the same time. When a player

crosses the dividing line into the other team’s territory, the player

can be tagged by the other team. Depending on the rules players

agree to, once a player is tagged, they may either return to their

own side, or be placed in a “jail” to wait until their teammate can

free them with a tag. KidiGo™NexTag™Units in this game are

only used as ags and bases and are not worn. The game ends

when one team secures all of the other team’s ags. The game

time limit is 10 minutes.

7. Dino Defense

In this game, the cavepeople must try and sneak eggs away from

the dinosaur to bring back to their cave. Players must rst decide

who will be the dinosaur. The cavepeople will use the red KidiGo™

NexTag™Unit as their “cave”, and the other units will be the “eggs”

that the dinosaur must spread out and defend. To register that an

egg has been brought back to the cave, a caveperson must press

and hold the Color Light Button on both the cave and egg units

simultaneously for ve seconds. Once an egg has been brought back

to the cave, it cannot be removed. If a cave person is tagged by the

dinosaur on their way back to the cave, the eggs they’re carrying

Tabla de contenidos

Otros manuales de Juguete de V-tech

V-tech

V-tech KidiStar Dance Instrucciones de montaje

V-tech

V-tech Go! Go! Cory Carson Fire Rescue Freddie Manual de usuario

V-tech

V-tech Fox & Friends Gift Set Manual de usuario

V-tech

V-tech Zoo Jamz Guitar Manual de usuario

V-tech

V-tech Go! Go! Cory Carson The Carson Playhouse Instrucciones de montaje

V-tech

V-tech Marble Rush Starter Set Instrucciones de montaje

V-tech

V-tech PC Mouse Manual de usuario

V-tech

V-tech KidiCreative Kidi ART Studio Manual de usuario

V-tech

V-tech Busy Books Manual de usuario

V-tech

V-tech Toot-Toot Drivers Big Vehicle Carrier Instrucciones de montaje

V-tech

V-tech MobiGo Game Storage Manual de usuario

V-tech

V-tech Barks & Beats Pups Manual de usuario

V-tech

V-tech Play & Learn Tree House Manual de usuario

V-tech

V-tech Slide & Talk Smart Phone Manual de usuario

V-tech

V-tech Hop-a-Roo Kangaroo Instrucciones de montaje

V-tech

V-tech MobiGo Disney Princess Manual de usuario

V-tech

V-tech 80-032301 - Write Learn SMARTBOARD Manual de usuario

V-tech

V-tech Sing n Smile Pals Manual de usuario

V-tech

V-tech Stacking Animal Squares Manual de usuario

V-tech

V-tech Power Vision Manual de usuario

V-tech

V-tech Marble Rush Discovery Starter Set Manual de usuario

V-tech

V-tech SWITCH&GO DIONS Burnout the Velociraptor Manual de usuario

V-tech

V-tech Switch & Go Velociraptor Racer Instrucciones de montaje

V-tech

V-tech DREAMWORKS Gabby's Dollhouse Pandy Paws' Paw-Tastic... Manual de usuario

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

Canon

Canon PAPER CRAFT Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario