V-tech bs2425 Manual de usuario
1
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury, including
the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4. Do not use this product near water (for example, near a bath tub, kitchen
sink, or swimming pool).
5. Do not place this product on an unstable cart, stand, or table. The product
may fall, causing serious damage to the product.
6. Slots and openings in the cabinet and the back or bottom are provided
for ventilation. To protect it from overheating, these openings must not
be blocked by placing the product on the bed, sofa, rug, or other similar
surface. This product should never be placed near or over a radiator
or heat register. This product should not be placed in a built-in installation
where proper ventilation is not provided.
7. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power
supply to your home, consult your dealer or local power company.
8. Do not allow anything to rest on the power cord. Do not locate this product
where the cord will be abused by persons walking on it.
9. Never push objects of any kind into this product through cabinet slots
as they may touch dangerous voltage points or short out parts that could
result in a risk of fire or electric shock. Never spill liquid of any kind on
the product.
10. To reduce the risk of electric shock, do not disassemble this product,
but take it to an authorized service facility. Opening or removing cabinet
parts other than specified access doors may expose you to dangerous
voltages or other risks. Incorrect reassemb-ling can cause electric shock
when the appliance is subsequently used.
11. Do not overload wall outlets and extension cords as this can result in
the risk of fire or electric shock.
Important Safety Instructions
2
12. Unplug this product from the wall outlet and refer servicing to an
authorized service facility under the following conditions:
A. When the power supply cord or plug is damaged or frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions, because improper adjustment of other
controls may result in damage and will often require extensive work
by an authorized technician to restore the product to normal
operation.
E. If the product has been dropped and the cabinet has been damaged.
F. If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lighting.
14. Do not use the telephone to report a gas leak in the vicinity of the leak.
CAUTION:TOREDUCETHERISKOFFIREORINJURYTOPERSONSBY
BATTERY,READANDFOLLOWTHESEINSTRUCTONS.
1. Use only the appropriate type and size battery pack specified in the
instruction manual provided for this product.
2. Do not dispose of the battery pack in a fire. The cell may explode. Check
with State and local codes for possible special disposal instructions.
3. Do not open or mutilate the battery pack. Released electrolyte is corrosive
and may cause damage to the eyes or skin. It may be toxic if swallowed.
4. Exercise care in handling battery in order not to short the battery with
conducting materials such as rings, bracelets, and keys. The battery or
conductor may overheat and cause burns.
5. Charge the battery pack provided with or identified for use with this
product only in accordance with the instructions and limitations specified
in the struction manual.
6. Observe proper polarity orientation between the battery pack and battery
charger.
3
The 2425 is an advanced cordless telephone that operates in the 2.4GHz
frequency range. Your 2425 is capable of supporting up to a maximum of
4 Handsets. Using additional Handsets, two extensions can be conferenced
on a call (2 Handsets and the Base Speakerphone), or two extensions can
be conferenced on a call, while two other extensions can be talking internally,
using the Intercom feature.
This manual is designed to familiarize you with the 2425 cordless telephone.
We strongly recommend you read the manual before using your phone.
Introduction
4
Parts Check List
5. Belt Clip
6. Battery Pack
7. Wall Mounting Bracket
8. Owner's Manual
1. Handset
2. Base Unit
3. AC Power Adapter
4. Telephone Line Cord
5
The Handset Layout
1. Antenna
2. MessageWaitingIndicator
3. Earpiece
4. Headset Jack (2.5mm)
5. Scroll Keys
6. On (Flash)
7. Dialing Keys
8. Handsfree Speakerphone
9. LCD Display
10. Select
11. Off (Clear)
12. Battery Compartment
13. Intercom
14. Billed Services
15. Microphone
6
Follow the steps below:
1. Remove the battery cover by
pressing on the indent and
sliding downward.
2. Place the new battery pack in
the handset with the metal
contacts aligned with the charge
contacts in the battery
compartment.
3. Replace the battery cover by
sliding it upwards.
4. If the new battery pack is not
already charged, place the
handset in the base unit, or a
remote charging stand, and
allow it to charge for 12 hours.
After initial charge, a
maintenance charge of 8 hours
should be sufficient.
Setup
1. Plug the AC power adapter into an electrical outlet, and the DC connector
into the bottom of the base unit.
GettingStarted
Installation of Battery Pack in
Handset
7
GettingStarted
Charging Of Handset Battery Pack
The Handset of your 2425 cordless telephone is powered by a rechargeable
battery pack. It charges automatically whenever the Handset is in the Base
Unit.
You should charge the battery pack for 12 hours when you first receive
your phone. You'll know the battery pack needs charging when:
• The low battery message is
displayed :
• The handset seems completely
dead, the LCD is completely
clear and does not activate
when you press the keys.
IMPORTANT:
1. Do not dispose of a battery pack in a fire, the cell may explode.
2. Do not open or mutilate the battery pack. Toxic substances may be
released, causing harm to eyes or skin.
3. Exercise care in handling battery packs in order to prevent an accidental
short of the charge contacts, potentially causing the battery pack to
overheat.
4.Do not dispose of this battery pack into household garbage. Please
contact your local, state or municipal recycling organization for
information on how to properly dispose of your rechargeable battery pack.
Setup
8
GettingStarted
Connecting to phone line
Plug one end of the telephone line cord into the jack on the bottom of the
base unit. Plug the other end of this cord into the wall jack.
Checking for dial tone
After the battery is charged press ON on the Handset. The Phone icon
will appear on the handset display, and you will hear dial tone. If not, see
In Case of Difficulty.
Tone/Pulse selection
The TONE/PULSE switch is located on the bottom of the Base Unit, near the
telephone jack. It is factory set to TONE. If you have rotary (Pulse) service,
set the switch to PULSE.
CAUTION: Use only the power supply provided with your 2425.
IMPORTANT:
For best performance the 2425
should be installed as follows:
In an elevated location, in the center of
the room, with no obstructions nearby.
In a location that is away from other
electrical appliances such as microwave
ovens, personal computers, or
televisions.
Setup
9
Wall Mounting
The Wall Mount bracket is designed
for use on standard Wall Mount
plates only.
1. Line up the tabs on the wall
mount adapter with the holes
on the bottom of the Base Unit.
Snap the wall mount bracket
firmly in place.
2. Plug the AC adapter into an
electrical outlet, and the DC
connector to the bottom of the
Base Unit. If the handset battery
pack has not been charged
previously, place the handset in
the base unit cradle, and allow
it to charge for 12 hours.
3. Connect the telephone line cord
to the jack on the bottom of the
Base Unit, and the other end to
the wall jack.
4. Mount the base unit on the wall.
Position the base unit so the
mounting studs will fit into the
holes on the wall mount bracket.
Slide base unit down on the
mounting studs until it locks
into place.
GettingStarted
10
Registration and Operation
Registration And Operation Of The 2425 Accessory Handset
Your 2425 system can operate up to 4 Handsets.
The accessory Handset, model 2422, consists of the following:
Setup Of The 2422 Accessory
Handset
1. Plug the AC power adapter into
an electrical outlet.
2. Remove the Handset battery
cover by pressing on the indent
and sliding downward.
3. Place the new battery pack in
the Handset, with the metal
contacts aligned with the charge
contacts in the battery
compartment.
4. Replace the battery cover by
sliding it upward.
5. Place the Handset in the Charge
Cradle, and allow it to charge for
12hours. After theinitial charge,
a maintenance charge of 8
hours should be sufficient.
GettingStarted
The original Handset that is shipped with your 2425 system will be automatically
registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER
BASE ID to register the new Handset.
Otros manuales para bs2425
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Teléfono de V-tech
V-tech
V-tech ErisTerminal VSP715 Manual de usuario
V-tech
V-tech ErisTerminal VSP610AErisTerminal VSP608A Manual de usuario
V-tech
V-tech LS6181 Manual de usuario
V-tech
V-tech Contemporary Series A2100 Manual de usuario
V-tech
V-tech ip5856 Guía de configuración
V-tech
V-tech i6764 Manual de usuario
V-tech
V-tech CareLine SN1157 Manual de usuario
V-tech
V-tech CS5111 Manual de usuario
V-tech
V-tech ErisTerminal VSP608A Manual de usuario
V-tech
V-tech i6763 Manual de usuario
V-tech
V-tech 8121 Manual de usuario
V-tech
V-tech LS6204 - Cordless Extension Handset Manual de usuario
V-tech
V-tech ErisTerminal VSP875G Manual de usuario
V-tech
V-tech FS6608A Manual de usuario
V-tech
V-tech CD1261 Manual de usuario
V-tech
V-tech ErisStation VCS752 Manual de instrucciones
V-tech
V-tech CS6319 Manual de usuario
V-tech
V-tech ia5845 Manual de usuario
V-tech
V-tech VSP735 Manual de usuario
V-tech
V-tech i6786 - 5.8 Ghz 4 Handsets Cordless Phone... Manual de usuario
