V-tech LS6305 Manual de usuario

User’s manual

Accessory handset for

use with VTech models

LS6315/LS6315-2/

LS6315-3/LS6325/

LS6325-2/LS6325-3/

LS6325-4/LS6325-5/

LS6326-5

Model: LS6305

Congratulations

on purchasing your new VTech product. Before using this telephone, please

read the Important safety instructions on page 10 of this manual.

This manual has all the feature operations and troubleshooting necessary

to install and operate your new VTech telephone. Please review this manual

thoroughly to ensure proper installation and operation of this innovative and

feature rich VTech product. For support, shopping, and everything new at

VTech, visit our website at www.vtechphones.com.

In Canada, please visit

www.vtechcanada.com.

The ENERGY STAR®program (www.energystar.gov) recognizes

and encourages the use of products that save energy and help

protect our environment. We are proud to mark this product with

the ENERGY STAR®label indicating it meets the latest energy

efciency guidelines.

Table of contents

Getting started .............................. 1

Parts checklist................................. 1

Battery installation .......................... 2

Battery charging.............................. 3

Add and register a handset ............. 4

Replace a handset .......................... 5

Handset layout ................................ 6

Appendix........................................ 9

Battery............................................. 9

Important safety instructions......... 10

Precautions for users of

implanted cardiac pacemakers ..... 11

Operating range ............................ 11

Maintenance.................................. 12

About cordless telephones............ 13

The RBRC®seal............................ 13

Warranty........................................ 14

FCC, ACTA and IC regulations ..... 16

Technical specications ................ 18

Parts checklist

Your telephone contains the following items. Save your sales receipt and

original packaging in the event warranty service is necessary.

User’s manual

Handset

Charger and charger adapter

BatteryBattery compartment cover

Getting started

To purchase replacement batteries or power adapters, visit our website at

www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to

www.vtechcanada.com or dial 1 (800) 267-7377.

Getting started

CHARGE

light

Battery installation

Install the battery as shown below.

If the battery compartment cover is on the handset, press on the grooved

tab and slide the cover to remove.

Plug the battery connector securely into the socket inside the handset

battery compartment, matching the color-coded label.

Place the battery with the label THIS SIDE UP facing up and the wires

inside the battery compartment.

Align the cover at against the battery compartment, then slide it towards

the center of the handset until it clicks into place.

Charge the handset by placing it in the telephone base or charger. The

CHARGE light is on when the handset charges.

If the handset will not be used for a long time, disconnect and remove the

battery to prevent possible leakage.

To purchase replacement batteries, visit our website at

www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to

www.vtechcanada.com or dial 1 (800) 267-7377.

•

Getting started

Battery charging

Once you have installed the battery, the screen indicates the battery status

(see the table below). If necessary, place the handset in the telephone base

or charger to charge the battery. For best performance, keep the handset in

the telephone base or charger when not in use. The battery is fully charged

after 16 hours of continuous charging. See the table on page 9 for battery

operating times.

If the screen is blank or shows Place in charger, you need to charge the

handset without interruption for at least 30 minutes to give the handset

enough charge to use the telephone for a short time. When the battery is low,

the handset shows Low battery and a ashing icon. If you are on a call in

low battery mode, the handset plays short beeps to alert you.

The following table summarizes the battery charge indicators and actions

to take.

Battery indicators Battery status Action

The screen is blank

or shows Place in

charger and ashes.

Battery has very little or

no charge. The handset

cannot be used.

Charge without interruption (at

least 30 minutes).

The screen shows

Low battery and

ashes.

Battery has enough

charge to be used for a

short time.

Charge

without interruption

(about 30 minutes).

The screen shows

HANDSET X.

Battery is charged. To keep the battery charged,

place it in the telephone base

or charger when not in use.

If you do not plug in the battery into the handset and place it in the telephone base

or charger, the screen displays No battery.

Getting started

Add and register a handset

Each newly purchased handset (LS6305) must be registered to the

telephone system (LS6315/LS6325/LS6305) before use. When rst

purchased, each handset shows

1.Press FIND HS on base 4sec and

2.Then press # on handset

alternately. You may need to charge the

handset before registering it to the telephone base. For more details on

battery charging, see page 3.

To make registration easier, read all of the instructions on this page before

you begin.

To register a handset:

Place the unregistered handset in the telephone base or charger. If

1.Press FIND HS on base 4sec and 2.Then press # on handset do not

appear alternately on the handset screen after a few seconds, remove the

handset and place it in the telephone base or charger again.

On the telephone base, press and hold

/FIND HANDSET for about four seconds until the red

IN USE light on the telephone base turns on.

Remove the handset from the telephone base or charger

and then press #. It displays Registering...Please wait.

It takes about 10 seconds to complete the registration.

The handset shows HANDSET X Registered and you

hear a beep when the registration completes.

When the registration is complete, the newly registered

handset is assigned the next available handset registration

number. For instance, if you already have HANDSET 1, the

next registered handset will be HANDSET 2.

If the registration fails, the handset displays Registration

failed for a few seconds, then 1.Press FIND HS on

base 4sec and 2.Then press # on handset alternately.

To reset the handset, remove it from the telephone base

and place it back in. Try the registration process again.

You cannot register a handset if any other system

handset is in use.

Only one handset can be registered at a time.

•

Getting started

Replace a handset

If you want to replace a handset or reassign the designated handset number

of a registered handset, you must deregister all the handsets and then

individually register each handset.

To make deregistration easier, read all of the instructions on this page before

you begin.

To deregister all handsets:

Press and hold /FIND HANDSET on the telephone base for about

10 seconds until the IN USE light on the telephone base turns on and

starts to ash.

Press and release /FIND HANDSET again. You must press

/FIND HANDSET while the IN USE light is still ashing. The IN USE light

ashes for approximately seven seconds.

The deregistration process takes about 10 seconds to complete. All

handsets show 1.Press FIND HS on base 4sec and 2.Then press # on

handset

alternately

when the deregistration completes.

If deregistration fails, you may need to reset the telephone and try again.

To reset:

Pick up the registered handset and then press /FLASH.

Press OFF/CLEAR and place the handset in the telephone base.

-OR-

Unplug the power from the telephone base, then plug it back in.

You cannot deregister a handset if any system handset is in use.

Getting started

/ VOL (directory/volume)

Press to enter the directory when the telephone

is not in use.

While in a menu, press to scroll up.

During a call, press to increase the listening

volume.

Handset layout

CHARGE light

On when the handset is charging in the

telephone base or charger.

While reviewing a call log entry, press

repeatedly to add or remove 1in front of the

telephone number before dialing or saving it in

the directory.

/FLASH

Press to make or answer a call.

During a call, press to answer an incoming call

when you receive a call waiting alert.

REDIAL/PAUSE

Press to review the redial list.

While dialing or entering numbers into

the directory, press and hold to insert a

dialing pause.

(speakerphone)

Press to make or answer a call.

During a call, press to switch between

speakerphone and handset.

TONE

With the phone set for pulse dialing, press to

temporarily change to tone dialing while on a

call.

Handset layout

Getting started

MENU/SELECT

Press to show the menu.

While in a menu, press to choose an item, or

save an entry or setting.

OFF/CLEAR

During a call, press to hang up.

While the handset is ringing, press to silence

the ringer temporarily.

While the telephone is not in use,

press and hold to erase the missed

calls indicator.

During programming, press to exit without

making changes.

Press repeatedly to show other dialing options

when reviewing a call log entry.

MUTE/REMOVE

While on a call, press to mute the microphone.

While reviewing the call log, directory or redial

list, press to delete an individual entry.

While predialing, press to delete digits.

During an outside call or intercom call, press

to change the audio quality to best suit your

hearing.

VOL/CID (volume/caller ID)

Press to review the call log when the telephone

is not in use.

While in a menu, press to scroll down.

During a call, press to decrease the listening

volume.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Teléfono inalámbrico de V-tech

V-tech

V-tech DECT 6.0 LS6315 Series Manual de usuario

V-tech

V-tech IP8300 Manual de usuario

V-tech

V-tech CS6529 Manual de usuario

V-tech

V-tech CS6519 Manual de usuario

V-tech

V-tech i 5807 Manual de usuario

V-tech

V-tech CS6114 Manual de usuario

V-tech

V-tech I6787 Manual de usuario

V-tech

V-tech 80-6101-00 Manual de usuario

V-tech

V-tech i 5871 Manual de instrucciones

V-tech

V-tech ia5865 Manual de usuario

V-tech

V-tech SN6187 Manual de usuario

V-tech

V-tech CS5119-17 Manual de usuario

V-tech

V-tech VT9011 Manual de usuario

V-tech

V-tech DS6221 Manual de usuario

V-tech

V-tech CS6529 Manual de usuario

V-tech

V-tech DS6673 Manual de usuario

V-tech

V-tech CS6629 Manual de usuario

V-tech

V-tech CS6124 Manual de usuario

V-tech

V-tech IA5864 Manual de usuario

V-tech

V-tech LS6205 - Cordless Extension Handset Manual de usuario

V-tech

V-tech CS6729-37 Manual de usuario

V-tech

V-tech I 5858 Manual de usuario

V-tech

V-tech DS6321 Manual de usuario

V-tech

V-tech gz5838 Manual de usuario

Manuales populares de Teléfono inalámbrico de otras marcas

3Com

3Com NBX Manual de usuario

Panasonic

Panasonic KX-TGK210HK Manual de usuario

Panasonic

Panasonic KX-TCA181EX Manual de usuario

BT FREESTYLE 3200 Manual de usuario

AT&T

AT&T CL84102 Manual de usuario

BREZZICNI

BREZZICNI CL-3622 Manual de usuario

Panasonic

Panasonic KX-TG1831NZ Manual de usuario

Panasonic

Panasonic KX-TG7301E Manual de usuario

Furuno

Furuno FM-4721 Manual de usuario

Sanyo

Sanyo CLT-J70 Manual de usuario

Amplicomms

Amplicomms BigTel 201 Manual de usuario

GE 26992 Manual de usuario

AT&T

AT&T E1812B Manual de usuario

Sanyo

Sanyo CLT-670 Manual de usuario

GE 15432970 Manual de usuario

Curtis

Curtis TC595 Manual de usuario

Gigaset

Gigaset Gigaset 3000 Micro Manual de usuario

Poly

Poly VVX D230 Guía de configuración