V-tech LS1650-B Manual de usuario

User’s manual

www.euphones.vtech.com

LS1650-B

1. IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions should always

be followed to reduce the risk of re, electric shock and injury, including the

following:

Read and understand all the instructions.

Follow all warnings and instructions marked on the product.

Unplug this product from the wall outlet before cleaning. Do not use liquid

cleaners or aerosol cleaners. Use a damp cloth for cleaning.

Do not use this product near water (for example, near a bath tub, kitchen

sink, swimming pool).

Do not expose the telephone to direct sunlight or extreme cold environment.

Do not put the telephone close to heating sources such as radiators,

cookers, etc.

Do not overload wall outlets and extension cords as this can result in the risk

of re or electric shock.

Unplug this product from the wall outlet and refer servicing to VTech/

distributor under the following conditions:

When the power supply cord or plug is damaged or frayed.

If the product does not operate normally by following the operating

instructions.

If the product has been dropped and the cabinet has been damaged.

If the product exhibits a distinct change in performance.

Avoid using a telephone (other than a cordless type) during an electrical

storm. There may be a remote risk of electric shock from lightning.

Do not use the telephone to report a gas leak in the vicinity of the leak.

Use only the supplied NiMH (Nickel Metal Hydride) batteries! The operation

periods for the handsets are only applicable with the default battery

capacities.

The use of other battery types or non-rechargeable batteries/primary cells

can be dangerous. These may cause interference and/or unit damages. The

manufacturer will not be held liable for damage arising from such

non-compliance.

Do not use third party charging bays. The batteries may be damaged.

Please note the correct polarity while inserting the batteries.

Battery should not be exposed to excessive heat such as bright sunshine or

re and immersed in water.

•

10.

11.

12.

13.

14.

DISPOSAL WARNING

When this crossed-out wheeled bin symbol is attached to a

product, it means the product is covered by the European

Directive 2002/96/EC.

All electrical and electronic products/battery should be disposed

of separately from the municipal waste stream via designated

collection facilities appointed by the government or the local

authorities.

The correct disposal of your old appliance/battery will help prevent potential

negative consequences for the environment and human health.

For more detailed information about disposal of your old appliance/battery,

please contact your city ofce, waste disposal service or the shop where you

purchased the product.

If you have questions about this product, or having difculty with setup or

operation, contact our Customer Service Centre.

POWER ADAPTOR INFORMATION

Power adaptor Charger:

Vtech (Qingyuan) Plastics & Electronics Co. Ltd. - Model:

VT04EEU06045,

Input 100-240V AC 50/60Hz 150mA, Output 6VDC 450mA

(EU plug).

Ten Pao International Ltd. - Model: S003IV0600045,

Input 100-240V AC 50/60Hz 150mA, Output 6VDC 450mA

(EU plug).

Base:

Vtech (Qingyuan) Plastics & Electronics Co. Ltd. - Model:

VT04EEU06045/VT04EUK06045,

Input 100-240V AC 50/60Hz 150mA, Output 6VDC 450mA

(EU/UK plug).

Shenzhen Ruijing International Ltd. - Model: RJ-

AS060450E002/RJ-AS06045B001,

Input 100-240V AC 50/60Hz 150mA, Output 6VDC 450mA

(EU/UK plug).

Battery AAAx2, Ni-MH, 400mAh.

For pluggable equipment, the socket outlet shall be installed near the equipment

and shall be easily accessible.

2. SET UP THE TELEPHONE

2.1 Package Contents

The package contains the following items:

1 Handset

1 Base station

1 Power adaptor for base station

1 Charger with power adapter

1 Telephone line cord

2 AAA NiMH rechargeable batteries

1 User’s manual

2.2 Connect the Corded Base Station

•

Plug the corded

handset cord into the

corded handset jack

on the back of the

telephone base.

Click the wall mount

bracket securely into

the mounting slots for

tabletoap use.

Route the power

adapter cord through

this slot.

Plug the large end of

the telephone base

power adapter into a

power outlet.

Plug one end of the

telephone line cord

into a telephone jack

or a DSL lter.

If you have DSL

high-speed Internet

service, a DSL lter

(not included) is

required.

Route the telephone

line cord through this

slot.

Plug the small end of

the telephone base

power adapter into

the power adapter

jack on the back of

the telephone base.

Plug the other end of the telephone

line cord into the telephone jack on

the back of the telephone base.

NOTE

Use only the supplied power adapter.•

2.3 Connect the Charger

Plug the power adapter

into a power outlet.

NOTE

Use only the supplied power adapter.•

2.4 Install and Charge the Handset Battery

NOTES

Use only the supplied AAAx2, Ni-MH, 400mAh batteries.

If you do not use the handset for a long time, disconnect and remove the

battery to prevent possible leakage.

•

2.5 Installation options

Your telephone base is ready for tabletop use. If you want to mount your on a wall,

follow the steps to connect the telephone base with a standard dual-stud telephone

wall mounting plate. You may need a professional to install the mounting plate.

2.5.1 Tabletop to Wall Mount Installation

Unplug the power adapter from the power outlet. Unplug the telephone line

cord from the wall jack (or DSL lter).

Put the corded handset aside. Hold down the switch hook on the base, and

then slide the handset tab upwards to remove it from the slot. Rotate the

handset tab by 180 degrees. Then, replace the handset tab into the slot until it

locks into position.

Press down on the tabs of the wall mount bracket to release it from tabletop

orientation.

Rotate the wall mount bracket down and push it into the telephone base until it

clicks into place.

Plug the telephone line cord (or DSL lter) into the wall jack. Plug the power

adapter into a power outlet. Align the slots on the back of the telephone base

with the studs of the wall mounting plate.

Slide the telephone base down until it locks securely. Bundle the telephone

line cord and power adapter cord neatly with twist ties.

21 3

Rotate

Press down

Slide

up Slide

down

UnplugUnplug

Rotate

Plug

Align

Plug

54 6Slide

down

2.5.2 Wall Mount to Tabletop Installation

Unplug the power adapter from the power outlet. Unplug the telephone line

cord from the wall jack (or DSL lter). If the telephone line cord and power

adapter cord are bundled, untie them rst. Push the telephone base up to

remove it from wall.

Put the corded handset aside. Hold down the switch hook on the telephone

base, and then slide the handset tab upwards to remove it from the slot.

Rotate the handset tab by 180 degrees. Then, replace the handset tab into the

slot until it locks into position.

Gently pull upward to release the wall mount bracket. Rotate the wall mount

bracket up to tabletop position and push it into the telephone base until it clicks

into place.

Plug the telephone line cord (or DSL lter) into the wall jack. Plug the power

adapter into an power outlet. Bundle the telephone line cord and power

adapter cord neatly with twist ties if necessary.

1 2

3 4

Slide

Rotate

Slide

up Slide

down

Rotate

Plug Plug

3. GET TO KNOW YOUR PHONE

3.1 Overview of the Handset

1. / – VOLUME UP/VOLUME DOWN

2. M1 / M2 – DIRECT MEMORY KEYS

Press and hold to dial the number stored in the memory key.

3. R – FLASH (RECALL)

In predial mode or during a call: Press to insert a Flash.

4. – CLEAR/BACK/MUTE/INTERCOM

5. – UP/CALL LOG

6. – TALK OFF

7. – DOWN/REDIAL LIST

8. ALPHANUMERIC KEYPAD, *, #

Press to insert a digit / character / */ #

1key in idle mode: Press and hold to access the voice mail.

*key in idle mode: Press and hold to enable or disable the keypad lock.

*key during a call (in Pulse mode): Press to switch to tone mode.

# key in idle mode: Press and hold to turn on / off the ringer.

0 key in predialing / number editing mode: Press and hold to insert a pause.

# key in Call Log mode: Press to review caller’s number if applicable.

9. MICROPHONE

10. – TALK/SPEAKERPHONE

11. – MENU/OK

12. – AMPLIFY

13. LED

Steadily on when the audio boost is turned on.

Flashes when there is an incoming call.

14. EARPIECE

Otros manuales para LS1650-B

Tabla de contenidos

Otros manuales de Teléfono inalámbrico de V-tech

V-tech

V-tech VT 9114 Manual de usuario

V-tech

V-tech DS6621 Manual de usuario

V-tech

V-tech CS6719 Manual de usuario

V-tech

V-tech ip5850 - 5.8 GHz DSS Cordless Phone Manual de usuario

V-tech

V-tech DS6151 - 6.0 Expandable Cordless Phone Manual de usuario

V-tech

V-tech gz 2334 Manual de usuario

V-tech

V-tech VT 2961 Manual de usuario

V-tech

V-tech ia5829 - Cordless Phone - Operation Manual de usuario

V-tech

V-tech CS6124 Manual de usuario

V-tech

V-tech T2351 Manual de usuario

V-tech

V-tech vt1712 Manual de usuario

V-tech

V-tech t2151 - Cordless Phone - Operation Guía del usuario

V-tech

V-tech VTECH LS6425 Manual de usuario

V-tech

V-tech i6725 Manual de usuario

V-tech

V-tech CS6859 Manual de usuario

V-tech

V-tech CS6319 Manual de usuario

V-tech

V-tech T2455 - 2.4GHz Dual Handset Cordless Phone... Manual de usuario

V-tech

V-tech MI6821 - Cordless Telephone With Caller Id Guía del usuario

V-tech

V-tech VT 1932 Manual de usuario

V-tech

V-tech 6032 Guía de configuración

V-tech

V-tech i 5871 Manual de instrucciones

V-tech

V-tech CS5111-3 Manual de usuario

V-tech

V-tech Cordless Telephone Manual de usuario

V-tech

V-tech LS6245 Manual de usuario

Manuales populares de Teléfono inalámbrico de otras marcas

3Com

3Com NBX Manual de usuario

Panasonic

Panasonic KX-TGK210HK Manual de usuario

Panasonic

Panasonic KX-TCA181EX Manual de usuario

BT FREESTYLE 3200 Manual de usuario

AT&T

AT&T CL84102 Manual de usuario

BREZZICNI

BREZZICNI CL-3622 Manual de usuario

Panasonic

Panasonic KX-TG1831NZ Manual de usuario

Panasonic

Panasonic KX-TG7301E Manual de usuario

Furuno

Furuno FM-4721 Manual de usuario

Sanyo

Sanyo CLT-J70 Manual de usuario

Amplicomms

Amplicomms BigTel 201 Manual de usuario

GE 26992 Manual de usuario

AT&T

AT&T E1812B Manual de usuario

Sanyo

Sanyo CLT-670 Manual de usuario

GE 15432970 Manual de usuario

Curtis

Curtis TC595 Manual de usuario

Gigaset

Gigaset Gigaset 3000 Micro Manual de usuario

Poly

Poly VVX D230 Guía de configuración