UNINEX KoolBase MSC1800NE Manual de usuario
USER MANUAL
MSC1800NE
A PORTABLE STREAM OF AIR FOR
INDOOR AND OUTDOOR USE
KoolBase
MOBILE SPOT COOLER
THANK YOU FOR PURCHASING THE KOOLBASE MOBILE SPOT COOLER.
PLEASE READ THE INSTRUCTIONS BEFORE USING.
KEEP THESE INSTRUCTIONS FOR REFERENCE.
KoolBase
2
TABLE OF CONTENTS
1. SAFETY PRECAUTIONS ··································· PAGE 4,5
2. SPECIFICATIONS ················································· PAGE 6
3. ACCESSORIES ····················································· PAGE 6
4. PARTS OF THE MACHINE ··································· PAGE 7
5. INSTALLATION ····················································· PAGE 7
6. OPERATING INSTRUCTION ································ PAGE 8
7. MAINTENANCE AND INSPECTION ··················· PAGE 11
8. TROUBLESHOOTING ········································· PAGE 12
KoolBase
3
KoolBase
4
1. SAFETY PRECAUTIONS
Please read “Safety Precautions” carefully before operating the unit to reduce the risk of injury or
damage.
Please read carefully. The following should be read and understood.
STOP
STOP
FORBIDDEN
AS DIRECTED
NOTIFICATIONS / CAUTION
FOR YOUR SAFETY, PLEASE FOLLOW THESE INSTRUCTIONS.
It may cause personal injury, re, or other property damage
if you neglect this mark and operate in the wrong way.
Please do not use the unit where ammable materials are used or stored (such as thinner,
gasoline, kerosene, LPG, aluminum, magnesium, and plumbum). They could cause
possible re or explosion.
Only a professional repair service should disassemble the unit in order to avoid warranty
voidance or safety issues such as re, electric shock, and injury. If you need repairs,
please contact the manufacture or qualied repair service.
This mark stands for under any circumstances this unit should
not be used.
This mark stands for only use as directed.
The power supply use only 115V single phase, otherwise it will cause the unit not to
function properly.
This mark stands for notication of use or to be aware of
possible hazardous or unsafe situations.
Please do not operate the unit in the rain or wet areas.
KoolBase
5
Keep unit away from excessive heat or re. It may cause damage to the unit.
Do not change or modify the unit. It could cause damage to the unit or property and will
void warranty.
Use only grounded outlet.
Turn o the unit to move location or lock casters.
Hold plug when pulling out of outlet. Otherwise, the plug may be damaged or sparking
could occur.
The unit operates in the temperature range from 64°F to 104°F, otherwise it may cause the
unit to slow the air ow or shutdown.
To prevent an accident or damage, the unit can not be used in the following locations:
• Not grounded.
• Unlevel ground.
• Stairs, emergency exit or entrance.
• Area of strong wind, heavy dust or metal powder.
Unplug unit for repair or installation.
Do not bend, pull, bind, clip, or change the power cord. It may cause accidents such as
re or electrical shock.
Do not use unit on a boat.
Unplug unit if storing or non-use for a period time.
If the unit is stopping, has excessive noise, or abnormal odor, please stop use immediately.
STOP
2. SPECIFICATIONS
3. ACCESSORIES
POWER / FREQUENCY
LOAD CURRENT
CONSUMPTION POWER
COOLING CAPACITY
COMPRESSOR
REFRIGERANT
Curved Duct Cooling Duct Drain Hose
REFRIGERANT (RATED CHARGE)
WATER STORAGE CAPACITY
CONDENSATE WATER HANDLING METHOD
SIZE
WEIGHT
OPERATING TEMPERATURE LIMIT
Single Phase 115 V / 60 Hz
5.6 A
675 W
6,100 BTU
Fully Closed Type Rotary
R410 A
340 g
3 L
Condensation Tank / Drain Pipe
18” × 10” × 23”
50 LB
(77℉ - 113℉)
KoolBase
6
Cooling Duct
Filter
Operation Switch
Curved Duct
Condensation Tank (3L)
Caster Wheel
Exhaust
Raised Nub
Notch
Slot
Curved Duct
Cooling Duct
Cooling Duct Base
Releasing-Locking Ring
Cold Air Exit LockUnlock
4. PARTS OF THE MACHINE
5. INSTALLATION
•INSTALLING THE CURVED DUCT
Line up the nubs on the curved duct with slot on the cold air exit. Turn locking ring until lt is locked
position.
• INSTALLING THE COOLING DUCT
Slide the cooling duct raised nub in to the slot of the curved duct. Then turn clockwise to lock.
Make sure the duct is connected properly before using. When adjusting the direction, turn the curved
duct instead of the cooling duct.
Cooling Duct Installation Curved Duct Installation
KoolBase
7
KoolBase
8
Grounded Screw
Power Cord
Cooling
O
Fan
• POWER SUPPLY CONNECTION
Please use a dedicated power outlet.
Please use a grounded circuit breaker with a 15A capacity.
6. OPERATING INSTRUCTION
OPERATION SWITCH INFORMATION
• To power on, turn on the switch at the top of the unit to fan or cooling for operation.
There are 2 options:
1. Fan - Air ow at ambient temperature.
2. Cooling - Sends a ow of cold air at fan speed.
• Operating temperature is between 64°F to 104°F.
• If you use the unit out of the temperature range, it may not work properly.
• Do not overload the electrical system by using too many devices off one outlet.
NOTIFICATION
360°
KoolBase
9
When the overload protection is working, the air ow from the unit will be at the ambient temperature
of the room, but will not cool the air.
If overload protection works frequently, nd out, and x the problem before using the unit.
Please adjust the angle of the cooling duct before using the unit. Hold the curved duct and bend the
cooling duct for angle adjustment.
•COMPRESSOR OVERLOAD / OVERHEAT PROTECTION
If the compressor overheats or overloads due to high or low voltage or high ambient temperature,
the built in safety protection for the compressor will start working and turn o the unit.
•ADJUSTING THE AIR FLOW DIRECTION.
Please adjust the duct to get the desired cooling direction. The cooling duct adjustment range is 360°
horizontal and 50° vertical.
NOTIFICATION
NOTIFICATION
Cooling Outlet
Direction above 12”
Heating Outlet
Direction above 16”
Air Intake
Direction above 8”
•KEEP DISTANCE
Make sure the unit has minimum distance from any wall, ceiling, or object as illustrated below.
In order to prevent accidents, the unit should be placed on level ground. Unlevel ground, stairs,
emergency exits should not be used.
Minimum distance needed is 12” from any wall. While the unit operates, please do not place
obstructions in front of the lter, cooling, or heating exhaust duct.
•CASTER WHEEL LOCK / UNLOCK
The front wheels come with locks. For safety, lock the casters and check the unit for movement.
KoolBase
10
Condensation Tank (3L)
Condensation Tank Cover
ON
Caster Wheel
Locked
OFF
Caster Wheel
Unlocked
•CONDENSATION TANK.
The dehumidied water will ow into condensation tank. The capacity of the tank is 3L.
The condensation tank can be taken out manually from the unit.
Please check the amount of the water periodically. Drain the water before moving the unit.
Empty the water immediately when the water gets to the red line. The unit does not have a warning
device.
NOTIFICATION
Tabla de contenidos
Otros manuales de Accesorios de UNINEX
UNINEX
UNINEX Nakatomi Koolzone SAC-6500 Manual de usuario
UNINEX
UNINEX KOOLZONE SAC-1800 Manual de usuario
UNINEX
UNINEX KOOLZONE SAC-3000AS Manual de usuario
UNINEX
UNINEX KOOLZONE Manual de instrucciones
UNINEX
UNINEX Nakatomi Koolzone SAC-6500 Manual de instrucciones
UNINEX
UNINEX KOOLZONE SAC-3000 Manual de usuario
UNINEX
UNINEX Koolzone SAC-2500C Manual de usuario
UNINEX
UNINEX KOOLZONE SAC-3000 Manual de usuario
UNINEX
UNINEX KOOLZONE SAC-3000AS Manual de usuario
UNINEX
UNINEX KOOLZONE SAC-4500 Manual de instrucciones
