O DIAGRAM
OF PBOGRAM SELECTION AII{D OPERATTON
It should be noted that ttrc dlagparn may rcpresent cne of twe pases :
l) The proflram selectlan phase (set by presing the kep @]ffi i"
During this phase, program psramete$ may be seleeted or modified- ?he eorresponding
indicatar tamp lights up on the diagram.
The for peen lamps indicate hold time, The for red lamps indieate tempenature and
rate of heat rise.
Tc select a paranceter other than *pre*drying temperahrnen, use cuisor @
When the parameter is selected, its value is indicated on display @" while the
correspcnding i:nit of meassrenrent lights up at @
?) The operatlng'phase {set by preming f.*V @ G }.
Once the operating phase is selected. the firing cycle begins.
The larnps corresponding to all operating stages lights up at o*ce.
When a stage in the pro6Fam is over, tlre eorresponding lamp goes out {u<cept far ttre
start-vacuum larnp if a firing cycle without vacuum has been programed).
A-
\$ Note: The prograrn m,n be chan6ed et any time, even during its umge.
Firing parameters:
Pre-drying temp€rarure 0 to I000sC or 3? to 18$2"F
Pre-drying tirne 0 to 20 mn
Heat rise rate + ?S to l5$"C/rnrer 68 to SSSUF
Vacuum start 0 to 1?00"C or 3? to 2190'F
Vacuurn reiease 0 io 12{i0"C or 32 to ?i90"F'
Baking temperef,ure 0 to 1200"C or 32 to 219S"F
Hold tirne 20 mn S0 seeondes
Cooling tlme Zfi rnn
@ PR*G*AMrN* rGrY
Fressing the @ m key apens aceess to prsgrariling in orderto s€t or change the
firing pararnetens of a program.
By pressing ti:is key fivice, you confirrn the program setting you have selected.
{Jnce the furnace is switched on" of at the end of, a baking cycle, press stand-by key to
obiain stand-by rnode.
Page 6 INSTRUCTISN MANUAL COMPAC}T 10{i - COMPLITERJZAD PORCEI*AIN FtlIttlACE
ffi\
\}f- PRocH,AIfi NTTMBER llrspr,ay
The controi staticn esn memor"ize 100 prograrns {0 to 99}.
To call up e pra€rarn, press'keys & B sr @ 13] "
The furnace mu"t be in stand-by mode {na dispiay on diagfaln).
