Uctronics Raspberry Pi Manual de usuario
Raspberry Pi
Quick-Start Guide
Rev 1.0, Mar 2017
www.uctronics.com
1
Table of Contents
1. Raspberry Pi Start Kits ..................................................................................................................... 2
A. Generation Introduction: ....................................................................................................... 2
B. Package including: ................................................................................................................... 2
2. Assembly: ............................................................................................................................................ 4
A．16GB Micro SD – Kingston Pre-Loaded with Raspbian ............................................... 4
B. Power Supply Adapter Charger 5V 2.5A (US) ................................................................. 5
C. USB cable with ON/OFF switch ........................................................................................... 6
D. ABS Protective Case Enclosure ............................................................................................ 7
E. Premium High Speed HDMI Cable..................................................................................... 8
F. Heatsink kit with Thermal Pad ............................................................................................. 9
G. T Type 40pin GPIO Board .................................................................................................... 10
H. 20cm FC40 40pin GPIO cable ............................................................................................ 11
I. 830 Tie Point Solderless Breadboard............................................................................... 12
J. 40pcs M/M and20pcsM/F Jumper Wires（20cm） ................................................... 13
K. RGB LED .................................................................................................................................... 14
L. Red, Green, Yellow, Blue LEDs ........................................................................................... 15
M. Push Button Switches ............................................................................................................ 16
N. 220 and 10K Ohm Resistors ............................................................................................... 17
3. Installation diagram: ...................................................................................................................... 19
A. Getting started ........................................................................................................................ 20
B. RaspbianSystem ...................................................................................................................... 21
B. Guide to connecting WIFI .................................................................................................... 26
www.uctronics.com
2
1. Raspberry Pi Start Kits
A. Generation Introduction:
The Raspberry Pi 3 Starter Kit is a great way to gain a solid introduction to the small,
credit-card sized computer. The starter kit make the Raspberry Pi intuitive and easy to
learn.
With this kit, you will be able to get your Raspberry Pi 3 as your own credit card sized
computer, getting started with programming and coding, setting-up the Raspberry Pi as
a game player. So, if you are looking for a new challenge or a way to get in on the RPi
craze, check out the Raspberry Pi 3 Starter Kit!
UCTRONICS team has carefully done the compatibility test for all components, and offer
the plug and play boot operation system like Raspbian. Users only need additional HDMI
monitor and keyboard/mice to use this kit as a standard PC desktop.
B. Package including:
1pcs 16GB Micro SD – Kingston Pre-Loaded with Raspbian
1pcs Power Supply Adapter Charger 5V 2.5A (US)
1pcs USB cable with ON/OFF switch
1pcs ABS Protective Case Enclosure
1pcs Premium High Speed HDMI Cable
3pcs Heatsink kit with Thermal Pad
1pcs T type 40pin GPIO Board
1pcs 20cm FC40 40pin GPIO cable
1pcs 830 Tie Point Solderless Breadboard
40pcs M/M Jumper Wires(20cm)
20pcs M/F Jumper Wires(20cm)
1pcs RGB LED
2pcs Red LEDs
2pcs Green LEDs
2pcs Yellow LEDs
2pcs Blue LEDs
www.uctronics.com
3
2pcs Push Button Switches
10pcs 220 Ohm Resistors
5pcs 10K Ohm Resistors
www.uctronics.com
4
2. Assembly:
A．16GB Micro SD – Kingston Pre-Loaded with Raspbian
This Micro SD Card Bundle for the Raspberry Pi consists of a Micro SD card pre-loaded
with the system like Raspbian.
Specification:
Capacity: 16GB
Weight: approx 0.2g
Simply plug this SD card into your Raspberry Pi
Fully tested to work with the Raspberry Pi 3 Model B
Pre-Loaded with pre-loaded with the Raspberry Pi Raspbian image
Superior Random-Access Performance - Perfect for the Raspberry Pi
www.uctronics.com
5
B. Power Supply Adapter Charger 5V 2.5A (US)
These have a standard USB ‘A’ connector for the output so you can power your Arduino,
Raspberry Pi, etc. through a USB cable. Any device that uses a USB cable for charging or
power can be powered with this supply.
Specification:
Input Voltage: AC100-240V 50/60Hz
Output: DC 5.0V 2500mA (2.5A)
Consistent fixed switching voltage
Internal Fuse for Extra Safety
Adapter plug type: US
www.uctronics.com
6
C. USB cable with ON/OFF switch
This USB to Micro USB Cable with switch is 1.5m long and is the perfect hard on/off power
switch for your Raspberry Pi.
Specification:
Tested for Compatibility with the Raspberry Pi
On/Off switch
1.5m Long
Color: Black
Connector Type A: USB
Connector Type B: Micro USB
www.uctronics.com
7
D. ABS Protective Case Enclosure
This enclosure case is elegant, beautiful, and functional for Raspberry Pi Model B.
Made of ultra-durable, super-glossy polycarbonate, it is both good looking and tough
enough to toss into your bookbag or toolbox. It has slim openings for all your cables, an
easy-to-remove beveled slot for your Micro SD card, slots for both your Pi Camera and
upcoming Display, and a space for your GPIO cable to extend out from the Pi.
Specification:
Durable two part ABS plastic case
Vents on three sides double as fly-through cable ports
Two-section breakout on A/V side for break-out board I/O
Micro SD card access port
Mounting option 1: two M3.5/M3/#6 screws slide into wall mounts for easy removal,
horizontal orientation with A/V side down, 40mm spacing
Mounting option 2: four M3.5/M3/#6 screws through feet from inside for secure
mounting in any orientation, 68.3 x 38.8mm spacing
External dimensions: 96 x 66 x 41mm
Internal volume for breakout boards:
Length: 90.0mm
Width: 60.0mm
www.uctronics.com
8
E. Premium High Speed HDMI Cable
The 1.5m Gold Plated HDMI to HDMI cable is the perfect low cost solution to connecting
your Raspberry Pi to your HDMI monitor or TV.
This is the latest high speed version V1.4 with Ethernet, 3D support!
Specification:
1.5m Long
Flat "Noodle" Type Cable
Tested for Compatibility with the Raspberry Pi
HDMI Male (19 Pin) to HDMI Male (19 Pin)
24k Gold-Plated Contacts Prevents Corrosion for Life-Long Optimum Signal
Transfer
Fully Ethernet and 3D over HDMI enabled (V1.4 Connection)
Supports 4K*2K, 1080p Resolutions
www.uctronics.com
9
F. Heatsink kit with Thermal Pad
The Raspberry Pi Heat Sink Kit consists of three high quality aluminum heat sinks, each
selected to perfectly match the size of the main heat out-put components on your
Raspberry Pi board. The heatsinks are designed to fit on top of the Broadcom and
Ethernet SOC's. Keep your Raspberry Pi super cool with this Raspberry Pi Heat Sink Kit in
stunning silver! Extend the life of your Raspberry Pi and reduce the risk of hardware failure.
Specification:
3 x Silver Aluminum Heat Sinks.
Compact, and Able to Fit in Most Raspberry Pi Cases.
High quality Thermal Adhesive Tape for Easy Application.
Thermal Resistance 25°C/W.
1pcs 9x9x5mm Heat Sink, Floor Thinness:1.6mm, Vane Thickness:0.8mm.
2pcs 14x14x6mm Heat Sink, Floor Thinness:1.1mm, Vane Thickness:0.6mm.
Otros manuales para Raspberry Pi
1
Tabla de contenidos
Manuales populares de Placa madre de otras marcas
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manual de usuario
Gigabyte
Gigabyte GA-9IVDT Manual de usuario
Texas Instruments
Texas Instruments ADS8372EVM Manual de usuario
Commell
Commell MS-C73 Manual de usuario
IBT Technologies
IBT Technologies MB860 Manual de usuario
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manual de usuario
