
ETH-SP-G2 Quick Start Guide
https://dl.ubnt.com/qsg/ETH-SP-G2/ETH-SP-G2_EN.html[1/20/2020 4:04:01 PM]
connected to a remote grounding block or structure.
Installation Requirements
Mounting accessories and optional drain wire are not included.
Pole-Mounting:
Drill with a 4.5 mm drill bit
(1) Metal strap or cable tie
Wall-Mounting:
(2) Screws (≤ 5 mm screw head)
(1) M5 machine screw and nut
(1) Drain wire (≤ 16 AWG, ≤ 40 cm)
Optional: Drain wire, M5 machine screw, and nut are not included.
Note: Place the included Serrated Washer between the screw and drain wire.
Installation
Install the ETH-SP-G2 near an Ethernet device. Follow the appropriate steps for your
installation:
“Pole Mounting”
“Wall Mounting”