Precautions
This manual should be made available to all users of this equipment. For best
results, and for maximum durability of the equipment, carefully read and follow
all instructions.
The tape dispenser includes sharp metal parts, please be careful when
using the product.
Do not damage the cables, such as processing the cable, bending the
cable, pulling and strapping the cable, placing heavy objects on the cable or
cutting with scissors.
Do not use the tape dispenser if cable or plug has damages, or the socket
outlet is loose. Once the cable is damaged, do not disassemble or replace it by
yourself, but return the tape dispenser to factory for after-sales service.
When stop using the tape dispenser, or repairing and inspecting the tape
dispenser, please pull out the power plug from the outlet first.
Do not touch the cable or socket with wet hands. When repairing or
storing, please avoid water or moisture,and place the tape dispenser where
children can not reach and well ventilated.
When the tape is rolled into the feed rollers, please turn off the power
switch(OFF) before removing the tape.
Trouble caused by users’ split or assembly, the tape dispenser will be not
guaranteed.
The upper & lower blade set is easily sticked by adhesive tape, which will
cause the cutting not so smoothly, please clean the blade set on time.
Coat the Blade set with some oil or lubricant can improve the life
effectively.
When the tape feeding is curly, rotate the reel adjustment keys in
clockwise direction or replace the reel.
When the AUTO Feed does not work, please check whether the sensor
part is clean or not .
Troubleshooting
1.Problem:The tape will not be released automatically
or the tape will be sluggish.
Solution: Induction is too high, use a Phillips
screwdriver to adjust the bottom plate induction,
and adjust it in the - direction about 1MM.
2.Problem: Continuously cut tape, or cut a piece and
then alarm.
Solution: Induction is too low, use a Phillips
screwdriver to adjust the bottom plate induction, and
adjust it in the + direction about 1MM.
3.Problem: Excessive indentation on the tape
Solution: Pressure is too large, adjust the knob on the
top of the machine to the S direction by half a turn to
one turn
4.Problem: Tape does not come out when cutting
Solution: Pressure is too small, adjust the knob on the
top of the machine to the H direction by half a turn to
one turn.
5.Problem: The tape does not come out smoothly or
the glue outlet is blocked with the tape
Solution: Replace the separating roller ring.
6.Problem: Tape does not cut completely
Solution:The blade is worn or the shrapnel pressure is
too small, replace the blade or adjust the shrapnel
pressure.
