FRONT PANEL
ŸModulometers –Continuous lighting, peak reading, BBC 1-7, dB or VU scaling, built-in red LEDs
indicate when the gain reduction is occurring with the limiters switched on.
ŸBattery check pushbutton
Ÿ6.3 and 3.5 mm phone jacks
ŸMonitor selector switch –ST stereo. L+R sum signals, phase check, MS stereo equivalent Left.
L–R difference signals MS stereo equivalent Right. MS matrix, MS stereo equivalent. R right channel.
L left channel.
ŸPhones volume control –Output voltage into 50 Ωadjustable from 20 to 500 mV.
ŸLimiters on /off switches–The four individual limiters have fast attack time (less than 1 msec) and
a slow release time to smooth operation. Two red LEDs are built in the meters to indicate when the
limiters are selected and gain reduction is occurring. Threshold is internally set to +6 dBu at the
balanced output. To adjust the threshold for a value different from the supplied +6 dBu, see page
ADJUSTMENT POINTS.
ŸReference generator switch –1 kHz sine wave signal is fed to both left and right outputs, its level
can be controlled by the Master control.
ŸSlate microphone –It can be used either for identifying recorded segments or as an emergency
field microphone.
ŸLow-cut filter switches–Low frequency attenuation is 14 dB /octave at 100 Hz.
ŸPan switches–Assign selected input signal to Left or Right output. In M position, equal amount of
signal is sent to Left and Right outputs. The S position of Pan switches 1 and 3 assigns Channels 1–2
and 3–4 as stereo pairs controlled by Channel 1 and 3 Faders respectively.
ŸChannel gain controls
ŸPre-Fade Listen pushbuttons –Each channel can be checked by monitoring. Output audio signal
is not interrupted when the PFL pushbutton is activated.
ŸEE /RTN12 switch –A two-position switch selects the direct outputs from the mixer or the return 1
and 2 as a signal source for the monitoring.
ŸMaster –The fader sets the gain of both Left and Right legs and has +6 dB of gain in hand with the
nominal 0 dB gain position marked.
ŸPWR LED –A red LED lights to indicate power is on. Flashes when voltage is 11.5 Vdc or less.
ŸPower switch –In position EXT the mixer will be powered by an external DC supply and in BATT by
the internal batteries. Batteries should be recharged with the switch in EXT position.
