Tuxedo FP8K-DS Manual de usuario

FP8K-DS & FP8K-DS-XLT

Four Post Parking Lifts

8000 lb Capacity

Installation &Operation Manual

REV A-091713

SPECIFICATIONS FP8K-DS FP8K-DS-XLT

Lifting capacity 8,000 lbs. 8,000 lbs.

Overall length with ramps 207 1⁄8”222 1⁄2”

Overall width 103 1⁄2”109

1⁄2”

Overall height 86 1⁄4”96”

Track length 165 1⁄2”180

1⁄2”

Lifting height 74 3⁄4”82 1⁄4”

Width between posts 94 1⁄2”100

5⁄16”

Maximum clearance under tracks

70” 77 15⁄16”

Shipping weight 1,640 lbs. 1,700 lbs.

Features:

✦8,000 lb. lifting capacity

✦Carriages completely

enclosed for safety

✦Redundant ladder lock

safety system with

“auto engage” locking

bar in the event of

cable failure

✦Extra large slider blocks

for added stability

✦10 lock positions

✦Aircraft quality cables

rated at 14,500 lbs.

✦18” wide runways

formed with one-piece

3⁄16” non-skid

diamond-plate

✦Easy operation:

Lock release handle

located near power unit

✦Large 3” diameter

cylinder

✦Many options

available

8,000 LB.

DELUXE SERIES

STORAGE /SERVICE LIFTS

Smooth operation and good looks make a great first impression

but it’s the safety features and durability that makes

the“Deluxe Series” the best choice

in storage/service lifts.

FP8K-DS

Deluxe Series

Storage/ Service lift

Cable safety system

Internal ladder locking system

FP8K-DS-XLT

Extra length & under car clearance

1905 N Main St Suite C, Cleburne, TX 76033

Ph 817-558-9337 Fax 817-558-9740

TUXEDO DISTRIBUTORS LIMITED WARRANTY

Structural Warranty:

The following parts and structural components carry a five year warranty:

Columns Top Rail Beam Uprights Arms Swivel Pins

Legs Carriages Tracks Overhead BeamCross Rails

Limited One-Year Warranty:

Tuxedo Distributors, LLC (“Tuxedo”) offers a limited one-year warranty to the original purchaser of

Tuxedo lifts and Wheel Service in the United States and Canada. Tuxedo will replace, without charge, any

part found defective in materials or workmanship under normal use, for a period of one year after purchase.

The purchaser is responsible for all shipping charges. This warranty does not apply to equipment that has

been improperly installed or altered or that has not been operated or maintained according to specifications.

Other Limitations:

This warranty does not cover:

1. Parts needed for normal maintenance

2. Wear parts, including but not limited to cables, slider blocks, chains, rubber pads and pulleys

3. Replacement of lift and tire changer cylinders after the first 30 days. A seal kit and installation

instructions will be sent for repairs thereafter.

4. On-site labor

Upon receipt, the customer must visually inspect the equipment for any potential freight damage before

signing clear on the shipping receipt. Freight damage is not considered a warranty issue and therefore must

be noted for any potential recovery with the shipping company.

The customer is required to notify Tuxedo of any missing parts within 72 hours. Timely notification must

be received to be covered under warranty.

Tuxedo will replace any defective part under warranty at no charge as soon as such parts become available

from the manufacturer. No guarantee is given as to the immediate availability of replacement parts.

Tuxedo reserves the right to make improvements and/or design changes to its lifts without any obligation

to previously sold, assembled or fabricated equipment.

There is no other express warranty on the Tuxedo lifts and this warranty is exclusive of and in lieu of all

other warranties, expressed or implied, including all warranties of merchantability and fitness for a

particular purpose.

To the fullest extent allowed by law, Tuxedo shall not be liable for loss of use, cost of cover, lost profits,

inconvenience, lost time, commercial loss or other incidental or consequential damages.

This Limited Warranty is granted to the original purchaser only and is not transferable or

assignable.

Some states do not allow exclusion or limitation of consequential damages or how long an

implied warranty lasts, so the above limitations and exclusions may not apply. This warranty

gives you specific legal rights and you may have other rights, which may vary from state to state.

PREFACE

Prior to the operation of your lift make sure that you read the

instructions thoroughly. These instructions are found in this

manual. Please note that your warranty may be voided if you do

not read the manual and understand its content.

REV A-091713

IMPORTANT SAFETY INSTRUCTIONS

Read these safety instructions entirely!

Failure to read these instructions may result in injury to user, other people within

the area of the lift, or vehicles. The manufacturer is not responsible for any injury

or damage as a result of neglecting to carefully read and follow these instructions.

Always lock the lift in place before going under the vehicle. Never allow anyone to

go under the lift when raising or lowering.

INSPECT your lift daily. Never operate if it malfunctions or if it has broken or

damaged parts. Repairs should be made with original equipment parts.

ATTENTION! LOOK OUT!

Routine check of safety latch system is very important -the discovery of device

failure before needed could save you from expensive property damage, lost time,

serious personal injury or even death.

zNEVER overload your lift. Manufacturer’s rated capacity is shown on

nameplate affixed to the lift. ALWAYS operate the lift with gross weight

less than the capacity.

zNEVER use the lift to raise one end or one side of the vehicle.

zNEVER raise vehicle with anyone inside. No one should be in the lift area

during operation.

zALWAYS keep lift area free of obstructions, grease, oil, trash and other debris.

Before lowering the lift, be sure tool trays, stands, etc. are removed from under

the vehicle. Release locking devices before attempting to lower the lift.

zAdequate ventilation should be provided when working on internal

combustion engines.

zUse only manufacturer’s recommended attachments.

zKEEP HANDS and FEET CLEAR. Remove hands and feet from any moving

parts. Keep feet clear of the lift when lowering. Avoid pinch points.

zGUARD AGAINST ELECTRIC SHOCK. This lift must be grounded while in use

to protect the operator from electric shock. Never connect the yellow/green

wire in the power supply cord to a line terminal. This is for ground only.

zDANGER! The power unit used on this lift contains high voltage.

zDisconnect power at the receptacle before performing any electrical repairs.

Secure plug so that it cannot be accidentally plugged in during service.

zWARNING! RISK OF EXPLOSION. This equipment has internal arcing or

sparking parts which should not be exposed to flammable vapors. This

machine should not be located in a recessed area or below floor level.

REV A-091713

zMAINTAIN WITH CARE. Keep lift clean for better and safe performance. Follow

instructions in the manual for proper lubrication and maintenance. Keep

control handles and/or buttons dry, clean and free from grease and oil.

zSTAY ALERT. Watch what you are doing. Use common sense. Be aware. CHECK

FOR DAMAGED PARTS. Check for alignment of moving parts, breakage of parts

or any condition that may affect its operation. Do not use lift if any component is

broken or damaged

zNEVER remove safety related components from the lift. Do not use lift if safety

related components are damaged or missing.

zALWAYS wear safety glasses. Every day eyeglasses only have impact

resistant lenses. They are not safety glasses.

READ AND UNDERSTAND ALL SAFETY WARNINGS & PROCEDURES

BEFORE OPERATING LIFT. POST THESE SAFETY TIPS WHERE THEY

WILL BE A CONSTANT REMINDER TO YOUR LIFT OPERATOR. FOR

INFORMATION SPECIFIC TO THE LIFT, ALWAYS REFER TO THE LIFT

MANUFACTURER’S MANUAL.

REV A-091713

SIZE DRAWING

Fig. 1

Fig. 2

REV A-091713

SPECIFICATION:

Specifications 163016/FP8K-DS 163018/FP8K-XLT

Overall Width 2630mm(103.54”) 2780mm(109.45”)

Inside Columns 2398mm(94.41”) 2548mm(100.32”)

Width of Outside runway 1900mm(74.80”) 2050mm(80.71”)

Width of runway 474mm(18.66”) 474mm(18.66”)

Overall Length 4460mm(175.59”) 4845mm(190.75”)

Lifting Height Min122~max1900mm

(Min4.8”~Max 74.80”) Min122~Max2090mm

(Min4.8”~Max82.28”)

Overall Height 2237mm(88.07”) 2390mm(94.09”)

Length of Columns 4000mm(157.48”) 4385mm(172.64”)

Lifting Capacity 8000lbs 8000lbs

Net（Gross）Weight 745(770)kg 795(820)kg

REV A-091713

INSTALLATION

Improper installation can cause accelerated wear, resulting in catastrophic failure

which may cause property damage and / or bodily injury. Manufacturer will

assume no liability for loss or damage of any kind, expressed or implied,

resulting from improper installation or use of this product. Read this installation

manual in its entirety before attempting to install or operate the lift.

STEP 1 SELECTING SITE

Before installing your new lift, check the following.

zOVERHEAD OBSTRUCTIONS: The area where the lift will be located should be

free of overhead obstructions such as heaters, building supports, electrical lines etc.

zFLOOR REQUIREMENTS: Visually inspect the site where the lift is to be installed

and check for cracked or defective concrete. This lift must be installed on a solid

level concrete floor with no more than 2 degrees of slope. A level floor is suggested

for proper installation and level lifting. If a floor is of questionable slope, consider a

survey of the site and/or the possibility of pouring a new level concrete slab. This

lift is designed to be installed on a minimum of 4" thick, 3500psi, steel reinforced

concrete. Do not install this lift on asphalt, wood, or any other surface other than

described. This lift is only as strong as the foundation on which it is installed.

zDO NOT install this lift outdoors unless special consideration has been made to protect

the power unit from weather conditions. The Power unit is not water proof!!!

zDO NOT install lift close to wall. It is necessary to leave adequate clearance for safety

walking. Suggest clearance be 1 meter (3 feet) at min.

Fig.4

REV A-091713

Otros manuales para FP8K-DS

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Sistema de elevación de Tuxedo

Tuxedo

Tuxedo M-1000C Manual del propietario

Tuxedo

Tuxedo FP8K-DS Manual de usuario

Tuxedo

Tuxedo M-1500C-HR Manual de instrucciones

Tuxedo

Tuxedo TP9KAC-TUX Manual de usuario

Tuxedo

Tuxedo FP14K Manual de usuario

Tuxedo

Tuxedo TP9KF Manual de lista de piezas

Tuxedo

Tuxedo FP14KO-A Suplemento

Tuxedo

Tuxedo MR6K-38 Manual de usuario

Tuxedo

Tuxedo PL6K Manual de usuario

Tuxedo

Tuxedo JMC9KAC-TUX Manual de usuario

Tuxedo

Tuxedo TP12KFX Manual de usuario

Tuxedo

Tuxedo FP12K-K Manual de lista de piezas

Tuxedo

Tuxedo FP8K-B Instrucciones de instalación

Tuxedo

Tuxedo TP9KACX Manual de usuario

Tuxedo

Tuxedo TP9KF-TUX Manual de usuario

Tuxedo

Tuxedo TP11KC-DX Manual de usuario

Tuxedo

Tuxedo LR-26-PAD Manual de lista de piezas

Tuxedo

Tuxedo M-1500C-HR Manual de usuario

Manuales populares de Sistema de elevación de otras marcas

morse

morse 82H-124 Manual de usuario

Braun

Braun NL955 Series Manual de usuario

haacon

haacon 1889.10 Manual de usuario

Protekt

Protekt AT 252 Manual de usuario

R. Beck Maschinenbau

R. Beck Maschinenbau HS 600 Manual de usuario

Nova Technology International, LLC

Nova Technology International, LLC NAS Series Manual de usuario

Genie

Genie Z-60/34 Manual de usuario

Screen Technics

Screen Technics INTERFIT Vertical Up Lift Manual de usuario

Mortuary Lift

Mortuary Lift ULTIMATE 1000 Manual de usuario

Custom Equipment

Custom Equipment Hy-Brid 3 Series Manual de programación

Custom Equipment

Custom Equipment Hy-Brid Lifts 2 Series Manual de programación

Hy-Brid Lifts

Hy-Brid Lifts HB-P3.6 Manual de programación

BERG

BERG BeNomic EasyLeaf Manual de usuario

Powermate

Powermate LiftGate LG-3 Manual de usuario

Snorkel

Snorkel TM12 Series Manual de usuario

Terberg

Terberg OMNIDEKA Manual de usuario

Harmar Mobility

Harmar Mobility AL625 Instrucciones de funcionamiento

Rotary

Rotary SPO16 Manual de usuario