Tuff-Cam®2
PLAY Menu Options
nDelete: Single, All, Selection
nCopy to (SD) Card: Single, All, Selection
nSlide show: 3 sec, 5 sec, 10 sec
nProtect: Single, All, Selection
nVolume: 1 to 8
Connecting to a PC or Apple Mac
nThere are two modes in which the Tuff-Cam 2 can connect to a PC:
MSDC or PC-CAM.
nIn MSDC mode, the PC or Mac will recognise the device as a USB mass
storage device and it will appear as a removable drive in the file explorer
window.
nPC-CAM mode is not available for MAC computers.
nIn PC-Cam mode, only MS Windows based computers are supported
and the drivers (see below) must be installed first.
nTo select MSDC mode, move the slide switch to PLAY before
connecting to the PC.
nTo select PC-Cam mode, move the slide switch to PHOTO or VIDEO
before connecting to the PC.
Charging the Battery
nTuff-Cam 2 is supplied with a partially charged battery and can be
used immediately without charging first.
nThe battery can be charged by placing the camera on the base and
connecting it to any active USB port. This will take between 2 and 4
hours depending on the state of the battery.
nWhile the battery is charging, the Battery Status LED will flash red.
nWhen Tuff-Cam 2 is fully charged, the Battery Status LED will change
to solid red.
nTo charge your Tuff-Cam 2, place the camera on the base, so that the
USB is plugged in.
nThen plug the USB cable from the base into a USB port on your PC or
into a USB charging adaptor (not included).
