TTI TCB-660 Manual de usuario

4W MOBILE CB TRANSCEIVER

INSTRUCTION MANUAL

www.ttikorea.co.kr

Microphone Jack

LCD Display

Down Button

Up Button

AM/FM and LCR Button

Scan and Lcok Button

Emergency and Calling Button

Squelch Control Knob

Volume and Power On/Off Knob

Antenna Connector

Power 13.2DC

EXT-SPK Jack

CONTENTS

10.

11.

12.

13.

14.

15.

10)

11)

12)

Introduction

Supplied Accessories

Installation

Transceiver Controls and Functions

LCD Display

Microphone

Menu Setting Mode

How to Operate the Transceiver

Band Selection

Trouble Shooting

CE Declaration

Safety Requirement

Specification

Restrictions on the use

Frequency Table

ENGLISH

1. Introduction

1 unit

2 pieces

3 pieces

2 pieces

1 piece

TCB-660 transceiver

Microphone with cord

Power cable

Radio mounting bracket

Radio mounting thumb screw with rubber washer

Mounting screw with washer (for transceiver bracket)

Mounting screw with washer (for microphone bracket)

Microphone mounting bracket

2. Supplied Accessories

3. Installation

TCB-660 transceiver is designed to have a good performance

in any conditions that the transceiver operates, using rugged

build chassis, PCB’s and components. This transceiver is also

designed for users’ convenience, implementing human

ergonomics to locate the knobs and buttons in the proper

places. The combination of well designed knobs and buttons

as well as user friendly graphic layouts will lead users to

quickly adapt themselves for the easy operation. The newly

applied menu mode will make professional users more

satisfactory with pleasure. The elegant and luxury blue LED

light supporting the face design will go well with any vehicles.

This instruction manual has been designed to enable you to

get the best use from your CB Transceiver, therefore you are

recommended to take a few minutes to read this instruction

manual before initial use of your CB Transceiver.

Your transceiver is supplied with a full range of accessories to

help you get started and virtually benefit from all the features

straight away.

Plan the location of the transceiver and microphone first, which

is most convenient for the operation. The transceiver should

normally be mounted horizontally, but may be mounted

vertically. The bracket supplied can be fitted above or below

the case allowing the TCB-660 to be cradled by the bracket or

suspended from it.

TCB-660

Consider that this location of the transceiver should not

interfere with the driver and passengers. Choose a spot where

the microphone and all controls are easily accessible.

Put the mounting bracket on the proper location where you

are going to install.

Drill holes and fix mounting bracket on the location.

Connect the antenna cable plug to the standard receptacle

on the transceiver, which

is marked "ANT".

Connect the power cable directly to the vehicle battery or

fuse box of the car. Be careful to make sure of the polarity of

the battery first and connect the cable.(Red: Positive Pole(+),

Black: Negative Pole(-). The same colours are shown on the

battery and in the fuse box of the car.)

Connect the power cable to the transceiver cable.

Mount the microphone bracket on one side of the

transceiver, or near it using two screws included.

Connect the microphone to the transceiver’s microphone

receptacle. Now you are

ready to operate the

transceiver.

ENGLISH

TCB-660

ENGLISH

Installing An Antenna

It is very important to select a good quality high efficiency

27MHz antenna. A poor quality antenna or one not designed

for the 27MHz band will give very poor performance and could

cause damage to the transceiver.

Warning : Never try the operation of your transceiver before

connecting a proper antenna in order not to cause any damage.

Place the antenna as high as possible.

The longer the antenna is, normally the better is the

performance of the transceiver.

Try to mount the antenna in the centre of the surface that

you select.

Make sure that you have a solid metal-to-metal ground

connection.

Be careful not to damage the cable during the installation.

TCB-660

4. Transceiver Controls and Functions

3 4 5 6 7 8 9

10 1211

1) Microphone Jack

3) Down Button

2) LCD Display

Insert the microphone into this jack. Use the guide

for easy connection.

Most of the operational

information is displayed.

Please see item no. 5 for the

details of information.

ENGLISH

TCB-660

Press this button briefly to select the channel one

by one that you like to use.

LCR

LOCK

ENGLISH

4) Up Button

TCB-660

Press this button briefly to select the channel one

by one that you like to use.

5) AM/FM and LCR Button

When the transceiver is used in UK, UE, or EC

freequency band modes this button activates or

deactivates Last Channel Recall function. In all

other modes (where national regulations permit this)

this button allows user to switch between AM and FM modes

by momentarily pressing this button.

6) Scan and Lock Button

Scan : Press this button momentarily to start

scanning upward to catch any channels that are

occupied by others.

To activate/deactivate the channel scan, press the Scan button

briefly. The Scan icon will appear when the channel scan is

active. Scanning will only stop when you deactivate the scan

function.

The transceiver will scan through the whole transceiver

channels. If your transceiver detects a valid signal the scan will

pause for the period that has been set by the menu mode

setting (continuously receiving or 1-99 seconds for scan

receive time and immediate response or 1-99 seconds for scan

delay time).

If you press the PTT button when your transceiver detects a

signal, the radio will transmit on the same channel. Scanning

will resume after the scan receive time and/or the scan delay

time. Use the channel selector or quick up/quick down selector

to resume scanning immediately.

If you press the PTT button during scanning, the radio will

return to your original channel. Scanning will resume after the

scan receive time and/or the scan delay time. Use the channel

selector or quick up/quick down selector to resume scanning

immediately.

8) Squelch Control knob

7) Emergency and Calling Button

9) Volume and Power On/Off Knob

Turn this knob counter-clockwise until you hear the

background noise and then turn the knob a little

clockwise until the noise disappears. In this way,

you get the best receive sensitivity.

To switch on the transceiver turn this knob

clockwise. After clicking sound the transceiver is

switched on. The more you turn this knob

clockwise, the bigger the audio sound grows.

ENGLISH

TCB-660

SQUELCH

VOLUME

ON/OFF

Pressing this button once will lead you to the

emergency channel, "CH 9"("CH 19" in some

bands) and the EMG icon will be displayed.

Pressing this button twice will lead you to the calling

channel, "CH 19" ("CH 9" in some bands) will be

10) Antenna Connector

11) Power 13.2 DC

Connect the power supply cable to this port.

12) EXT-SPK Jack

Insert the mail connector of the antenna cable into

this female antenna connector.

Connecting a loud speaker to this port makes the

built-in speaker turned off.

Lock : Press this button for more than 2 seconds to activate

and deactivate the keypad lock function. This function locks

only the channel selector, quick up/quick down buttons, scan

button. Other buttons and selectors work normal.

displayed. To return to the previous operation mode,

momentarily press the emergency button again.

ENGLISH

5. LCD Display

1 2 3 5

9876

Channel Display

Transmit

Receive

AM Mode

FM Mode

Selected Frequency Band

Keypad Lock

Scan

Emergency Channel Display

TCB-660

6. Microphone

1Up Button : Use this button to change

the channels upward.

Down Button : Use this button to

change the channels downward.

Lock Button : This locks the up button

and down button of the microphone.

Also, this lock works same as the lock

button on the transceiver front panel.

PTT Button : While pressing this

button, you can transmit.

6 Pin Microphone Connector :

Connect this to the microphone jack

on the front panel of the transceiver.

7. Menu Setting Mode

On( ) / Off( )

High( ) / Low( ) / Off( )

Off( ) and 1~99 Sec.

Continue( ) and 1-99 Sec.

Off( ) and 1~99 Sec.

Beep Tone

Backlight Dimmer

Scan Delay Timer

(after Receiving signal)

Scan Receive Timer

Time-out Timer

Display SettingsFunctions

Pressing the Lock button of the microphone, turn on the

transceiver. The transceiver goes to the Menu Setting Mode,

which has the following menu features. This menu setting

mode allows you to program user preferences, activate

features and use advanced functions.

TCB-660

ENGLISH

Note :

Use Channel Selector to selecte the main menu features

such as Beep Tone, Time-out Timer, Scan Receive Timer,

Scan Delay Timer, Backlight Dimmer and Backlight Timer.

Use AM/FM button to enter value setting level.

Use Channel Selector to select or change any value that you

like to have while the values are blinking.

Use SCAN button to return to the previous main menu

features.

Press Lock button or PTT button of the Microphone to

complete the selections and changes and return to the

stand-by mode. Or the selections and changes will be

automatically confirmed after 5 seconds of the selections

and changes. Using Scan button to return to the previous

main menu features will be accompanied by the automatic

confirmation of the selected values and changes.

Otros manuales para TCB-660

Tabla de contenidos

Otros manuales de Transceptor de TTI

TTI

TTI TCB-881 Manual de usuario

TTI

TTI TCB-660 Manual de usuario

TTI

TTI TCB-560 Manual de usuario

TTI

TTI Freequency TCB-770 Manual de usuario

TTI

TTI Freequency TCB-880 Manual de usuario

TTI

TTI Freequency TCB-880 Manual de usuario

TTI

TTI TCB-900 Manual de usuario

TTI

TTI Freequency PMR-500TX Manual de usuario

TTI

TTI TCB-H100 Manual de usuario

TTI

TTI TCB-550N Manual de usuario

TTI

TTI TCB-H100 Manual de usuario

TTI

TTI TXL-446 Manual de usuario

TTI

TTI Freequency TCB-770 Manual de usuario

TTI

TTI TX-1446 Manual de usuario

TTI

TTI TCB-R2000 Manual de usuario

TTI

TTI Freequency TCB-770 Manual de usuario

TTI

TTI TCB-1100 Manual de usuario

TTI

TTI TCB-550 Manual de usuario

TTI

TTI PMR-506TX Manual de usuario

TTI

TTI TX-1446 Plus Manual de usuario

TTI

TTI TSC-100R Manual de usuario

TTI

TTI TCB-550 Manual de usuario

TTI

TTI TCB-R2000 Manual de usuario

TTI

TTI TCB-771 Manual de usuario

Manuales populares de Transceptor de otras marcas

Yaesu

Yaesu FT-7B Manual de usuario

Kenwood

Kenwood ProTalk TK-3201 Manual de usuario

Texas Instruments

Texas Instruments TLK10232 Manual de usuario

Mizuho

Mizuho MX-2 Guía del producto

Kenwood

Kenwood TK-3180 Manual de operación y mantenimiento

Blitz

Blitz MJ-398U Manual de usuario

Utilicom

Utilicom LongRanger 2050 Manual de usuario

Standart

Standart HX290UKA Manual de usuario

Altronix

Altronix Pace1PTM Manual de usuario

Kirisun

Kirisun PT2208 Manual de usuario

ELECRAFT

ELECRAFT KX2 Manual de usuario

Zodiac

Zodiac K3 Manual de usuario

Assa Abloy

Assa Abloy SecureComm HKC GSM-WIFI U Manual de usuario

Kenwood

Kenwood TK-2217 Manual de usuario

Siemens

Siemens PSO 4000 Manual de usuario

Kenwood

Kenwood TS-590SG Manual de usuario

Midland

Midland G8E-BT Manual

ComNav

ComNav Mariner X2 Manual de usuario