Product
Certifications:
Thermal Resources Management (TRM)
175 Idema Road, Markham,
ON, Canada, L3R 1A9
Tel: 1-905-940-4737
Fax: 1-905-940-4731
www.TRMheatingcables.com
Important notes:
1) All electrical wiring including GFCI (ground fault circuit interrupters) must be installed
in compliance with the National and Local Electrical Codes by qualified person(s)
2) Article 426 of ANSI/NFPA 70 of the National Electrical Code (NEC Section 62 of
CAN/CSA-C22.1, Canadian Electrical Code, Part 1 (CEC)) Governs the installation of
these heat tracing systems
3) TRM SR-ACC-SPL/TEE (Splice and Tee Kit) is suitable for use with TRMSR heating
Cables
4) Cables should be terminated into certified junction boxes that are appropriate for the
cable termination location
5) Use 30-mA ground fault protection on each heating cable circuit for maximum
protection
6) The black heating cable core is conductive and can short. It must be properly insulated
and kept dry
7) Keep ends of heating devices and kit components dry before and during installation
work
8) The conductive layer of this heating device must have a suitable grounding/earthing
terminal
9) Do not break braid or bus wire strands when scoring the jacket or conductive core.
Damaged bus wires can overheat or short out
10) Keep bus wires separated. Bus wires will short if they touch each other
11) Replace damaged components. Components damaged by heat can short.
12) Utilize a heat gun with a low heat flame, do not use a torch with a blue flame as that
would melt/compromise the heat shrink tubing. Charring or burning the heat shrink
tubing can produce fumes that may cause irritation to skin,, eyes, nose, and throat
13) Do not heat up components of this kit (except for the heat shrink tubes)
14) When installing this cable, only use fire-resistant insulation materials such as fiberglass
wrap
15) Do not twist the cable during installation
Assembly Tools Required:
Utility knife, scissors, side cutters, needle-nose pliers, linesman pliers, channel lock
pliers, crimping tool, flathead screwdriver, heat gun, measuring tape/ruler.
TRM SR-ACC-SPL/TEE
Self Regulating Cable Splice and Tee Kit
Installation Instruction Manual
