11 12
After installing the lock to the mounting surface, the battery and holder can be inserted
into the lock. The cover for the battery holder also serves to lock the holder into the lock
housing. The battery cover must be in the fully open position before inserting the holder.
The battery holder screw cannot be protruding from the bottom of the battery holder. It
must be flush with the holder so the holder can be inserted.
Check that the battery is properly inserted into the holder. The “+” surface of the
battery should be Inserted into the holder against the surface of the holder marked
with the “+” symbol. Insert the battery holder into the lock with the holder cover in the
fully open position and with the battery holder screw flush to the bottom of the holder
until the holder is fully seated. Next, use the hex tool to fasten the battery holder
screw into the lock body. Last, swing the battery holder cover to the closed position,
push in and fully seat the cover into the battery holder until it is flush to the lock body.
If the battery is inserted while the knob is locked, you should hear the lock mechanism
click and the unit will lock. If the battery is inserted while the knob is unlocked, after
turning the knob to the locked position you should hear the lock mechanism click and
the unit will lock. If the unit will not lock after inserting the battery, enter the factory
code, move the knob to the unlocked position, and move the knob to the locked
position and you should hear the lock mechanism click and the unit will lock. If the
unit still does not lock, replace the battery.
Battery
1 2
3 4
Battery
Holder
Battery
Cover
LIFT
UPWARD
SWING OVER
AND SNAP THE
COVER DOWN
Hex
Tool
Battery
Cover
Screw
Liability Limits:
Operating Temperature: 0 - +50 C
Storage temperature: -10 - +70 C
Operating Moisture: 20% - 80% Rh (without condensation)
Replacement Battery: 3 volt lithium CR2032
Battery Life: 5 years or more ( calculated at 20 uses per day )
This is a limited warranty and in lieu of all other warranties (including the
implied warranties of merchantability and fitness of use) and under no
circumstances shall TriTeq Lock & Security or Hudson Lock, LLC be liable for
any incidental or consequential damages or losses.
To clean the MicroIQ surface, apply a non-acid based cleaner to a clean cotton
cloth. Do not spray cleaner directly on the MicroIQ. Wipe down the keypad and
housing surface of excess cleaner.
TriTeq Limited Warranty:
TriTeq offers a one year limited warranty on all products to be free from
manufacturing defects in materials and workmanship. This limited
warranty does not cover battery, lost combinations or damages caused by
improper mounting, operation or unreasonable use.
Cleaning and Care:
ATTENTION:
Battery life may vary with battery brand and environmental conditions.
Mounting Template
3.150
.75
1.00
Measure before drilling.
If the length of the segment is dierent from 1.00"
the template dimensions will be scaled accordingly
1/8” diameter hole for metal
3/32” diameter hole for wood
