5. BUCKLE STRAPS: Remove the velcro binding on each of the EIGHT strapping bundles
on the top and bottom of the booth framework. The side of the booth that doesn’t
have straps is the DOOR side. The female ends of the buckles are on the straps at
the top of the booth, the adjustable male ends of the buckles are on the straps
attached to the bottom of the booth. *NOTE: THE STRAPS ARE ALREADY SET TO
THE APPROPRIATE TENSION. NO NEED TO LOOSEN AND RETIGHTEN UNLESS
YOU’VE ADDED THE HEIGHT EXTENSIONS! THE STRAPS ARE MEANT TO BE UNDER
TENSION SO YOU’LL NEED TO USE A LITTLE FORCE TO CONNECT THE BUCKLES.
Facing one of the sides with straps, buckle the upper-left female buckle to the
lower-right male buckle. Then attach the upper-right female buckle to the lower-left
male buckle. This forms an “X” with the straps. Repeat with the other side with straps.
Now that you’ve braced the booth, let’s set things up inside…!
6. ADJUST MIC & COPY HOLDER BOOMS: From top to bottom of the UTILITY POLE,
there is a microphone boom, a copy holder boom, and room to attach the utility
shelf/beverage holder. You can adjust the height of the booms by loosening the
smaller knob on the boom, raising or lowering the boom to the desired height, then
tightening the knob. To adjust the angle of the booms, loosen the large knob, swing
the boom into the position that best suits you, then tighten the knob. You will then
screw your mic mount (supplied by you) to the threaded end of the mic boom and
clip your microphone in place. Then screw the copy holder onto the copy holder
boom. You can adjust the black threaded collar on each boom to ensure the exact
rposition of the mount and the copy holder. (DO NOT OVER-TIGHTEN!)!
7. INSTALL UTILITY SHELF & POWER HUB: Retrieve the utility shelf and hook it around
the UTILITY POLE at your preferred height and tighten it until just secure (DO NOT
OVER-TIGHTEN!) You can place the POWER HUB on the shelf or anywhere you’d like.
There are Velcro dots are in the red EMERGENCY KIT if you’d like to use them to
secure the POWER HUB to any flat surface such as the utility shelf. You can now plug
all of your gear into the POWER HUB’s AC and USB outlets. Plug the POWER HUB
into a nearby outlet or use the supplied EXTENSION CORD to reach available
outlets. Now that you’ve powered up, let’s take care of the acoustics.!
8. INSTALL ACOUSTIC BLANKETS: There are three pieces of acoustic blanketing - two
identical blankets with hooks along the top edge called SKIRTS and one triangular
piece called the CAP. Pick up either one of the SKIRTS and starting at its top left
corner, hook the first hook to the left of the center coupling at the top of the door
side. Then continue moving to your right and attach the SKIRT’S hooks to the top
TRIANGLE until all hooks have been attached. Then pick up the second SKIRT and
