UNPACKING YOUR NEW MAGNETIC DRILL
Open shipping carton and remove the literature and
Read and Follow All Instructions
to operate your new Magnetic Drill.
Complete and mail the Product Registration Card
It is important that Trak-Star has a record of product
For the MD50 and MD70, open hardware package and
02635 Hex wrench for cutter installation
10565 1/8” Hex wrench for Gib Adjustment
04532 Feed handle knobs (3)
24166 7/32” T-Handle Hex Wrench
10565 1/8” Hex wrench for Gib Adjustment
04532 Feed handle knobs (3)
Using the handle of Magnetic Drill, lift unit out of the
Remove all packing and securing material from the
Screw the three Knobs into the three Feed Handles
and then screw Handles into the Hub Assembly.
Your Magnetic Drill was factory adjusted prior to
shipping. Check to make sure that all gib
adjustment screws, motor mount screws, front
support bracket screws, and magnet mounting
screws are snug and have not vibrated loose in
Your new Magnetic Drill comes complete with an
arbor mount. The MD40 will use the Trak-Star
RotaLoc Plus Cutters with the bayonet shank. The
MD50 & MD70 will use the Trak-Star annular cutter
with a 3/4” shank diameter.
Reread Safety Warnings listed in the Operator’s Manual
and on the drill unit to avoid injury. Follow operating
MAGNETIC DRILL SPECIFICATIONS
Cutter Type........................
Trak-Star Annular Cutters with
Hole Capacity....................7/16” to 1-1/2” (12mm-38mm)
Depth of Cut......................2” (50mm)
Motor.................................450 RPM, 8A (115v)
Net Weight.........................27.5 lbs. (12.5kg)
Cutter Type.......................
Trak-Star RotaLoc Plus Cutters with
Hole Capacity....................1/2” to 1-3/8” or 12mm to 35mm
Depth of Cut......................1” or 25mm
Motor.................................450 RPM, 8A, 120 volt
Net Weight.........................22.7 lbs. or 10.2 kg
Cutter Type........................
Trak-Star Annular Cutters with
Hole Capacity....................7/16” to 2-1/16” (12 mm - 52 mm)
Depth of Cut......................3” (76 mm)
Motor ...............................115v, 11.2 A, 350 RPM
Electrical System .............115v, 50/60 Hz, 12.2A, 1403 W
Net Weight........................ 42 lbs. (19.05 Kg)
Trak-Star Annular Cutters with
®
Trak-Star Annular Cutters with
Trak-Star RotaLoc Plus Cutters with
®
Trak-Star RotaLoc Plus Cutters with
Trak-Star Annular Cutters with
®
Trak-Star Annular Cutters with
