Tradedor Programming of Handsets & Accessories Guide, 2022/1
Pictures are for illustration purposes only, connector blocks are not provided and further ttings may be required.
7
Programming RD10GOK Wireless
Key Pad
Installation
Fit directly to the wall using the 2 fixings making sure it is level and square with the writing at the
bottom.
1 Press and hold the “RADIO PROG” button
(g.9A). You will hear a beep and the red LED
alongside “C1” (g.9B) will illuminate, then
release the “RADIO PROG” button.
2 Enter the access code and press OK (g.12B).
The panel will beep to conrm it has accepted
the unit.
3 Leave for several seconds and the receiver box
will beep twice to conrm end of programming.
Programming To Receiver Box
fig.12
Programming Codes
Master Code:
1 Press and hold the * button (g.12A). For 3
seconds until the LED issues a slow red
ashing light.
2 Enter the master code (factory issue 12345678)
and press OK (g.12B). The red LED will
ash faster.
3 Press the * button (g.12A) then enter the new
master code followed by the * button. The LED
will ash green.
4 Enter the new master code again followed by
the * button (g.12A). The LED will have
a permanent green light for 2 seconds then go
out. This means it has been programmed. If the
second entry doesn’t match the rst, the LED
will ash red and it has not been programmed.
1 Press and hold the * button (g.12A) for
3 seconds until the LED issues a slow red
ashing light.
2 Enter the master code and press OK
(g.12B). The red LED will ash faster.
3 Enter your new access code (1 to 8 numbers
long) followed by the channel number from
1 to 4 (e.g. 5555 is the number and 1 for the
channel so 55551) and press OK (g.12B).
4 The LED will have a permanent green light
for 2 seconds then go out. This means it has
been programmed. If you wish for more than 1
access code, then it must be programmed to a
separate channel otherwise it will just replace
the already stored code.
AB
Access Code:
