TP-Link TL-PA101 Manual de usuario
TL-PA101
85Mbps Powerline Ethernet Adapter
Rev: 1.0.0
1910010102
I
COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. is a registered trademark of
TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or
registered trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means or used to make any
derivative such as translation, transformation, or adaptation without permission from TP-LINK
TECHNOLOGIES CO., LTD. Copyright © 2008 TP-LINK TECHNOLOGIES CO., LTD. All rights
reserved.
http://www.tp-link.com
II
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures.
III
CONTENTS
Chapter 1 Introduction.................................................................................................................1
Chapter 2 Connecting Mechanism ...............................................................................2
2.1 Introduction .......................................................................................................................................... 2
2.2 LED Indicator....................................................................................................................................... 2
2.3 Physical Interface................................................................................................................................3
2.4 Hardware Connection – Computer .................................................................................................... 3
2.5 Hardware Connection – Internet ........................................................................................................ 4
Chapter 3 Installing Management Utility ......................................................................6
Chapter 4 Using The Management Utility ....................................................................9
4.1 Main...................................................................................................................................................... 9
4.1.1 Rename .................................................................................................................................10
4.1.2 Enter Password......................................................................................................................10
4.1.3 Add Device.............................................................................................................................11
4.2 Privacy ............................................................................................................................................... 12
4.3 Diagnostics ........................................................................................................................................ 13
4.4 About .................................................................................................................................................. 15
Appendix A: Troubleshooting Guide ..............................................................................16
TL-PA101 85Mbps Ethernet Powerline Adapter
1
Chapter 1 Introduction
Congratulations on your purchase of this outstanding Ethernet Powerline Adapter. This device is an
85Mbps Powerline Ethernet Adapter which transforms your house’s existing electrical wiring into an
ubiquitous networking infrastructure. Simply plug this 85Mbps Ethernet Powerline Adapter into an
ordinary AC power outlet which will easily extend your Cable/xDSL broadband connection or existing
Ethernet (LAN) network to any other electrical outlet in any room of a house without the need of any new
cabling.
This Ethernet Powerline Adapter supports up to 85Mbps data rate over the existing household power
circuit. With data rates of 85Mbps, full multimedia application can easily be supported throughout the
whole house in addition to Internet access. This Ethernet Powerline Adapter uses the existing power
lines installed in a home as a path to transmit digital data, voice, audio and video between devices.
To ensure data communication’s security and multimedia applications, this Ethernet Powerline Adapter
support built-in 56-bit DES encryption and Quality of Service features.With minimum setup, you can
install and use this Ethernet Powerline Adapter within minutes.
A. System Requirement
a) At least two AC 100V ~ 240V power outlets with standard home power wiring
b) A computer with the following:
¾Operating System with TCP/IP installed
¾Pentium III compatible processor and above
¾Ethernet LAN card installed with TCP/IP protocol
¾64 MB RAM or more
¾50 MB of free disk space (Minimum)
¾CD-ROM Drive
B. Package Contents
The 85Mbps Ethernet Powerline Adapter package contains the following items:
¾One 85Mbps Ethernet Powerline Adapter
¾One Quick Installation Guide
¾One CAT-5 Ethernet Cable
¾One CD-ROM (Utility / Manual / Quick Installation Guide)
If any of the above items are damaged or missing, please contact your dealer immediately.
TL-PA101 85Mbps Ethernet Powerline Adapter
2
Chapter 2 Connecting Mechanism
2.1 Introduction
The Ethernet Powerline Adapter support up to 85Mbps data rate. With this high speed connection rate,
this Ethernet Powerline Adapter allows you to setup a high speed home network by using your home
existing electrical wiring. Simply plug this Ethernet Powerline Adapter into an ordinary power outlet to
extend your Cable/xDSL broadband connection or existing LAN network to any other electrical outlet in
any rooms of your house.
Take notes that this Ethernet Powerline Adapter works in pairs. You need to plug one Ethernet
Powerline Adapter into a power outlet for each computer (Connect to the computer LAN card) you want
to connect (Network access); you will also need another Ethernet Powerline Adapter connected to your
Cable/xDSL broadband (Ethernet port) in order to extend your broadband connection or Internet surfing.
Section below describes the Ethernet Powerline Adapter’s LED indicators, physical interface and
hardware connection mechanism.
2.2 LED Indicator
The LED indicator displays information about the device’s status.
TL-PA101 85Mbps Ethernet Powerline Adapter
3
Label Status Description
ON The Ethernet Powerline Adapter is power on
Power
OFF The Ethernet Powerline Adapter is not receiving power
ON Another Powerline port is detected on the same Powerline network
OFF Did not detect any other Powerline port on the same powerline network
Powerline
Flashing The Powerline port is transmitting/receiving data
ON The Ethernet port is on and ready to receiving/transmitting data
OFF The Ethernet port is not connected or not power on
Ethernet
Flashing The Ethernet port is receiving/transmitting data
2.3 Physical Interface
There are two physical interfaces on this Ethernet Powerline Adapter.
Interface Description
Ethernet One 10/100Mbps Ethernet port connected to PC LAN card or broadband
device.
Power Plug Power Plug connected to any 100V ~ 240V AC power socket.
2.4 Hardware Connection – Computer
For those computers you wish to be networked by Ethernet Powerline Adapter, each of the computers
must be properly connected with an Ethernet Powerline Adapter through an Ethernet (RJ-45) cable.
Following are the steps to properly connect the Ethernet Powerline Adapter to your computer:
1. Power off your PC or Notebook.
2. Connect the provided Ethernet (RJ-45) cable to the Ethernet Powerline Adapter’s Ethernet port.
TL-PA101 85Mbps Ethernet Powerline Adapter
4
3. Connect the other end of the Ethernet (RJ-45) cable to you computer’s LAN port.
4. Plug the Ethernet Powerline Adapter into a wall socket next to the computer.
5. Turn on your computer.
6. Check and confirm that the Power and Ethernet LEDs on the Ethernet Powerline Adapter are ON
The hardware connection mechanism is shown below:
2.5 Hardware Connection – Internet
This section describes how to connect the Ethernet Powerline Adapter into your existing ADSL
broadband connection via ADSL Ethernet port. Follow the procedures describe below to connect the
Ethernet Powerline Adapter to your ADSL broadband connection:
1. Power off your PC or Notebook.
2. Connect the provided Ethernet (RJ-45) cable to the Ethernet Powerline Adapter’s Ethernet port.
3. Connect the other end of the Ethernet (RJ-45) cable to an available Ethernet port of your ADSL
broadband Router.
4. Plug the Ethernet Powerline Adapter into a wall socket next to the computer.
5. Turn on your computer.
6. Check and confirm that the Power, Powerline and Ethernet LEDs on the Ethernet Powerline
Adapter are ON.
The hardware connection mechanism is shown below:
TL-PA101 85Mbps Ethernet Powerline Adapter
5
TL-PA101 85Mbps Ethernet Powerline Adapter
6
Chapter 3 Installing Management Utility
Please verify that no other Ethernet Powerline Adapter or any Encryption Management Utilities are
installed before installing the provided software. If other Homeplug Utilities are installed, uninstall them
and restart your personal computer before installing this provided software.
Follow the following procedures to properly installing the provided Management Utility:
Step 1: The program installation process will carry out and copy all the necessary files to your system.
Otros manuales para TL-PA101
2
Tabla de contenidos
Otros manuales de Adaptador de TP-Link
TP-Link
TP-Link TL-PA4010 Manual de usuario
TP-Link
TP-Link UE300C Manual de usuario
TP-Link
TP-Link TL-WA890EA Manual de usuario
TP-Link
TP-Link UE330 Manual de usuario
TP-Link
TP-Link TL-PA7020P Manual de usuario
TP-Link
TP-Link TL-WN321G Manual de usuario
TP-Link
TP-Link TL-WN951N - IEEE 802.11b/g 802.11n Draft 2.0 PCI Wireless... Manual de usuario
TP-Link
TP-Link TL-WN821N Manual de usuario
TP-Link
TP-Link TL-PA8010P Manual de usuario
TP-Link
TP-Link TL-PA4010 Manual de usuario
TP-Link
TP-Link TL-WN321G Manual de usuario
TP-Link
TP-Link TL-WN7200ND Manual de usuario
TP-Link
TP-Link TL-WN781ND Manual de usuario
TP-Link
TP-Link TL-PA9020 Manual de usuario
TP-Link
TP-Link TL-PA4010P KIT EU Manual de usuario
TP-Link
TP-Link TL-PA9020 Manual de usuario
TP-Link
TP-Link TL-PA7010 Manual de usuario
TP-Link
TP-Link TL-WN722N Manual de usuario
TP-Link
TP-Link TL-WN951N - IEEE 802.11b/g 802.11n Draft 2.0 PCI Wireless... Manual de usuario
TP-Link
TP-Link TL-UE300 Manual de usuario
